diff options
Diffstat (limited to 'arch/i386/mach-voyager/voyager_basic.c')
| -rw-r--r-- | arch/i386/mach-voyager/voyager_basic.c | 331 |
1 files changed, 0 insertions, 331 deletions
diff --git a/arch/i386/mach-voyager/voyager_basic.c b/arch/i386/mach-voyager/voyager_basic.c deleted file mode 100644 index 9b77b39b71a..00000000000 --- a/arch/i386/mach-voyager/voyager_basic.c +++ /dev/null @@ -1,331 +0,0 @@ -/* Copyright (C) 1999,2001 - * - * Author: J.E.J.Bottomley@HansenPartnership.com - * - * linux/arch/i386/kernel/voyager.c - * - * This file contains all the voyager specific routines for getting - * initialisation of the architecture to function. For additional - * features see: - * - * voyager_cat.c - Voyager CAT bus interface - * voyager_smp.c - Voyager SMP hal (emulates linux smp.c) - */ - -#include <linux/module.h> -#include <linux/types.h> -#include <linux/sched.h> -#include <linux/ptrace.h> -#include <linux/ioport.h> -#include <linux/interrupt.h> -#include <linux/init.h> -#include <linux/delay.h> -#include <linux/reboot.h> -#include <linux/sysrq.h> -#include <linux/smp.h> -#include <linux/nodemask.h> -#include <asm/io.h> -#include <asm/voyager.h> -#include <asm/vic.h> -#include <linux/pm.h> -#include <asm/tlbflush.h> -#include <asm/arch_hooks.h> -#include <asm/i8253.h> - -/* - * Power off function, if any - */ -void (*pm_power_off)(void); -EXPORT_SYMBOL(pm_power_off); - -int voyager_level = 0; - -struct voyager_SUS *voyager_SUS = NULL; - -#ifdef CONFIG_SMP -static void -voyager_dump(int dummy1, struct tty_struct *dummy3) -{ - /* get here via a sysrq */ - voyager_smp_dump(); -} - -static struct sysrq_key_op sysrq_voyager_dump_op = { - .handler = voyager_dump, - .help_msg = "Voyager", - .action_msg = "Dump Voyager Status", -}; -#endif - -void -voyager_detect(struct voyager_bios_info *bios) -{ - if(bios->len != 0xff) { - int class = (bios->class_1 << 8) - | (bios->class_2 & 0xff); - - printk("Voyager System detected.\n" - " Class %x, Revision %d.%d\n", - class, bios->major, bios->minor); - if(class == VOYAGER_LEVEL4) - voyager_level = 4; - else if(class < VOYAGER_LEVEL5_AND_ABOVE) - voyager_level = 3; - else - voyager_level = 5; - printk(" Architecture Level %d\n", voyager_level); - if(voyager_level < 4) - printk("\n**WARNING**: Voyager HAL only supports Levels 4 and 5 Architectures at the moment\n\n"); - /* install the power off handler */ - pm_power_off = voyager_power_off; -#ifdef CONFIG_SMP - register_sysrq_key('v', &sysrq_voyager_dump_op); -#endif - } else { - printk("\n\n**WARNING**: No Voyager Subsystem Found\n"); - } -} - -void -voyager_system_interrupt(int cpl, void *dev_id) -{ - printk("Voyager: detected system interrupt\n"); -} - -/* Routine to read information from the extended CMOS area */ -__u8 -voyager_extended_cmos_read(__u16 addr) -{ - outb(addr & 0xff, 0x74); - outb((addr >> 8) & 0xff, 0x75); - return inb(0x76); -} - -/* internal definitions for the SUS Click Map of memory */ - -#define CLICK_ENTRIES 16 -#define CLICK_SIZE 4096 /* click to byte conversion for Length */ - -typedef struct ClickMap { - struct Entry { - __u32 Address; - __u32 Length; - } Entry[CLICK_ENTRIES]; -} ClickMap_t; - - -/* This routine is pretty much an awful hack to read the bios clickmap by - * mapping it into page 0. There are usually three regions in the map: - * Base Memory - * Extended Memory - * zero length marker for end of map - * - * Returns are 0 for failure and 1 for success on extracting region. - */ -int __init -voyager_memory_detect(int region, __u32 *start, __u32 *length) -{ - int i; - int retval = 0; - __u8 cmos[4]; - ClickMap_t *map; - unsigned long map_addr; - unsigned long old; - - if(region >= CLICK_ENTRIES) { - printk("Voyager: Illegal ClickMap region %d\n", region); - return 0; - } - - for(i = 0; i < sizeof(cmos); i++) - cmos[i] = voyager_extended_cmos_read(VOYAGER_MEMORY_CLICKMAP + i); - - map_addr = *(unsigned long *)cmos; - - /* steal page 0 for this */ - old = pg0[0]; - pg0[0] = ((map_addr & PAGE_MASK) | _PAGE_RW | _PAGE_PRESENT); - local_flush_tlb(); - /* now clear everything out but page 0 */ - map = (ClickMap_t *)(map_addr & (~PAGE_MASK)); - - /* zero length is the end of the clickmap */ - if(map->Entry[region].Length != 0) { - *length = map->Entry[region].Length * CLICK_SIZE; - *start = map->Entry[region].Address; - retval = 1; - } - - /* replace the mapping */ - pg0[0] = old; - local_flush_tlb(); - return retval; -} - -/* voyager specific handling code for timer interrupts. Used to hand - * off the timer tick to the SMP code, since the VIC doesn't have an - * internal timer (The QIC does, but that's another story). */ -void -voyager_timer_interrupt(void) -{ - if((jiffies & 0x3ff) == 0) { - - /* There seems to be something flaky in either - * hardware or software that is resetting the timer 0 - * count to something much higher than it should be - * This seems to occur in the boot sequence, just - * before root is mounted. Therefore, every 10 - * seconds or so, we sanity check the timer zero count - * and kick it back to where it should be. - * - * FIXME: This is the most awful hack yet seen. I - * should work out exactly what is interfering with - * the timer count settings early in the boot sequence - * and swiftly introduce it to something sharp and - * pointy. */ - __u16 val; - - spin_lock(&i8253_lock); - - outb_p(0x00, 0x43); - val = inb_p(0x40); - val |= inb(0x40) << 8; - spin_unlock(&i8253_lock); - - if(val > LATCH) { - printk("\nVOYAGER: countdown timer value too high (%d), resetting\n\n", val); - spin_lock(&i8253_lock); - outb(0x34,0x43); - outb_p(LATCH & 0xff , 0x40); /* LSB */ - outb(LATCH >> 8 , 0x40); /* MSB */ - spin_unlock(&i8253_lock); - } - } -#ifdef CONFIG_SMP - smp_vic_timer_interrupt(); -#endif -} - -void -voyager_power_off(void) -{ - printk("VOYAGER Power Off\n"); - - if(voyager_level == 5) { - voyager_cat_power_off(); - } else if(voyager_level == 4) { - /* This doesn't apparently work on most L4 machines, - * but the specs say to do this to get automatic power - * off. Unfortunately, if it doesn't power off the - * machine, it ends up doing a cold restart, which - * isn't really intended, so comment out the code */ -#if 0 - int port; - - - /* enable the voyager Configuration Space */ - outb((inb(VOYAGER_MC_SETUP) & 0xf0) | 0x8, - VOYAGER_MC_SETUP); - /* the port for the power off flag is an offset from the - floating base */ - port = (inb(VOYAGER_SSPB_RELOCATION_PORT) << 8) + 0x21; - /* set the power off flag */ - outb(inb(port) | 0x1, port); -#endif - } - /* and wait for it to happen */ - local_irq_disable(); - for(;;) - halt(); -} - -/* copied from process.c */ -static inline void -kb_wait(void) -{ - int i; - - for (i=0; i<0x10000; i++) - if ((inb_p(0x64) & 0x02) == 0) - break; -} - -void -machine_shutdown(void) -{ - /* Architecture specific shutdown needed before a kexec */ -} - -void -machine_restart(char *cmd) -{ - printk("Voyager Warm Restart\n"); - kb_wait(); - - if(voyager_level == 5) { - /* write magic values to the RTC to inform system that - * shutdown is beginning */ - outb(0x8f, 0x70); - outb(0x5 , 0x71); - - udelay(50); - outb(0xfe,0x64); /* pull reset low */ - } else if(voyager_level == 4) { - __u16 catbase = inb(VOYAGER_SSPB_RELOCATION_PORT)<<8; - __u8 basebd = inb(VOYAGER_MC_SETUP); - - outb(basebd | 0x08, VOYAGER_MC_SETUP); - outb(0x02, catbase + 0x21); - } - local_irq_disable(); - for(;;) - halt(); -} - -void -machine_emergency_restart(void) -{ - /*for now, just hook this to a warm restart */ - machine_restart(NULL); -} - -void -mca_nmi_hook(void) -{ - __u8 dumpval __maybe_unused = inb(0xf823); - __u8 swnmi __maybe_unused = inb(0xf813); - - /* FIXME: assume dump switch pressed */ - /* check to see if the dump switch was pressed */ - VDEBUG(("VOYAGER: dumpval = 0x%x, swnmi = 0x%x\n", dumpval, swnmi)); - /* clear swnmi */ - outb(0xff, 0xf813); - /* tell SUS to ignore dump */ - if(voyager_level == 5 && voyager_SUS != NULL) { - if(voyager_SUS->SUS_mbox == VOYAGER_DUMP_BUTTON_NMI) { - voyager_SUS->kernel_mbox = VOYAGER_NO_COMMAND; - voyager_SUS->kernel_flags |= VOYAGER_OS_IN_PROGRESS; - udelay(1000); - voyager_SUS->kernel_mbox = VOYAGER_IGNORE_DUMP; - voyager_SUS->kernel_flags &= ~VOYAGER_OS_IN_PROGRESS; - } - } - printk(KERN_ERR "VOYAGER: Dump switch pressed, printing CPU%d tracebacks\n", smp_processor_id()); - show_stack(NULL, NULL); - show_state(); -} - - - -void -machine_halt(void) -{ - /* treat a halt like a power off */ - machine_power_off(); -} - -void machine_power_off(void) -{ - if (pm_power_off) - pm_power_off(); -} |