diff options
Diffstat (limited to 'arch/arm/mach-at91/board-sam9g20ek.c')
| -rw-r--r-- | arch/arm/mach-at91/board-sam9g20ek.c | 17 |
1 files changed, 7 insertions, 10 deletions
diff --git a/arch/arm/mach-at91/board-sam9g20ek.c b/arch/arm/mach-at91/board-sam9g20ek.c index ca8198b3c16..7624cf0d006 100644 --- a/arch/arm/mach-at91/board-sam9g20ek.c +++ b/arch/arm/mach-at91/board-sam9g20ek.c @@ -43,6 +43,7 @@ #include <mach/board.h> #include <mach/gpio.h> #include <mach/at91sam9_smc.h> +#include <mach/system_rev.h> #include "sam9_smc.h" #include "generic.h" @@ -60,7 +61,7 @@ static int inline ek_have_2mmc(void) } -static void __init ek_map_io(void) +static void __init ek_init_early(void) { /* Initialize processor: 18.432 MHz crystal */ at91sam9260_initialize(18432000); @@ -175,11 +176,6 @@ static struct atmel_nand_data __initdata ek_nand_data = { .rdy_pin = AT91_PIN_PC13, .enable_pin = AT91_PIN_PC14, .partition_info = nand_partitions, -#if defined(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16) - .bus_width_16 = 1, -#else - .bus_width_16 = 0, -#endif }; static struct sam9_smc_config __initdata ek_nand_smc_config = { @@ -202,6 +198,7 @@ static struct sam9_smc_config __initdata ek_nand_smc_config = { static void __init ek_add_device_nand(void) { + ek_nand_data.bus_width_16 = !board_have_nand_8bit(); /* setup bus-width (8 or 16) */ if (ek_nand_data.bus_width_16) ek_nand_smc_config.mode |= AT91_SMC_DBW_16; @@ -406,18 +403,18 @@ static void __init ek_board_init(void) MACHINE_START(AT91SAM9G20EK, "Atmel AT91SAM9G20-EK") /* Maintainer: Atmel */ - .boot_params = AT91_SDRAM_BASE + 0x100, .timer = &at91sam926x_timer, - .map_io = ek_map_io, + .map_io = at91sam9260_map_io, + .init_early = ek_init_early, .init_irq = ek_init_irq, .init_machine = ek_board_init, MACHINE_END MACHINE_START(AT91SAM9G20EK_2MMC, "Atmel AT91SAM9G20-EK 2 MMC Slot Mod") /* Maintainer: Atmel */ - .boot_params = AT91_SDRAM_BASE + 0x100, .timer = &at91sam926x_timer, - .map_io = ek_map_io, + .map_io = at91sam9260_map_io, + .init_early = ek_init_early, .init_irq = ek_init_irq, .init_machine = ek_board_init, MACHINE_END |