diff options
Diffstat (limited to 'arch/mips/sgi-ip22/ip22-mc.c')
-rw-r--r-- | arch/mips/sgi-ip22/ip22-mc.c | 44 |
1 files changed, 22 insertions, 22 deletions
diff --git a/arch/mips/sgi-ip22/ip22-mc.c b/arch/mips/sgi-ip22/ip22-mc.c index 75ada8a9713..7cec0a4e527 100644 --- a/arch/mips/sgi-ip22/ip22-mc.c +++ b/arch/mips/sgi-ip22/ip22-mc.c @@ -121,22 +121,22 @@ void __init sgimc_init(void) */ /* Step 0: Make sure we turn off the watchdog in case it's - * still running (which might be the case after a - * soft reboot). + * still running (which might be the case after a + * soft reboot). */ tmp = sgimc->cpuctrl0; tmp &= ~SGIMC_CCTRL0_WDOG; sgimc->cpuctrl0 = tmp; /* Step 1: The CPU/GIO error status registers will not latch - * up a new error status until the register has been - * cleared by the cpu. These status registers are - * cleared by writing any value to them. + * up a new error status until the register has been + * cleared by the cpu. These status registers are + * cleared by writing any value to them. */ sgimc->cstat = sgimc->gstat = 0; /* Step 2: Enable all parity checking in cpu control register - * zero. + * zero. */ /* don't touch parity settings for IP28 */ tmp = sgimc->cpuctrl0; @@ -147,7 +147,7 @@ void __init sgimc_init(void) sgimc->cpuctrl0 = tmp; /* Step 3: Setup the MC write buffer depth, this is controlled - * in cpu control register 1 in the lower 4 bits. + * in cpu control register 1 in the lower 4 bits. */ tmp = sgimc->cpuctrl1; tmp &= ~0xf; @@ -155,26 +155,26 @@ void __init sgimc_init(void) sgimc->cpuctrl1 = tmp; /* Step 4: Initialize the RPSS divider register to run as fast - * as it can correctly operate. The register is laid - * out as follows: + * as it can correctly operate. The register is laid + * out as follows: * - * ---------------------------------------- - * | RESERVED | INCREMENT | DIVIDER | - * ---------------------------------------- - * 31 16 15 8 7 0 + * ---------------------------------------- + * | RESERVED | INCREMENT | DIVIDER | + * ---------------------------------------- + * 31 16 15 8 7 0 * - * DIVIDER determines how often a 'tick' happens, - * INCREMENT determines by how the RPSS increment - * registers value increases at each 'tick'. Thus, - * for IP22 we get INCREMENT=1, DIVIDER=1 == 0x101 + * DIVIDER determines how often a 'tick' happens, + * INCREMENT determines by how the RPSS increment + * registers value increases at each 'tick'. Thus, + * for IP22 we get INCREMENT=1, DIVIDER=1 == 0x101 */ sgimc->divider = 0x101; /* Step 5: Initialize GIO64 arbitrator configuration register. * * NOTE: HPC init code in sgihpc_init() must run before us because - * we need to know Guiness vs. FullHouse and the board - * revision on this machine. You have been warned. + * we need to know Guiness vs. FullHouse and the board + * revision on this machine. You have been warned. */ /* First the basic invariants across all GIO64 implementations. */ @@ -187,18 +187,18 @@ void __init sgimc_init(void) if (SGIOC_SYSID_BOARDREV(sgioc->sysid) < 2) { tmp |= SGIMC_GIOPAR_HPC264; /* 2nd HPC at 64bits */ tmp |= SGIMC_GIOPAR_PLINEEXP0; /* exp0 pipelines */ - tmp |= SGIMC_GIOPAR_MASTEREXP1; /* exp1 masters */ + tmp |= SGIMC_GIOPAR_MASTEREXP1; /* exp1 masters */ tmp |= SGIMC_GIOPAR_RTIMEEXP0; /* exp0 is realtime */ } else { tmp |= SGIMC_GIOPAR_HPC264; /* 2nd HPC 64bits */ tmp |= SGIMC_GIOPAR_PLINEEXP0; /* exp[01] pipelined */ tmp |= SGIMC_GIOPAR_PLINEEXP1; - tmp |= SGIMC_GIOPAR_MASTEREISA; /* EISA masters */ + tmp |= SGIMC_GIOPAR_MASTEREISA; /* EISA masters */ } } else { /* Guiness specific settings. */ tmp |= SGIMC_GIOPAR_EISA64; /* MC talks to EISA at 64bits */ - tmp |= SGIMC_GIOPAR_MASTEREISA; /* EISA bus can act as master */ + tmp |= SGIMC_GIOPAR_MASTEREISA; /* EISA bus can act as master */ } sgimc->giopar = tmp; /* poof */ |