diff options
Diffstat (limited to 'arch/arm/boot/dts/armada-xp-gp.dts')
| -rw-r--r-- | arch/arm/boot/dts/armada-xp-gp.dts | 222 |
1 files changed, 113 insertions, 109 deletions
diff --git a/arch/arm/boot/dts/armada-xp-gp.dts b/arch/arm/boot/dts/armada-xp-gp.dts index 04f28a712b9..26ad06fc147 100644 --- a/arch/arm/boot/dts/armada-xp-gp.dts +++ b/arch/arm/boot/dts/armada-xp-gp.dts @@ -26,137 +26,141 @@ memory { device_type = "memory"; - /* - * 4 GB of plug-in RAM modules by default but only 3GB - * are visible, the amount of memory available can be - * changed by the bootloader according the size of the - * module actually plugged + * 8 GB of plug-in RAM modules by default.The amount + * of memory available can be changed by the + * bootloader according the size of the module + * actually plugged. Only 7GB are usable because + * addresses from 0xC0000000 to 0xffffffff are used by + * the internal registers of the SoC. */ - reg = <0x00000000 0xC0000000>; + reg = <0x00000000 0x00000000 0x00000000 0xC0000000>, + <0x00000001 0x00000000 0x00000001 0x00000000>; }; soc { - serial@d0012000 { - clock-frequency = <250000000>; - status = "okay"; - }; - serial@d0012100 { - clock-frequency = <250000000>; - status = "okay"; - }; - serial@d0012200 { - clock-frequency = <250000000>; - status = "okay"; - }; - serial@d0012300 { - clock-frequency = <250000000>; - status = "okay"; - }; - - sata@d00a0000 { - nr-ports = <2>; - status = "okay"; - }; - - mdio { - phy0: ethernet-phy@0 { - reg = <16>; + internal-regs { + serial@12000 { + clock-frequency = <250000000>; + status = "okay"; }; - - phy1: ethernet-phy@1 { - reg = <17>; + serial@12100 { + clock-frequency = <250000000>; + status = "okay"; }; - - phy2: ethernet-phy@2 { - reg = <18>; + serial@12200 { + clock-frequency = <250000000>; + status = "okay"; + }; + serial@12300 { + clock-frequency = <250000000>; + status = "okay"; }; - phy3: ethernet-phy@3 { - reg = <19>; + sata@a0000 { + nr-ports = <2>; + status = "okay"; }; - }; - ethernet@d0070000 { - status = "okay"; - phy = <&phy0>; - phy-mode = "rgmii-id"; - }; - ethernet@d0074000 { - status = "okay"; - phy = <&phy1>; - phy-mode = "rgmii-id"; - }; - ethernet@d0030000 { - status = "okay"; - phy = <&phy2>; - phy-mode = "rgmii-id"; - }; - ethernet@d0034000 { - status = "okay"; - phy = <&phy3>; - phy-mode = "rgmii-id"; - }; + mdio { + phy0: ethernet-phy@0 { + reg = <16>; + }; - spi0: spi@d0010600 { - status = "okay"; + phy1: ethernet-phy@1 { + reg = <17>; + }; - spi-flash@0 { - #address-cells = <1>; - #size-cells = <1>; - compatible = "n25q128a13"; - reg = <0>; /* Chip select 0 */ - spi-max-frequency = <108000000>; - }; - }; + phy2: ethernet-phy@2 { + reg = <18>; + }; - devbus-bootcs@d0010400 { - status = "okay"; - ranges = <0 0xf0000000 0x1000000>; /* @addr 0xf000000, size 0x1000000 */ - - /* Device Bus parameters are required */ - - /* Read parameters */ - devbus,bus-width = <8>; - devbus,turn-off-ps = <60000>; - devbus,badr-skew-ps = <0>; - devbus,acc-first-ps = <124000>; - devbus,acc-next-ps = <248000>; - devbus,rd-setup-ps = <0>; - devbus,rd-hold-ps = <0>; - - /* Write parameters */ - devbus,sync-enable = <0>; - devbus,wr-high-ps = <60000>; - devbus,wr-low-ps = <60000>; - devbus,ale-wr-ps = <60000>; - - /* NOR 16 MiB */ - nor@0 { - compatible = "cfi-flash"; - reg = <0 0x1000000>; - bank-width = <2>; + phy3: ethernet-phy@3 { + reg = <19>; + }; }; - }; - pcie-controller { - status = "okay"; + ethernet@70000 { + status = "okay"; + phy = <&phy0>; + phy-mode = "rgmii-id"; + }; + ethernet@74000 { + status = "okay"; + phy = <&phy1>; + phy-mode = "rgmii-id"; + }; + ethernet@30000 { + status = "okay"; + phy = <&phy2>; + phy-mode = "rgmii-id"; + }; + ethernet@34000 { + status = "okay"; + phy = <&phy3>; + phy-mode = "rgmii-id"; + }; - /* - * The 3 slots are physically present as - * standard PCIe slots on the board. - */ - pcie@1,0 { - /* Port 0, Lane 0 */ + spi0: spi@10600 { status = "okay"; + + spi-flash@0 { + #address-cells = <1>; + #size-cells = <1>; + compatible = "n25q128a13"; + reg = <0>; /* Chip select 0 */ + spi-max-frequency = <108000000>; + }; }; - pcie@9,0 { - /* Port 2, Lane 0 */ + + devbus-bootcs@10400 { status = "okay"; + ranges = <0 0xf0000000 0x1000000>; /* @addr 0xf000000, size 0x1000000 */ + + /* Device Bus parameters are required */ + + /* Read parameters */ + devbus,bus-width = <8>; + devbus,turn-off-ps = <60000>; + devbus,badr-skew-ps = <0>; + devbus,acc-first-ps = <124000>; + devbus,acc-next-ps = <248000>; + devbus,rd-setup-ps = <0>; + devbus,rd-hold-ps = <0>; + + /* Write parameters */ + devbus,sync-enable = <0>; + devbus,wr-high-ps = <60000>; + devbus,wr-low-ps = <60000>; + devbus,ale-wr-ps = <60000>; + + /* NOR 16 MiB */ + nor@0 { + compatible = "cfi-flash"; + reg = <0 0x1000000>; + bank-width = <2>; + }; }; - pcie@10,0 { - /* Port 3, Lane 0 */ + + pcie-controller { status = "okay"; + + /* + * The 3 slots are physically present as + * standard PCIe slots on the board. + */ + pcie@1,0 { + /* Port 0, Lane 0 */ + status = "okay"; + }; + pcie@9,0 { + /* Port 2, Lane 0 */ + status = "okay"; + }; + pcie@10,0 { + /* Port 3, Lane 0 */ + status = "okay"; + }; }; }; }; |