diff options
Diffstat (limited to 'arch/mips/mti-malta/malta-smtc.c')
| -rw-r--r-- | arch/mips/mti-malta/malta-smtc.c | 162 |
1 files changed, 0 insertions, 162 deletions
diff --git a/arch/mips/mti-malta/malta-smtc.c b/arch/mips/mti-malta/malta-smtc.c deleted file mode 100644 index c4849904f01..00000000000 --- a/arch/mips/mti-malta/malta-smtc.c +++ /dev/null @@ -1,162 +0,0 @@ -/* - * Malta Platform-specific hooks for SMP operation - */ -#include <linux/irq.h> -#include <linux/init.h> - -#include <asm/mipsregs.h> -#include <asm/mipsmtregs.h> -#include <asm/smtc.h> -#include <asm/smtc_ipi.h> - -/* VPE/SMP Prototype implements platform interfaces directly */ - -/* - * Cause the specified action to be performed on a targeted "CPU" - */ - -static void msmtc_send_ipi_single(int cpu, unsigned int action) -{ - /* "CPU" may be TC of same VPE, VPE of same CPU, or different CPU */ - smtc_send_ipi(cpu, LINUX_SMP_IPI, action); -} - -static void msmtc_send_ipi_mask(const struct cpumask *mask, unsigned int action) -{ - unsigned int i; - - for_each_cpu(i, mask) - msmtc_send_ipi_single(i, action); -} - -/* - * Post-config but pre-boot cleanup entry point - */ -static void msmtc_init_secondary(void) -{ - int myvpe; - - /* Don't enable Malta I/O interrupts (IP2) for secondary VPEs */ - myvpe = read_c0_tcbind() & TCBIND_CURVPE; - if (myvpe != 0) { - /* Ideally, this should be done only once per VPE, but... */ - clear_c0_status(ST0_IM); - set_c0_status((0x100 << cp0_compare_irq) - | (0x100 << MIPS_CPU_IPI_IRQ)); - if (cp0_perfcount_irq >= 0) - set_c0_status(0x100 << cp0_perfcount_irq); - } - - smtc_init_secondary(); -} - -/* - * Platform "CPU" startup hook - */ -static void msmtc_boot_secondary(int cpu, struct task_struct *idle) -{ - smtc_boot_secondary(cpu, idle); -} - -/* - * SMP initialization finalization entry point - */ -static void msmtc_smp_finish(void) -{ - smtc_smp_finish(); -} - -/* - * Hook for after all CPUs are online - */ - -static void msmtc_cpus_done(void) -{ -} - -/* - * Platform SMP pre-initialization - * - * As noted above, we can assume a single CPU for now - * but it may be multithreaded. - */ - -static void __init msmtc_smp_setup(void) -{ - /* - * we won't get the definitive value until - * we've run smtc_prepare_cpus later, but - * we would appear to need an upper bound now. - */ - smp_num_siblings = smtc_build_cpu_map(0); -} - -static void __init msmtc_prepare_cpus(unsigned int max_cpus) -{ - smtc_prepare_cpus(max_cpus); -} - -struct plat_smp_ops msmtc_smp_ops = { - .send_ipi_single = msmtc_send_ipi_single, - .send_ipi_mask = msmtc_send_ipi_mask, - .init_secondary = msmtc_init_secondary, - .smp_finish = msmtc_smp_finish, - .cpus_done = msmtc_cpus_done, - .boot_secondary = msmtc_boot_secondary, - .smp_setup = msmtc_smp_setup, - .prepare_cpus = msmtc_prepare_cpus, -}; - -#ifdef CONFIG_MIPS_MT_SMTC_IRQAFF -/* - * IRQ affinity hook - */ - - -int plat_set_irq_affinity(struct irq_data *d, const struct cpumask *affinity, - bool force) -{ - cpumask_t tmask; - int cpu = 0; - void smtc_set_irq_affinity(unsigned int irq, cpumask_t aff); - - /* - * On the legacy Malta development board, all I/O interrupts - * are routed through the 8259 and combined in a single signal - * to the CPU daughterboard, and on the CoreFPGA2/3 34K models, - * that signal is brought to IP2 of both VPEs. To avoid racing - * concurrent interrupt service events, IP2 is enabled only on - * one VPE, by convention VPE0. So long as no bits are ever - * cleared in the affinity mask, there will never be any - * interrupt forwarding. But as soon as a program or operator - * sets affinity for one of the related IRQs, we need to make - * sure that we don't ever try to forward across the VPE boundary, - * at least not until we engineer a system where the interrupt - * _ack() or _end() function can somehow know that it corresponds - * to an interrupt taken on another VPE, and perform the appropriate - * restoration of Status.IM state using MFTR/MTTR instead of the - * normal local behavior. We also ensure that no attempt will - * be made to forward to an offline "CPU". - */ - - cpumask_copy(&tmask, affinity); - for_each_cpu(cpu, affinity) { - if ((cpu_data[cpu].vpe_id != 0) || !cpu_online(cpu)) - cpu_clear(cpu, tmask); - } - cpumask_copy(d->affinity, &tmask); - - if (cpus_empty(tmask)) - /* - * We could restore a default mask here, but the - * runtime code can anyway deal with the null set - */ - printk(KERN_WARNING - "IRQ affinity leaves no legal CPU for IRQ %d\n", d->irq); - - /* Do any generic SMTC IRQ affinity setup */ - smtc_set_irq_affinity(d->irq, tmask); - - return IRQ_SET_MASK_OK_NOCOPY; -} -#endif /* CONFIG_MIPS_MT_SMTC_IRQAFF */ |