diff options
Diffstat (limited to 'arch/mips/Kconfig')
| -rw-r--r-- | arch/mips/Kconfig | 40 |
1 files changed, 28 insertions, 12 deletions
diff --git a/arch/mips/Kconfig b/arch/mips/Kconfig index 14af6cce2fa..27f83e64296 100644 --- a/arch/mips/Kconfig +++ b/arch/mips/Kconfig @@ -266,8 +266,8 @@ config MIPS_MALTA select BOOT_ELF32 select HAVE_STD_PC_SERIAL_PORT select DMA_NONCOHERENT - select IRQ_CPU select GENERIC_ISA_DMA + select IRQ_CPU select HW_HAS_PCI select I8259 select MIPS_BOARDS_GEN @@ -425,9 +425,8 @@ config MOMENCO_OCELOT_G select SWAP_IO_SPACE select SYS_HAS_CPU_RM7000 select SYS_SUPPORTS_32BIT_KERNEL - select SYS_SUPPORTS_64BIT_KERNEL + select SYS_SUPPORTS_64BIT_KERNEL if BROKEN select SYS_SUPPORTS_BIG_ENDIAN - select ARCH_SPARSEMEM_ENABLE help The Ocelot is a MIPS-based Single Board Computer (SBC) made by Momentum Computer <http://www.momenco.com/>. @@ -535,7 +534,7 @@ config SGI_IP22 select HW_HAS_EISA select IP22_CPU_SCACHE select IRQ_CPU - select NO_ISA if ISA + select GENERIC_ISA_DMA_SUPPORT_BROKEN select SWAP_IO_SPACE select SYS_HAS_CPU_R4X00 select SYS_HAS_CPU_R5000 @@ -560,6 +559,7 @@ config SGI_IP27 select SYS_SUPPORTS_64BIT_KERNEL select SYS_SUPPORTS_BIG_ENDIAN select SYS_SUPPORTS_NUMA + select SYS_SUPPORTS_SMP help This are the SGI Origin 200, Origin 2000 and Onyx 2 Graphics workstations. To compile a Linux kernel that runs on these, say Y @@ -766,6 +766,23 @@ config TOSHIBA_RBTX4938 endchoice +config KEXEC + bool "Kexec system call (EXPERIMENTAL)" + depends on EXPERIMENTAL + help + kexec is a system call that implements the ability to shutdown your + current kernel, and to start another kernel. It is like a reboot + but it is indepedent of the system firmware. And like a reboot + you can start any kernel with it, not just Linux. + + The name comes from the similiarity to the exec system call. + + It is an ongoing process to be certain the hardware in a machine + is properly shutdown, so do not be surprised if this code does not + initially work for you. It may help to enable device hotplugging + support. As of this writing the exact hardware interface is + strongly in flux, so no good recommendation can be made. + source "arch/mips/ddb5xxx/Kconfig" source "arch/mips/gt64120/ev64120/Kconfig" source "arch/mips/jazz/Kconfig" @@ -864,8 +881,11 @@ config MIPS_NILE4 config MIPS_DISABLE_OBSOLETE_IDE bool +config GENERIC_ISA_DMA_SUPPORT_BROKEN + bool + # -# Endianess selection. Suffiently obscure so many users don't know what to +# Endianess selection. Sufficiently obscure so many users don't know what to # answer,so we try hard to limit the available choices. Also the use of a # choice statement should be more obvious to the user. # @@ -874,7 +894,7 @@ choice help Some MIPS machines can be configured for either little or big endian byte order. These modes require different kernels and a different - Linux distribution. In general there is one prefered byteorder for a + Linux distribution. In general there is one preferred byteorder for a particular system but some systems are just as commonly used in the one or the other endianess. @@ -1633,9 +1653,6 @@ config ARCH_DISCONTIGMEM_ENABLE config ARCH_SPARSEMEM_ENABLE bool - -config ARCH_SPARSEMEM_ENABLE - bool select SPARSEMEM_STATIC config NUMA @@ -1690,6 +1707,7 @@ config NR_CPUS depends on SMP default "64" if SGI_IP27 default "2" + default "8" if MIPS_MT_SMTC help This allows you to specify the maximum number of CPUs which this kernel will support. The maximum supported value is 32 for 32-bit @@ -1837,13 +1855,11 @@ source "drivers/pci/Kconfig" config ISA bool -config NO_ISA - bool - config EISA bool "EISA support" depends on HW_HAS_EISA select ISA + select GENERIC_ISA_DMA ---help--- The Extended Industry Standard Architecture (EISA) bus was developed as an open alternative to the IBM MicroChannel bus. |