diff options
Diffstat (limited to 'Documentation/networking')
| -rw-r--r-- | Documentation/networking/ifenslave.c | 2 | ||||
| -rw-r--r-- | Documentation/networking/ip-sysctl.txt | 2 | ||||
| -rw-r--r-- | Documentation/networking/netlink_mmap.txt | 14 |
3 files changed, 9 insertions, 9 deletions
diff --git a/Documentation/networking/ifenslave.c b/Documentation/networking/ifenslave.c index ac5debb2f16..9f6a8fff9a7 100644 --- a/Documentation/networking/ifenslave.c +++ b/Documentation/networking/ifenslave.c @@ -501,7 +501,7 @@ out: static short mif_flags; -/* Get the inteface configuration from the kernel. */ +/* Get the interface configuration from the kernel. */ static int if_getconfig(char *ifname) { struct ifreq ifr; diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt index f98ca633b52..398d0fb1dd0 100644 --- a/Documentation/networking/ip-sysctl.txt +++ b/Documentation/networking/ip-sysctl.txt @@ -183,7 +183,7 @@ tcp_early_retrans - INTEGER for triggering fast retransmit when the amount of outstanding data is small and when no previously unsent data can be transmitted (such that limited transmit could be used). Also controls the use of - Tail loss probe (TLP) that converts RTOs occuring due to tail + Tail loss probe (TLP) that converts RTOs occurring due to tail losses into fast recovery (draft-dukkipati-tcpm-tcp-loss-probe-01). Possible values: 0 disables ER diff --git a/Documentation/networking/netlink_mmap.txt b/Documentation/networking/netlink_mmap.txt index 1c2dab40962..e6088baf109 100644 --- a/Documentation/networking/netlink_mmap.txt +++ b/Documentation/networking/netlink_mmap.txt @@ -54,7 +54,7 @@ it will use an allocated socket buffer as usual and the contents will be copied to the ring on transmission, nullifying most of the performance gains. Dumps of kernel databases automatically support memory mapped I/O. -Conversion of the transmit path involves changing message contruction to +Conversion of the transmit path involves changing message construction to use memory from the TX ring instead of (usually) a buffer declared on the stack and setting up the frame header approriately. Optionally poll() can be used to wait for free frames in the TX ring. @@ -65,8 +65,8 @@ Structured and definitions for using memory mapped I/O are contained in RX and TX rings ---------------- -Each ring contains a number of continous memory blocks, containing frames of -fixed size dependant on the parameters used for ring setup. +Each ring contains a number of continuous memory blocks, containing frames of +fixed size dependent on the parameters used for ring setup. Ring: [ block 0 ] [ frame 0 ] @@ -80,7 +80,7 @@ Ring: [ block 0 ] [ frame 2 * n + 1 ] The blocks are only visible to the kernel, from the point of view of user-space -the ring just contains the frames in a continous memory zone. +the ring just contains the frames in a continuous memory zone. The ring parameters used for setting up the ring are defined as follows: @@ -91,7 +91,7 @@ struct nl_mmap_req { unsigned int nm_frame_nr; }; -Frames are grouped into blocks, where each block is a continous region of memory +Frames are grouped into blocks, where each block is a continuous region of memory and holds nm_block_size / nm_frame_size frames. The total number of frames in the ring is nm_frame_nr. The following invariants hold: @@ -113,8 +113,8 @@ Some parameters are constrained, specifically: - nm_frame_nr must equal the actual number of frames as specified above. -When the kernel can't allocate phsyically continous memory for a ring block, -it will fall back to use physically discontinous memory. This might affect +When the kernel can't allocate phsyically continuous memory for a ring block, +it will fall back to use physically discontinuous memory. This might affect performance negatively, in order to avoid this the nm_frame_size parameter should be chosen to be as small as possible for the required frame size and the number of blocks should be increased instead. |