diff options
Diffstat (limited to 'arch/arm/mach-msm/proc_comm.h')
| -rw-r--r-- | arch/arm/mach-msm/proc_comm.h | 105 |
1 files changed, 99 insertions, 6 deletions
diff --git a/arch/arm/mach-msm/proc_comm.h b/arch/arm/mach-msm/proc_comm.h index 834760f2569..12da4cacd4a 100644 --- a/arch/arm/mach-msm/proc_comm.h +++ b/arch/arm/mach-msm/proc_comm.h @@ -16,6 +16,8 @@ #ifndef _ARCH_ARM_MACH_MSM_PROC_COMM_H_ #define _ARCH_ARM_MACH_MSM_PROC_COMM_H_ +#include <linux/init.h> + enum { PCOM_CMD_IDLE = 0x0, PCOM_CMD_DONE, @@ -62,19 +64,104 @@ enum { PCOM_RESET_CHIP_IMM, PCOM_PM_VID_EN, PCOM_VREG_PULLDOWN, + PCOM_GET_MODEM_VERSION, + PCOM_CLK_REGIME_SEC_RESET, + PCOM_CLK_REGIME_SEC_RESET_ASSERT, + PCOM_CLK_REGIME_SEC_RESET_DEASSERT, + PCOM_CLK_REGIME_SEC_PLL_REQUEST_WRP, + PCOM_CLK_REGIME_SEC_ENABLE, + PCOM_CLK_REGIME_SEC_DISABLE, + PCOM_CLK_REGIME_SEC_IS_ON, + PCOM_CLK_REGIME_SEC_SEL_CLK_INV, + PCOM_CLK_REGIME_SEC_SEL_CLK_SRC, + PCOM_CLK_REGIME_SEC_SEL_CLK_DIV, + PCOM_CLK_REGIME_SEC_ICODEC_CLK_ENABLE, + PCOM_CLK_REGIME_SEC_ICODEC_CLK_DISABLE, + PCOM_CLK_REGIME_SEC_SEL_SPEED, + PCOM_CLK_REGIME_SEC_CONFIG_GP_CLK_WRP, + PCOM_CLK_REGIME_SEC_CONFIG_MDH_CLK_WRP, + PCOM_CLK_REGIME_SEC_USB_XTAL_ON, + PCOM_CLK_REGIME_SEC_USB_XTAL_OFF, + PCOM_CLK_REGIME_SEC_SET_QDSP_DME_MODE, + PCOM_CLK_REGIME_SEC_SWITCH_ADSP_CLK, + PCOM_CLK_REGIME_SEC_GET_MAX_ADSP_CLK_KHZ, + PCOM_CLK_REGIME_SEC_GET_I2C_CLK_KHZ, + PCOM_CLK_REGIME_SEC_MSM_GET_CLK_FREQ_KHZ, + PCOM_CLK_REGIME_SEC_SEL_VFE_SRC, + PCOM_CLK_REGIME_SEC_MSM_SEL_CAMCLK, + PCOM_CLK_REGIME_SEC_MSM_SEL_LCDCLK, + PCOM_CLK_REGIME_SEC_VFE_RAIL_OFF, + PCOM_CLK_REGIME_SEC_VFE_RAIL_ON, + PCOM_CLK_REGIME_SEC_GRP_RAIL_OFF, + PCOM_CLK_REGIME_SEC_GRP_RAIL_ON, + PCOM_CLK_REGIME_SEC_VDC_RAIL_OFF, + PCOM_CLK_REGIME_SEC_VDC_RAIL_ON, + PCOM_CLK_REGIME_SEC_LCD_CTRL, + PCOM_CLK_REGIME_SEC_REGISTER_FOR_CPU_RESOURCE, + PCOM_CLK_REGIME_SEC_DEREGISTER_FOR_CPU_RESOURCE, + PCOM_CLK_REGIME_SEC_RESOURCE_REQUEST_WRP, + PCOM_CLK_REGIME_MSM_SEC_SEL_CLK_OWNER, + PCOM_CLK_REGIME_SEC_DEVMAN_REQUEST_WRP, + PCOM_GPIO_CONFIG, + PCOM_GPIO_CONFIGURE_GROUP, + PCOM_GPIO_TLMM_SET_PORT, + PCOM_GPIO_TLMM_CONFIG_EX, + PCOM_SET_