diff options
Diffstat (limited to 'Documentation/sound/alsa')
| -rw-r--r-- | Documentation/sound/alsa/ALSA-Configuration.txt | 10 | ||||
| -rw-r--r-- | Documentation/sound/alsa/HD-Audio-Models.txt | 79 | ||||
| -rw-r--r-- | Documentation/sound/alsa/HD-Audio.txt | 7 |
3 files changed, 16 insertions, 80 deletions
diff --git a/Documentation/sound/alsa/ALSA-Configuration.txt b/Documentation/sound/alsa/ALSA-Configuration.txt index 936699e4f04..6f75ba3b8a3 100644 --- a/Documentation/sound/alsa/ALSA-Configuration.txt +++ b/Documentation/sound/alsa/ALSA-Configuration.txt @@ -860,7 +860,8 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed. [Multiple options for each card instance] model - force the model name - position_fix - Fix DMA pointer (0 = auto, 1 = use LPIB, 2 = POSBUF) + position_fix - Fix DMA pointer (0 = auto, 1 = use LPIB, 2 = POSBUF, + 3 = VIACOMBO, 4 = COMBO) probe_mask - Bitmask to probe codecs (default = -1, meaning all slots) When the bit 8 (0x100) is set, the lower 8 bits are used as the "fixed" codec slots; i.e. the driver probes the @@ -925,6 +926,11 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed. (Usually SD_LPIB register is more accurate than the position buffer.) + position_fix=3 is specific to VIA devices. The position + of the capture stream is checked from both LPIB and POSBUF + values. position_fix=4 is a combination mode, using LPIB + for playback and POSBUF for capture. + NB: If you get many "azx_get_response timeout" messages at loading, it's likely a problem of interrupts (e.g. ACPI irq routing). Try to boot with options like "pci=noacpi". Also, you @@ -1588,7 +1594,7 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed. Module supports autoprobe a chip. - Note: the driver may have problems regarding endianess. + Note: the driver may have problems regarding endianness. The power-management is supported. diff --git a/Documentation/sound/alsa/HD-Audio-Models.txt b/Documentation/sound/alsa/HD-Audio-Models.txt index c8c54544abc..d97d992ced1 100644 --- a/Documentation/sound/alsa/HD-Audio-Models.txt +++ b/Documentation/sound/alsa/HD-Audio-Models.txt @@ -8,37 +8,10 @@ ALC880 5stack-digout 5-jack in back, 2-jack in front, a SPDIF out 6stack 6-jack in back, 2-jack in front 6stack-digout 6-jack with a SPDIF out - w810 3-jack - z71v 3-jack (HP shared SPDIF) - asus 3-jack (ASUS Mobo) - asus-w1v ASUS W1V - asus-dig ASUS with SPDIF out - asus-dig2 ASUS with SPDIF out (using GPIO2) - uniwill 3-jack - fujitsu Fujitsu Laptops (Pi1536) - F1734 2-jack - lg LG laptop (m1 express dual) - lg-lw LG LW20/LW25 laptop - tcl TCL S700 - clevo Clevo laptops (m520G, m665n) - medion Medion Rim 2150 - test for testing/debugging purpose, almost all controls can be - adjusted. Appearing only when compiled with - $CONFIG_SND_DEBUG=y - auto auto-config reading BIOS (default) ALC260 ====== - fujitsu Fujitsu S7020 - acer Acer TravelMate - will Will laptops (PB V7900) - replacer Replacer 672V - favorit100 Maxdata Favorit 100XS - basic fixed pin assignment (old default model) - test for testing/debugging purpose, almost all controls can - adjusted. Appearing only when compiled with - $CONFIG_SND_DEBUG=y - auto auto-config reading BIOS (default) + N/A ALC262 ====== @@ -70,55 +43,7 @@ ALC680 ALC882/883/885/888/889 ====================== - 3stack-dig 3-jack with SPDIF I/O - 6stack-dig 6-jack digital with SPDIF I/O - arima Arima W820Di1 - targa Targa T8, MSI-1049 T8 - asus-a7j ASUS A7J - asus-a7m ASUS A7M - macpro MacPro support - mb5 Macbook 5,1 - macmini3 Macmini 3,1 - mba21 Macbook Air 2,1 - mbp3 Macbook Pro rev3 - imac24 iMac 24'' with jack detection - imac91 iMac 9,1 - w2jc ASUS W2JC - 3stack-2ch-dig 3-jack with SPDIF I/O (ALC883) - alc883-6stack-dig 6-jack digital with SPDIF I/O (ALC883) - 3stack-6ch 3-jack 6-channel - 3stack-6ch-dig 3-jack 6-channel with SPDIF I/O - 6stack-dig-demo 6-jack digital for Intel demo board - acer Acer laptops (Travelmate 3012WTMi, Aspire 5600, etc) - acer-aspire Acer Aspire 9810 - acer-aspire-4930g Acer Aspire 4930G - acer-aspire-6530g Acer Aspire 6530G - acer-aspire-7730g Acer Aspire 7730G - acer-aspire-8930g Acer Aspire 8930G - medion Medion Laptops - targa-dig Targa/MSI - targa-2ch-dig Targa/MSI with 2-channel - targa-8ch-dig Targa/MSI with 8-channel (MSI GX620) - laptop-eapd 3-jack with SPDIF I/O and EAPD (Clevo M540JE, M550JE) - lenovo-101e Lenovo 101E - lenovo-nb0763 Lenovo NB0763 - lenovo-ms7195-dig Lenovo MS7195 - lenovo-sky Lenovo Sky - haier-w66 Haier W66 - 3stack-hp HP machines with 3stack (Lucknow, Samba boards) - 6stack-dell Dell machines with 6stack (Inspiron 530) - mitac Mitac 8252D - clevo-m540r Clevo M540R (6ch + digital) - clevo-m720 Clevo M720 laptop series - fujitsu-pi2515 Fujitsu AMILO Pi2515 - fujitsu-xa3530 Fujitsu AMILO XA3530 - 3stack-6ch-intel Intel DG33* boards - intel-alc889a Intel IbexPeak with ALC889A - intel-x58 Intel DX58 with ALC889 - asus-p5q ASUS P5Q-EM boards - mb31 MacBook 3,1 - sony-vaio-tt Sony VAIO TT - auto auto-config reading BIOS (default) + N/A ALC861/660 ========== diff --git a/Documentation/sound/alsa/HD-Audio.txt b/Documentation/sound/alsa/HD-Audio.txt index 91fee3b45fb..7813c06a5c7 100644 --- a/Documentation/sound/alsa/HD-Audio.txt +++ b/Documentation/sound/alsa/HD-Audio.txt @@ -59,7 +59,12 @@ a case, you can change the default method via `position_fix` option. `position_fix=1` means to use LPIB method explicitly. `position_fix=2` means to use the position-buffer. `position_fix=3` means to use a combination of both methods, needed -for some VIA and ATI controllers. 0 is the default value for all other +for some VIA controllers. The capture stream position is corrected +by comparing both LPIB and position-buffer values. +`position_fix=4` is another combination available for all controllers, +and uses LPIB for the playback and the position-buffer for the capture +streams. +0 is the default value for all other controllers, the automatic check and fallback to LPIB as described in the above. If you get a problem of repeated sounds, this option might help. |