summaryrefslogtreecommitdiffstats
path: root/arch/blackfin/mach-bf548
diff options
context:
space:
mode:
Diffstat (limited to 'arch/blackfin/mach-bf548')
-rw-r--r--arch/blackfin/mach-bf548/include/mach/anomaly.h22
-rw-r--r--arch/blackfin/mach-bf548/include/mach/bfin_serial_5xx.h22
-rw-r--r--arch/blackfin/mach-bf548/include/mach/irq.h8
3 files changed, 37 insertions, 15 deletions
diff --git a/arch/blackfin/mach-bf548/include/mach/anomaly.h b/arch/blackfin/mach-bf548/include/mach/anomaly.h
index 23d03c52f4b..882e40ccf0d 100644
--- a/arch/blackfin/mach-bf548/include/mach/anomaly.h
+++ b/arch/blackfin/mach-bf548/include/mach/anomaly.h
@@ -2,12 +2,12 @@
* File: include/asm-blackfin/mach-bf548/anomaly.h
* Bugs: Enter bugs at http://blackfin.uclinux.org/
*
- * Copyright (C) 2004-2008 Analog Devices Inc.
+ * Copyright (C) 2004-2009 Analog Devices Inc.
* Licensed under the GPL-2 or later.
*/
/* This file shoule be up to date with:
- * - Revision G, 08/07/2008; ADSP-BF542/BF544/BF547/BF548/BF549 Blackfin Processor Anomaly List
+ * - Revision H, 01/16/2009; ADSP-BF542/BF544/BF547/BF548/BF549 Blackfin Processor Anomaly List
*/
#ifndef _MACH_ANOMALY_H_
@@ -91,8 +91,6 @@
#define ANOMALY_05000371 (__SILICON_REVISION__ < 2)
/* USB DP/DM Data Pins May Lose State When Entering Hibernate */
#define ANOMALY_05000372 (__SILICON_REVISION__ < 1)
-/* Mobile DDR Operation Not Functional */
-#define ANOMALY_05000377 (1)
/* Security/Authentication Speedpath Causes Authentication To Fail To Initiate */
#define ANOMALY_05000378 (__SILICON_REVISION__ < 2)
/* 16-Bit NAND FLASH Boot Mode Is Not Functional */
@@ -157,8 +155,22 @@
#define ANOMALY_05000429 (__SILICON_REVISION__ < 2)
/* Software System Reset Corrupts PLL_LOCKCNT Register */
#define ANOMALY_05000430 (__SILICON_REVISION__ >= 2)
+/* Incorrect Use of Stack in Lockbox Firmware During Authentication */
+#define ANOMALY_05000431 (__SILICON_REVISION__ < 3)
+/* OTP Write Accesses Not Supported */
+#define ANOMALY_05000442 (__SILICON_REVISION__ < 1)
/* IFLUSH Instruction at End of Hardware Loop Causes Infinite Stall */
#define ANOMALY_05000443 (1)
+/* CDMAPRIO and L2DMAPRIO Bits in the SYSCR Register Are Not Functional */
+#define ANOMALY_05000446 (1)
+/* UART IrDA Receiver Fails on Extended Bit Pulses */
+#define ANOMALY_05000447 (1)
+/* DDR Clock Duty Cycle Spec Violation (tCH, tCL) */
+#define ANOMALY_05000448 (__SILICON_REVISION__ == 1)
+/* Reduced Timing Margins on DDR Output Setup and Hold (tDS and tDH) */
+#define ANOMALY_05000449 (__SILICON_REVISION__ == 1)
+/* USB DMA Mode 1 Short Packet Data Corruption */
+#define ANOMALY_05000450 (1
/* Anomalies that don't exist on this proc */
#define ANOMALY_05000125 (0)
@@ -171,6 +183,8 @@
#define ANOMALY_05000263 (0)
#define ANOMALY_05000266 (0)
#define ANOMALY_05000273 (0)
+#define ANOMALY_05000278 (0)
+#define ANOMALY_05000305 (0)
#define ANOMALY_05000307 (0)
#define ANOMALY_05000311 (0)
#define ANOMALY_05000323 (0)
diff --git a/arch/blackfin/mach-bf548/include/mach/bfin_serial_5xx.h b/arch/blackfin/mach-bf548/include/mach/bfin_serial_5xx.h
