diff options
Diffstat (limited to 'Documentation')
-rw-r--r-- | Documentation/dmatest.txt | 6 | ||||
-rw-r--r-- | Documentation/filesystems/xfs.txt | 3 |
2 files changed, 6 insertions, 3 deletions
diff --git a/Documentation/dmatest.txt b/Documentation/dmatest.txt index 279ac0a8c5b..132a094c7bc 100644 --- a/Documentation/dmatest.txt +++ b/Documentation/dmatest.txt @@ -34,7 +34,7 @@ command: After a while you will start to get messages about current status or error like in the original code. -Note that running a new test will stop any in progress test. +Note that running a new test will not stop any in progress test. The following command should return actual state of the test. % cat /sys/kernel/debug/dmatest/run @@ -52,8 +52,8 @@ To wait for test done the user may perform a busy loop that checks the state. The module parameters that is supplied to the kernel command line will be used for the first performed test. After user gets a control, the test could be -interrupted or re-run with same or different parameters. For the details see -the above section "Part 2 - When dmatest is built as a module..." +re-run with the same or different parameters. For the details see the above +section "Part 2 - When dmatest is built as a module..." In both cases the module parameters are used as initial values for the test case. You always could check them at run-time by running diff --git a/Documentation/filesystems/xfs.txt b/Documentation/filesystems/xfs.txt index 3e4b3dd1e04..83577f0232a 100644 --- a/Documentation/filesystems/xfs.txt +++ b/Documentation/filesystems/xfs.txt @@ -33,6 +33,9 @@ When mounting an XFS filesystem, the following options are accepted. removing extended attributes) the on-disk superblock feature bit field will be updated to reflect this format being in use. + CRC enabled filesystems always use the attr2 format, and so + will reject the noattr2 mount option if it is set. + barrier Enables the use of block layer write barriers for writes into the journal and unwritten extent conversion. This allows for |