diff options
Diffstat (limited to 'arch/arm/mach-omap2/usb-musb.c')
| -rw-r--r-- | arch/arm/mach-omap2/usb-musb.c | 220 |
1 files changed, 83 insertions, 137 deletions
diff --git a/arch/arm/mach-omap2/usb-musb.c b/arch/arm/mach-omap2/usb-musb.c index 241fc94b411..35559f77e2d 100644 --- a/arch/arm/mach-omap2/usb-musb.c +++ b/arch/arm/mach-omap2/usb-musb.c @@ -30,118 +30,11 @@ #include <mach/irqs.h> #include <mach/am35xx.h> #include <plat/usb.h> -#include "control.h" +#include <plat/omap_device.h> +#include "mux.h" #if defined(CONFIG_USB_MUSB_OMAP2PLUS) || defined (CONFIG_USB_MUSB_AM35X) -static void am35x_musb_reset(void) -{ - u32 regval; - - /* Reset the musb interface */ - regval = omap_ctrl_readl(AM35XX_CONTROL_IP_SW_RESET); - - regval |= AM35XX_USBOTGSS_SW_RST; - omap_ctrl_writel(regval, AM35XX_CONTROL_IP_SW_RESET); - - regval &= ~AM35XX_USBOTGSS_SW_RST; - omap_ctrl_writel(regval, AM35XX_CONTROL_IP_SW_RESET); - - regval = omap_ctrl_readl(AM35XX_CONTROL_IP_SW_RESET); -} - -static void am35x_musb_phy_power(u8 on) -{ - unsigned long timeout = jiffies + msecs_to_jiffies(100); - u32 devconf2; - - if (on) { - /* - * Start the on-chip PHY and its PLL. - */ - devconf2 = omap_ctrl_readl(AM35XX_CONTROL_DEVCONF2); - - devconf2 &= ~(CONF2_RESET | CONF2_PHYPWRDN | CONF2_OTGPWRDN); - devconf2 |= CONF2_PHY_PLLON; - - omap_ctrl_writel(devconf2, AM35XX_CONTROL_DEVCONF2); - - pr_info(KERN_INFO "Waiting for PHY clock good...\n"); - while (!(omap_ctrl_readl(AM35XX_CONTROL_DEVCONF2) - & CONF2_PHYCLKGD)) { - cpu_relax(); - - if (time_after(jiffies, timeout)) { - pr_err(KERN_ERR "musb PHY clock good timed out\n"); - break; - } - } - } else { - /* - * Power down the on-chip PHY. - */ - devconf2 = omap_ctrl_readl(AM35XX_CONTROL_DEVCONF2); - - devconf2 &= ~CONF2_PHY_PLLON; - devconf2 |= CONF2_PHYPWRDN | CONF2_OTGPWRDN; - omap_ctrl_writel(devconf2, AM35XX_CONTROL_DEVCONF2); - } -} - -static void am35x_musb_clear_irq(void) -{ - u32 regval; - - regval = omap_ctrl_readl(AM35XX_CONTROL_LVL_INTR_CLEAR); - regval |= AM35XX_USBOTGSS_INT_CLR; - omap_ctrl_writel(regval, AM35XX_CONTROL_LVL_INTR_CLEAR); - regval = omap_ctrl_readl(AM35XX_CONTROL_LVL_INTR_CLEAR); -} - -static void am35x_musb_set_mode(u8 musb_mode) -{ - u32 devconf2 = omap_ctrl_readl(AM35XX_CONTROL_DEVCONF2); - - devconf2 &= ~CONF2_OTGMODE; - switch (musb_mode) { -#ifdef CONFIG_USB_MUSB_HDRC_HCD - case MUSB_HOST: /* Force VBUS valid, ID = 0 */ - devconf2 |= CONF2_FORCE_HOST; - break; -#endif -#ifdef CONFIG_USB_GADGET_MUSB_HDRC - case MUSB_PERIPHERAL: /* Force VBUS valid, ID = 1 */ - devconf2 |= CONF2_FORCE_DEVICE; - break; -#endif -#ifdef CONFIG_USB_MUSB_OTG - case MUSB_OTG: /* Don't override the VBUS/ID comparators */ - devconf2 |= CONF2_NO_OVERRIDE; - break; -#endif - default: - pr_info(KERN_INFO "Unsupported mode %u\n", musb_mode); - } - - omap_ctrl_writel(devconf2, AM35XX_CONTROL_DEVCONF2); -} - -static struct resource musb_resources[] = { - [0] = { /* start and end set dynamically */ - .flags = IORESOURCE_MEM, - }, - [1] = { /* general IRQ */ - .start = INT_243X_HS_USB_MC, - .flags = IORESOURCE_IRQ, - .name = "mc", - }, - [2] = { /* DMA IRQ */ - .start = INT_243X_HS_USB_DMA, - .flags = IORESOURCE_IRQ, - .name = "dma", - }, -}; - static struct musb_hdrc_config musb_config = { .multipoint = 1, .dyn_fifo = 1, @@ -169,38 +62,65 @@ static struct musb_hdrc_platform_data musb_plat = { static u64 musb_dmamask = DMA_BIT_MASK(32); -static struct platform_device musb_device = { - .name = "musb-omap2430", - .id = -1, - .dev = { - .dma_mask = &musb_dmamask, - .coherent_dma_mask = DMA_BIT_MASK(32), - .platform_data = &musb_plat, +static struct omap_device_pm_latency omap_musb_latency[] = { + { + .deactivate_func = omap_device_idle_hwmods, + .activate_func = omap_device_enable_hwmods, + .flags = OMAP_DEVICE_LATENCY_AUTO_ADJUST, }, - .num_resources = ARRAY_SIZE(musb_resources), - .resource = musb_resources, }; +static void usb_musb_mux_init(struct omap_musb_board_data *board_data) +{ + switch (board_data->interface_type) { + case MUSB_INTERFACE_UTMI: + omap_mux_init_signal("usba0_otg_dp", OMAP_PIN_INPUT); + omap_mux_init_signal("usba0_otg_dm", OMAP_PIN_INPUT); + break; + case MUSB_INTERFACE_ULPI: + omap_mux_init_signal("usba0_ulpiphy_clk", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_stp", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dir", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_nxt", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dat0", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dat1", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dat2", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dat3", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dat4", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dat5", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dat6", + OMAP_PIN_INPUT_PULLDOWN); + omap_mux_init_signal("usba0_ulpiphy_dat7", + OMAP_PIN_INPUT_PULLDOWN); + break; + default: + break; + } +} + void __init usb_musb_init(struct omap_musb_board_data *board_data) { - if (cpu_is_omap243x()) { - musb_resources[0].start = OMAP243X_HS_BASE; - } else if (cpu_is_omap3517() || cpu_is_omap3505()) { - musb_device.name = "musb-am35x"; - musb_resources[0].start = AM35XX_IPSS_USBOTGSS_BASE; - musb_resources[1].start = INT_35XX_USBOTG_IRQ; - board_data->set_phy_power = am35x_musb_phy_power; - board_data->clear_irq = am35x_musb_clear_irq; - board_data->set_mode = am35x_musb_set_mode; - board_data->reset = am35x_musb_reset; - } else if (cpu_is_omap34xx()) { - musb_resources[0].start = OMAP34XX_HSUSB_OTG_BASE; + struct omap_hwmod *oh; + struct omap_device *od; + struct platform_device *pdev; + struct device *dev; + int bus_id = -1; + const char *oh_name, *name; + + if (cpu_is_omap3517() || cpu_is_omap3505()) { } else if (cpu_is_omap44xx()) { - musb_resources[0].start = OMAP44XX_HSUSB_OTG_BASE; - musb_resources[1].start = OMAP44XX_IRQ_HS_USB_MC_N; - musb_resources[2].start = OMAP44XX_IRQ_HS_USB_DMA_N; + usb_musb_mux_init(board_data); } - musb_resources[0].end = musb_resources[0].start + SZ_4K - 1; /* * REVISIT: This line can be removed once all the platforms using @@ -212,12 +132,38 @@ void __init usb_musb_init(struct omap_musb_board_data *board_data) musb_plat.mode = board_data->mode; musb_plat.extvbus = board_data->extvbus; - if (platform_device_register(&musb_device) < 0) - printk(KERN_ERR "Unable to register HS-USB (MUSB) device\n"); - if (cpu_is_omap44xx()) omap4430_phy_init(dev); + if (cpu_is_omap3517() || cpu_is_omap3505()) { + oh_name = "am35x_otg_hs"; + name = "musb-am35x"; + } else { + oh_name = "usb_otg_hs"; + name = "musb-omap2430"; + } + + oh = omap_hwmod_lookup(oh_name); + if (!oh) { + pr_err("Could not look up %s\n", oh_name); + return; + } + + od = omap_device_build(name, bus_id, oh, &musb_plat, + sizeof(musb_plat), omap_musb_latency, + ARRAY_SIZE(omap_musb_latency), false); + if (IS_ERR(od)) { + pr_err("Could not build omap_device for %s %s\n", + name, oh_name); + return; + } + + pdev = &od->pdev; + dev = &pdev->dev; + get_device(dev); + dev->dma_mask = &musb_dmamask; + dev->coherent_dma_mask = musb_dmamask; + put_device(dev); } #else |