diff options
Diffstat (limited to 'arch/arm/mach-omap2/board-cm-t35.c')
| -rw-r--r-- | arch/arm/mach-omap2/board-cm-t35.c | 88 |
1 files changed, 63 insertions, 25 deletions
diff --git a/arch/arm/mach-omap2/board-cm-t35.c b/arch/arm/mach-omap2/board-cm-t35.c index bd1bcacb40f..e921e3be24a 100644 --- a/arch/arm/mach-omap2/board-cm-t35.c +++ b/arch/arm/mach-omap2/board-cm-t35.c @@ -37,7 +37,7 @@ #include <asm/mach/map.h> #include <plat/board.h> -#include <plat/common.h> +#include "common.h" #include <plat/nand.h> #include <plat/gpmc.h> #include <plat/usb.h> @@ -53,7 +53,8 @@ #include "hsmmc.h" #include "common-board-devices.h" -#define CM_T35_GPIO_PENDOWN 57 +#define CM_T35_GPIO_PENDOWN 57 +#define SB_T35_USB_HUB_RESET_GPIO 167 #define CM_T35_SMSC911X_CS 5 #define CM_T35_SMSC911X_GPIO 163 @@ -339,8 +340,10 @@ static struct regulator_consumer_supply cm_t35_vsim_supply[] = { REGULATOR_SUPPLY("vmmc_aux", "omap_hsmmc.0"), }; -static struct regulator_consumer_supply cm_t35_vdvi_supply[] = { - REGULATOR_SUPPLY("vdvi", "omapdss"), +static struct regulator_consumer_supply cm_t35_vio_supplies[] = { + REGULATOR_SUPPLY("vcc", "spi1.0"), + REGULATOR_SUPPLY("vdds_dsi", "omapdss"), + REGULATOR_SUPPLY("vdds_dsi", "omapdss_dsi1"), }; /* VMMC1 for MMC1 pins CMD, CLK, DAT0..DAT3 (20 mA, plus card == max 220 mA) */ @@ -373,6 +376,19 @@ static struct regulator_init_data cm_t35_vsim = { .consumer_supplies = cm_t35_vsim_supply, }; +static struct regulator_init_data cm_t35_vio = { + .constraints = { + .min_uV = 1800000, + .max_uV = 1800000, + .apply_uV = true, + .valid_modes_mask = REGULATOR_MODE_NORMAL + | REGULATOR_MODE_STANDBY, + .valid_ops_mask = REGULATOR_CHANGE_MODE, + }, + .num_consumer_supplies = ARRAY_SIZE(cm_t35_vio_supplies), + .consumer_supplies = cm_t35_vio_supplies, +}; + static uint32_t cm_t35_keymap[] = { KEY(0, 0, KEY_A), KEY(0, 1, KEY_B), KEY(0, 2, KEY_LEFT), KEY(1, 0, KEY_UP), KEY(1, 1, KEY_ENTER), KEY(1, 2, KEY_DOWN), @@ -421,6 +437,23 @@ static struct usbhs_omap_board_data usbhs_bdata __initdata = { .reset_gpio_port[2] = -EINVAL }; +static void cm_t35_init_usbh(void) +{ + int err; + + err = gpio_request_one(SB_T35_USB_HUB_RESET_GPIO, + GPIOF_OUT_INIT_LOW, "usb hub rst"); + if (err) { + pr_err("SB-T35: usb hub rst gpio request failed: %d\n", err); + } else { + udelay(10); + gpio_set_value(SB_T35_USB_HUB_RESET_GPIO, 1); + msleep(1); + } + + usbhs_init(&usbhs_bdata); +} + static int cm_t35_twl_gpio_setup(struct device *dev, unsigned gpio, unsigned ngpio) { @@ -456,17 +489,14 @@ static struct twl4030_platform_data cm_t35_twldata = { .gpio = &cm_t35_gpio_data, .vmmc1 = &cm_t35_vmmc1, .vsim = &cm_t35_vsim, + .vio = &cm_t35_vio, }; static void __init cm_t35_init_i2c(void) { omap3_pmic_get_config(&cm_t35_twldata, TWL_COMMON_PDATA_USB, - TWL_COMMON_REGULATOR_VDAC | TWL_COMMON_REGULATOR_VPLL2); - - cm_t35_twldata.vpll2->constraints.name = "VDVI"; - cm_t35_twldata.vpll2->num_consumer_supplies = - ARRAY_SIZE(cm_t35_vdvi_supply); - cm_t35_twldata.vpll2->consumer_supplies = cm_t35_vdvi_supply; + TWL_COMMON_REGULATOR_VDAC | + TWL_COMMON_PDATA_AUDIO); omap3_pmic_init("tps65930", &cm_t35_twldata); } @@ -570,24 +600,28 @@ static void __init cm_t3x_common_dss_mux_init(int mux_mode) static void __init cm_t35_init_mux(void) { - omap_mux_init_signal("gpio_70", OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("gpio_71", OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("gpio_72", OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("gpio_73", OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("gpio_74", OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("gpio_75", OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT); - cm_t3x_common_dss_mux_init(OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT); + int mux_mode = OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT; + + omap_mux_init_signal("dss_data0.dss_data0", mux_mode); + omap_mux_init_signal("dss_data1.dss_data1", mux_mode); + omap_mux_init_signal("dss_data2.dss_data2", mux_mode); + omap_mux_init_signal("dss_data3.dss_data3", mux_mode); + omap_mux_init_signal("dss_data4.dss_data4", mux_mode); + omap_mux_init_signal("dss_data5.dss_data5", mux_mode); + cm_t3x_common_dss_mux_init(mux_mode); } static void __init cm_t3730_init_mux(void) { - omap_mux_init_signal("sys_boot0", OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("sys_boot1", OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("sys_boot3", OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("sys_boot4", OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("sys_boot5", OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT); - omap_mux_init_signal("sys_boot6", OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT); - cm_t3x_common_dss_mux_init(OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT); + int mux_mode = OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT; + + omap_mux_init_signal("sys_boot0", mux_mode); + omap_mux_init_signal("sys_boot1", mux_mode); + omap_mux_init_signal("sys_boot3", mux_mode); + omap_mux_init_signal("sys_boot4", mux_mode); + omap_mux_init_signal("sys_boot5", mux_mode); + omap_mux_init_signal("sys_boot6", mux_mode); + cm_t3x_common_dss_mux_init(mux_mode); } #else static inline void cm_t35_init_mux(void) {} @@ -612,7 +646,7 @@ static void __init cm_t3x_common_init(void) cm_t35_init_display(); usb_musb_init(NULL); - usbhs_init(&usbhs_bdata); + cm_t35_init_usbh(); } static void __init cm_t35_init(void) @@ -634,8 +668,10 @@ MACHINE_START(CM_T35, "Compulab CM-T35") .map_io = omap3_map_io, .init_early = omap35xx_init_early, .init_irq = omap3_init_irq, + .handle_irq = omap3_intc_handle_irq, .init_machine = cm_t35_init, .timer = &omap3_timer, + .restart = omap_prcm_restart, MACHINE_END MACHINE_START(CM_T3730, "Compulab CM-T3730") @@ -644,6 +680,8 @@ MACHINE_START(CM_T3730, "Compulab CM-T3730") .map_io = omap3_map_io, .init_early = omap3630_init_early, .init_irq = omap3_init_irq, + .handle_irq = omap3_intc_handle_irq, .init_machine = cm_t3730_init, .timer = &omap3_timer, + .restart = omap_prcm_restart, MACHINE_END |