diff options
Diffstat (limited to 'Documentation')
| -rw-r--r-- | Documentation/DocBook/uio-howto.tmpl | 40 |
1 files changed, 39 insertions, 1 deletions
diff --git a/Documentation/DocBook/uio-howto.tmpl b/Documentation/DocBook/uio-howto.tmpl index fdd7f4f887b..c4d18731396 100644 --- a/Documentation/DocBook/uio-howto.tmpl +++ b/Documentation/DocBook/uio-howto.tmpl @@ -30,6 +30,12 @@ <revhistory> <revision> + <revnumber>0.5</revnumber> + <date>2008-05-22</date> + <authorinitials>hjk</authorinitials> + <revremark>Added description of write() function.</revremark> + </revision> + <revision> <revnumber>0.4</revnumber> <date>2007-11-26</date> <authorinitials>hjk</authorinitials> @@ -64,7 +70,7 @@ <?dbhtml filename="copyright.html"?> <title>Copyright and License</title> <para> - Copyright (c) 2006 by Hans-Jürgen Koch.</para> + Copyright (c) 2006-2008 by Hans-Jürgen Koch.</para> <para> This documentation is Free Software licensed under the terms of the GPL version 2. @@ -189,6 +195,30 @@ interested in translating it, please email me represents the total interrupt count. You can use this number to figure out if you missed some interrupts. </para> + <para> + For some hardware that has more than one interrupt source internally, + but not separate IRQ mask and status registers, there might be + situations where userspace cannot determine what the interrupt source + was if the kernel handler disables them by writing to the chip's IRQ + register. In such a case, the kernel has to disable the IRQ completely + to leave the chip's register untouched. Now the userspace part can + determine the cause of the interrupt, but it cannot re-enable + interrupts. Another cornercase is chips where re-enabling interrupts + is a read-modify-write operation to a combined IRQ status/acknowledge + register. This would be racy if a new interrupt occurred + simultaneously. + </para> + <para> + To address these problems, UIO also implements a write() function. It + is normally not used and can be ignored for hardware that has only a + single interrupt source or has separate IRQ mask and status registers. + If you need it, however, a write to <filename>/dev/uioX</filename> + will call the <function>irqcontrol()</function> function implemented + by the driver. You have to write a 32-bit value that is usually either + 0 or 1 to disable or enable interrupts. If a driver does not implement + <function>irqcontrol()</function>, <function>write()</function> will + return with <varname>-ENOSYS</varname>. + </para> <para> To handle interrupts properly, your custom kernel module can @@ -362,6 +392,14 @@ device is actually used. <function>open()</function>, you will probably also want a custom <function>release()</function> function. </para></listitem> + +<listitem><para> +<varname>int (*irqcontrol)(struct uio_info *info, s32 irq_on) +</varname>: Optional. If you need to be able to enable or disable +interrupts from userspace by writing to <filename>/dev/uioX</filename>, +you can implement this function. The parameter <varname>irq_on</varname> +will be 0 to disable interrupts and 1 to enable them. +</para></listitem> </itemizedlist> <para> |