FTM_BOOT_COUNT, + PCOM_RESERVED0, + PCOM_RESERVED1, + PCOM_CUSTOMER_CMD1, + PCOM_CUSTOMER_CMD2, + PCOM_CUSTOMER_CMD3, + PCOM_CLK_REGIME_ENTER_APPSBL_CHG_MODE, + PCOM_CLK_REGIME_EXIT_APPSBL_CHG_MODE, + PCOM_CLK_REGIME_SEC_RAIL_DISABLE, + PCOM_CLK_REGIME_SEC_RAIL_ENABLE, + PCOM_CLK_REGIME_SEC_RAIL_CONTROL, + PCOM_SET_SW_WATCHDOG_STATE, + PCOM_PM_MPP_CONFIG_DIGITAL_INPUT, + PCOM_PM_MPP_CONFIG_I_SINK, + PCOM_RESERVED_101, + PCOM_MSM_HSUSB_PHY_RESET, + PCOM_GET_BATT_MV_LEVEL, + PCOM_CHG_USB_IS_PC_CONNECTED, + PCOM_CHG_USB_IS_CHARGER_CONNECTED, + PCOM_CHG_USB_IS_DISCONNECTED, + PCOM_CHG_USB_IS_AVAILABLE, + PCOM_CLK_REGIME_SEC_MSM_SEL_FREQ, + PCOM_CLK_REGIME_SEC_SET_PCLK_AXI_POLICY, + PCOM_CLKCTL_RPC_RESET_ASSERT, + PCOM_CLKCTL_RPC_RESET_DEASSERT, + PCOM_CLKCTL_RPC_RAIL_ON, + PCOM_CLKCTL_RPC_RAIL_OFF, + PCOM_CLKCTL_RPC_RAIL_ENABLE, + PCOM_CLKCTL_RPC_RAIL_DISABLE, + PCOM_CLKCTL_RPC_RAIL_CONTROL, + PCOM_CLKCTL_RPC_MIN_MSMC1, PCOM_NUM_CMDS, }; enum { - PCOM_INVALID_STATUS = 0x0, - PCOM_READY, - PCOM_CMD_RUNNING, - PCOM_CMD_SUCCESS, - PCOM_CMD_FAIL, + PCOM_INVALID_STATUS = 0x0, + PCOM_READY, + PCOM_CMD_RUNNING, + PCOM_CMD_SUCCESS, + PCOM_CMD_FAIL, + PCOM_CMD_FAIL_FALSE_RETURNED, + PCOM_CMD_FAIL_CMD_OUT_OF_BOUNDS_SERVER, + PCOM_CMD_FAIL_CMD_OUT_OF_BOUNDS_CLIENT, + PCOM_CMD_FAIL_CMD_UNREGISTERED, + PCOM_CMD_FAIL_CMD_LOCKED, + PCOM_CMD_FAIL_SERVER_NOT_YET_READY, + PCOM_CMD_FAIL_BAD_DESTINATION, + PCOM_CMD_FAIL_SERVER_RESET, + PCOM_CMD_FAIL_SMSM_NOT_INIT, + PCOM_CMD_FAIL_PROC_COMM_BUSY, + PCOM_CMD_FAIL_PROC_COMM_NOT_INIT, + }; /* List of VREGs that support the Pull Down Resistor setting. */ -enum { +enum vreg_pdown_id { PM_VREG_PDOWN_MSMA_ID, PM_VREG_PDOWN_MSMP_ID, PM_VREG_PDOWN_MSME1_ID, /* Not supported in Panoramix */ @@ -131,6 +218,11 @@ enum { PM_VREG_PDOWN_XO_ID = PM_VREG_PDOWN_TCXO_ID }; +enum { + PCOM_CLKRGM_APPS_RESET_USB_PHY = 34, + PCOM_CLKRGM_APPS_RESET_USBH = 37, +}; + /* gpio info for PCOM_RPC_GPIO_TLMM_CONFIG_EX */ #define GPIO_ENABLE 0 @@ -161,5 +253,6 @@ enum { (((drvstr) & 0xF) << 17)) int msm_proc_comm(unsigned cmd, unsigned *data1, unsigned *data2); +void __init proc_comm_boot_wait(void); #endif |