diff options
Diffstat (limited to 'Documentation')
| -rw-r--r-- | Documentation/kdump/kdump.txt | 36 |
1 files changed, 29 insertions, 7 deletions
diff --git a/Documentation/kdump/kdump.txt b/Documentation/kdump/kdump.txt index 2e5b3176de1..07330681834 100644 --- a/Documentation/kdump/kdump.txt +++ b/Documentation/kdump/kdump.txt @@ -17,7 +17,7 @@ You can use common Linux commands, such as cp and scp, to copy the memory image to a dump file on the local disk, or across the network to a remote system. -Kdump and kexec are currently supported on the x86, x86_64, ppc64 and IA64 +Kdump and kexec are currently supported on the x86, x86_64, ppc64 and ia64 architectures. When the system kernel boots, it reserves a small section of memory for @@ -229,7 +229,23 @@ Dump-capture kernel config options (Arch Dependent, ppc64) Dump-capture kernel config options (Arch Dependent, ia64) ---------------------------------------------------------- -(To be filled) + +- No specific options are required to create a dump-capture kernel + for ia64, other than those specified in the arch idependent section + above. This means that it is possible to use the system kernel + as a dump-capture kernel if desired. + + The crashkernel region can be automatically placed by the system + kernel at run time. This is done by specifying the base address as 0, + or omitting it all together. + + crashkernel=256M@0 + or + crashkernel=256M + + If the start address is specified, note that the start address of the + kernel will be aligned to 64Mb, so if the start address is not then + any space below the alignment point will be wasted. Boot into System Kernel @@ -248,6 +264,10 @@ Boot into System Kernel On ppc64, use "crashkernel=128M@32M". + On ia64, 256M@256M is a generous value that typically works. + The region may be automatically placed on ia64, see the + dump-capture kernel config option notes above. + Load the Dump-capture Kernel ============================ @@ -266,7 +286,8 @@ For x86_64: For ppc64: - Use vmlinux For ia64: - (To be filled) + - Use vmlinux or vmlinuz.gz + If you are using a uncompressed vmlinux image then use following command to load dump-capture kernel. @@ -282,18 +303,19 @@ to load dump-capture kernel. --initrd=<initrd-for-dump-capture-kernel> \ --append="root=<root-dev> <arch-specific-options>" +Please note, that --args-linux does not need to be specified for ia64. +It is planned to make this a no-op on that architecture, but for now +it should be omitted + Following are the arch specific command line options to be used while loading dump-capture kernel. -For i386 and x86_64: +For i386, x86_64 and ia64: "init 1 irqpoll maxcpus=1" For ppc64: "init 1 maxcpus=1 noirqdistrib" -For IA64 - (To be filled) - Notes on loading the dump-capture kernel: |