diff options
Diffstat (limited to 'arch/mips/sibyte/sb1250')
| -rw-r--r-- | arch/mips/sibyte/sb1250/bus_watcher.c | 6 | ||||
| -rw-r--r-- | arch/mips/sibyte/sb1250/irq.c | 8 | ||||
| -rw-r--r-- | arch/mips/sibyte/sb1250/setup.c | 18 |
3 files changed, 16 insertions, 16 deletions
diff --git a/arch/mips/sibyte/sb1250/bus_watcher.c b/arch/mips/sibyte/sb1250/bus_watcher.c index 86e6e54dd15..e651105b3f0 100644 --- a/arch/mips/sibyte/sb1250/bus_watcher.c +++ b/arch/mips/sibyte/sb1250/bus_watcher.c @@ -71,7 +71,7 @@ static void print_summary(uint32_t status, uint32_t l2_err, * already been destructively read out of the registers. * * notes: this is currently used by the cache error handler - * should provide locking against the interrupt handler + * should provide locking against the interrupt handler */ void check_bus_watcher(void) { @@ -119,7 +119,7 @@ static int bw_print_buffer(char *page, struct bw_stats_struct *stats) (int)G_SCD_BERR_RID(stats->status), (int)G_SCD_BERR_DCODE(stats->status)); /* XXXKW indicate multiple errors between printings, or stats - collection (or both)? */ + collection (or both)? */ if (stats->status & M_SCD_BERR_MULTERRS) len += sprintf(page+len, "Multiple errors observed since last check.\n"); if (stats->status_printed) { @@ -168,7 +168,7 @@ static void create_proc_decoder(struct bw_stats_struct *stats) * sibyte_bw_int - handle bus watcher interrupts and accumulate counts * * notes: possible re-entry due to multiple sources - * should check/indicate saturation + * should check/indicate saturation */ static irqreturn_t sibyte_bw_int(int irq, void *data) { diff --git a/arch/mips/sibyte/sb1250/irq.c b/arch/mips/sibyte/sb1250/irq.c index 340aaf62665..fca0cdb9950 100644 --- a/arch/mips/sibyte/sb1250/irq.c +++ b/arch/mips/sibyte/sb1250/irq.c @@ -264,7 +264,7 @@ void __init arch_init_irq(void) IOADDR(A_IMR_REGISTER(1, R_IMR_INTERRUPT_MAP_BASE) + (K_INT_MBOX_0 << 3))); - /* Clear the mailboxes. The firmware may leave them dirty */ + /* Clear the mailboxes. The firmware may leave them dirty */ __raw_writeq(0xffffffffffffffffULL, IOADDR(A_IMR_REGISTER(0, R_IMR_MAILBOX_CLR_CPU))); __raw_writeq(0xffffffffffffffffULL, @@ -277,7 +277,7 @@ void __init arch_init_irq(void) /* * Note that the timer interrupts are also mapped, but this is - * done in sb1250_time_init(). Also, the profiling driver + * done in sb1250_time_init(). Also, the profiling driver * does its own management of IP7. */ @@ -294,7 +294,7 @@ static inline void dispatch_ip2(void) /* * Default...we've hit an IP[2] interrupt, which means we've got to - * check the 1250 interrupt registers to figure out what to do. Need + * check the 1250 interrupt registers to figure out what to do. Need * to detect which CPU we're on, now that smp_affinity is supported. */ mask = __raw_readq(IOADDR(A_IMR_REGISTER(cpu, @@ -323,7 +323,7 @@ asmlinkage void plat_irq_dispatch(void) if (pending & CAUSEF_IP7) /* CPU performance counter interrupt */ do_IRQ(MIPS_CPU_IRQ_BASE + 7); else if (pending & CAUSEF_IP4) - do_IRQ(K_INT_TIMER_0 + cpu); /* sb1250_timer_interrupt() */ + do_IRQ(K_INT_TIMER_0 + cpu); /* sb1250_timer_interrupt() */ #ifdef CONFIG_SMP else if (pending & CAUSEF_IP3) diff --git a/arch/mips/sibyte/sb1250/setup.c b/arch/mips/sibyte/sb1250/setup.c index 92da3155ce0..a14bd4cb0bc 100644 --- a/arch/mips/sibyte/sb1250/setup.c +++ b/arch/mips/sibyte/sb1250/setup.c @@ -203,8 +203,8 @@ void __init sb1250_setup(void) case K_SYS_REVISION_BCM1250_PASS1: #ifndef CONFIG_SB1_PASS_1_WORKAROUNDS printk("@@@@ This is a BCM1250 A0-A2 (Pass 1) board, " - "and the kernel doesn't have the proper " - "workarounds compiled in. @@@@\n"); + "and the kernel doesn't have the proper " + "workarounds compiled in. @@@@\n"); bad_config = 1; #endif break; @@ -213,28 +213,28 @@ void __init sb1250_setup(void) #if !defined(CONFIG_SB1_PASS_2_WORKAROUNDS) || \ !defined(CONFIG_SB1_PASS_2_1_WORKAROUNDS) printk("@@@@ This is a BCM1250 A3-A10 board, and the " - "kernel doesn't have the proper workarounds " - "compiled in. @@@@\n"); + "kernel doesn't have the proper workarounds " + "compiled in. @@@@\n"); bad_config = 1; #endif #ifdef CONFIG_CPU_HAS_PREFETCH printk("@@@@ Prefetches may be enabled in this kernel, " - "but are buggy on this board. @@@@\n"); + "but are buggy on this board. @@@@\n"); bad_config = 1; #endif break; case K_SYS_REVISION_BCM1250_PASS2_2: #ifndef CONFIG_SB1_PASS_2_WORKAROUNDS printk("@@@@ This is a BCM1250 B1/B2. board, and the " - "kernel doesn't have the proper workarounds " - "compiled in. @@@@\n"); + "kernel doesn't have the proper workarounds " + "compiled in. @@@@\n"); bad_config = 1; #endif #if defined(CONFIG_SB1_PASS_2_1_WORKAROUNDS) || \ !defined(CONFIG_CPU_HAS_PREFETCH) printk("@@@@ This is a BCM1250 B1/B2, but the kernel is " - "conservatively configured for an 'A' stepping. " - "@@@@\n"); + "conservatively configured for an 'A' stepping. " + "@@@@\n"); #endif break; default: |