index e4cf35e7ab9..c05e79cba25 100644
--- a/arch/blackfin/mach-bf548/include/mach/bfin_serial_5xx.h
+++ b/arch/blackfin/mach-bf548/include/mach/bfin_serial_5xx.h
@@ -63,7 +63,7 @@
#define UART_ENABLE_INTS(x, v) UART_SET_IER(x, v)
#define UART_DISABLE_INTS(x) UART_CLEAR_IER(x, 0xF)
-#if defined(CONFIG_BFIN_UART0_CTSRTS) || defined(CONFIG_BFIN_UART1_CTSRTS)
+#if defined(CONFIG_BFIN_UART0_CTSRTS) || defined(CONFIG_BFIN_UART2_CTSRTS)
# define CONFIG_SERIAL_BFIN_CTSRTS
# ifndef CONFIG_UART0_CTS_PIN
@@ -74,12 +74,12 @@
# define CONFIG_UART0_RTS_PIN -1
# endif
-# ifndef CONFIG_UART1_CTS_PIN
-# define CONFIG_UART1_CTS_PIN -1
+# ifndef CONFIG_UART2_CTS_PIN
+# define CONFIG_UART2_CTS_PIN -1
# endif
-# ifndef CONFIG_UART1_RTS_PIN
-# define CONFIG_UART1_RTS_PIN -1
+# ifndef CONFIG_UART2_RTS_PIN
+# define CONFIG_UART2_RTS_PIN -1
# endif
#endif
@@ -130,7 +130,7 @@ struct bfin_serial_res bfin_serial_resource[] = {
CH_UART0_TX,
CH_UART0_RX,
#endif
-#ifdef CONFIG_BFIN_UART0_CTSRTS
+#ifdef CONFIG_SERIAL_BFIN_CTSRTS
CONFIG_UART0_CTS_PIN,
CONFIG_UART0_RTS_PIN,
#endif
@@ -144,6 +144,10 @@ struct bfin_serial_res bfin_serial_resource[] = {
CH_UART1_TX,
CH_UART1_RX,
#endif
+#ifdef CONFIG_SERIAL_BFIN_CTSRTS
+ 0,
+ 0,
+#endif
},
#endif
#ifdef CONFIG_SERIAL_BFIN_UART2
@@ -154,7 +158,7 @@ struct bfin_serial_res bfin_serial_resource[] = {
CH_UART2_TX,
CH_UART2_RX,
#endif
-#ifdef CONFIG_BFIN_UART2_CTSRTS
+#ifdef CONFIG_SERIAL_BFIN_CTSRTS
CONFIG_UART2_CTS_PIN,
CONFIG_UART2_RTS_PIN,
#endif
@@ -168,6 +172,10 @@ struct bfin_serial_res bfin_serial_resource[] = {
CH_UART3_TX,
CH_UART3_RX,
#endif
+#ifdef CONFIG_SERIAL_BFIN_CTSRTS
+ 0,
+ 0,
+#endif
},
#endif
};
diff --git a/arch/blackfin/mach-bf548/include/mach/irq.h b/arch/blackfin/mach-bf548/include/mach/irq.h
index 60299a71e09..f194625f682 100644
--- a/arch/blackfin/mach-bf548/include/mach/irq.h
+++ b/arch/blackfin/mach-bf548/include/mach/irq.h
@@ -123,8 +123,8 @@ Events (highest priority) EMU 0
#define IRQ_MXVR_ERROR BFIN_IRQ(51) /* MXVR Status (Error) Interrupt */
#define IRQ_MXVR_MSG BFIN_IRQ(52) /* MXVR Message Interrupt */
#define IRQ_MXVR_PKT BFIN_IRQ(53) /* MXVR Packet Interrupt */
-#define IRQ_EPP1_ERROR BFIN_IRQ(54) /* EPPI1 Error Interrupt */
-#define IRQ_EPP2_ERROR BFIN_IRQ(55) /* EPPI2 Error Interrupt */
+#define IRQ_EPPI1_ERROR BFIN_IRQ(54) /* EPPI1 Error Interrupt */
+#define IRQ_EPPI2_ERROR BFIN_IRQ(55) /* EPPI2 Error Interrupt */
#define IRQ_UART3_ERROR BFIN_IRQ(56) /* UART3 Status (Error) Interrupt */
#define IRQ_HOST_ERROR BFIN_IRQ(57) /* HOST Status (Error) Interrupt */
#define IRQ_PIXC_ERROR BFIN_IRQ(59) /* PIXC Status (Error) Interrupt */
@@ -361,8 +361,8 @@ Events (highest priority) EMU 0
#define IRQ_UART2_ERR IRQ_UART2_ERROR
#define IRQ_CAN0_ERR IRQ_CAN0_ERROR
#define IRQ_MXVR_ERR IRQ_MXVR_ERROR
-#define IRQ_EPP1_ERR IRQ_EPP1_ERROR
-#define IRQ_EPP2_ERR IRQ_EPP2_ERROR
+#define IRQ_EPPI1_ERR IRQ_EPPI1_ERROR
+#define IRQ_EPPI2_ERR IRQ_EPPI2_ERROR
#define IRQ_UART3_ERR IRQ_UART3_ERROR
#define IRQ_HOST_ERR IRQ_HOST_ERROR
#define IRQ_PIXC_ERR IRQ_PIXC_ERROR