diff options
Diffstat (limited to 'arch/powerpc/Kconfig.debug')
| -rw-r--r-- | arch/powerpc/Kconfig.debug | 35 |
1 files changed, 33 insertions, 2 deletions
diff --git a/arch/powerpc/Kconfig.debug b/arch/powerpc/Kconfig.debug index 346cd3befe1..464f9b4b316 100644 --- a/arch/powerpc/Kconfig.debug +++ b/arch/powerpc/Kconfig.debug @@ -20,7 +20,7 @@ config DEBUG_STACK_USAGE config DEBUG_PAGEALLOC bool "Debug page memory allocations" - depends on DEBUG_KERNEL && !SOFTWARE_SUSPEND + depends on DEBUG_KERNEL && !HIBERNATION help Unmap pages from the kernel linear mapping after free_pages(). This results in a large slowdown, but helps to find certain types @@ -124,6 +124,16 @@ config IRQSTACKS for handling hard and soft interrupts. This can help avoid overflowing the process kernel stacks. +config VIRQ_DEBUG + bool "Expose hardware/virtual IRQ mapping via debugfs" + depends on DEBUG_FS && PPC_MERGE + help + This option will show the mapping relationship between hardware irq + numbers and virtual irq numbers. The mapping is exposed via debugfs + in the file powerpc/virq_mapping. + + If you don't know what this means you don't need it. + config BDI_SWITCH bool "Include BDI-2000 user context switcher" depends on DEBUG_KERNEL && PPC32 @@ -134,7 +144,7 @@ config BDI_SWITCH config BOOTX_TEXT bool "Support for early boot text console (BootX or OpenFirmware only)" - depends PPC_OF + depends PPC_OF && PPC_MULTIPLATFORM help Say Y here to see progress messages from the boot firmware in text mode. Requires either BootX or Open Firmware. @@ -211,6 +221,15 @@ config PPC_EARLY_DEBUG_44x Select this to enable early debugging for IBM 44x chips via the inbuilt serial port. +config PPC_EARLY_DEBUG_CPM + bool "Early serial debugging for Freescale CPM-based serial ports" + depends on SERIAL_CPM + select PIN_TLB if PPC_8xx + help + Select this to enable early debugging for Freescale chips + using a CPM-based serial port. This assumes that the bootwrapper + has run, and set up the CPM in a particular way. + endchoice config PPC_EARLY_DEBUG_44x_PHYSLOW @@ -223,4 +242,16 @@ config PPC_EARLY_DEBUG_44x_PHYSHIGH depends PPC_EARLY_DEBUG_44x default "0x1" +config PPC_EARLY_DEBUG_CPM_ADDR + hex "CPM UART early debug transmit descriptor address" + depends on PPC_EARLY_DEBUG_CPM + default "0xfa202008" if PPC_EP88XC + default "0xf0000008" if CPM2 + default "0xff002008" if CPM1 + help + This specifies the address of the transmit descriptor + used for early debug output. Because it is needed before + platform probing is done, all platforms selected must + share the same address. + endmenu |