diff options
Diffstat (limited to 'arch/powerpc/Kconfig')
| -rw-r--r-- | arch/powerpc/Kconfig | 97 |
1 files changed, 80 insertions, 17 deletions
diff --git a/arch/powerpc/Kconfig b/arch/powerpc/Kconfig index 4bb2e9310a5..3934e265940 100644 --- a/arch/powerpc/Kconfig +++ b/arch/powerpc/Kconfig @@ -608,6 +608,19 @@ source "drivers/pcmcia/Kconfig" source "drivers/pci/hotplug/Kconfig" +config HAS_RAPIDIO + bool + default n + +config RAPIDIO + bool "RapidIO support" + depends on HAS_RAPIDIO + help + If you say Y here, the kernel will include drivers and + infrastructure code to support RapidIO interconnect devices. + +source "drivers/rapidio/Kconfig" + endmenu menu "Advanced setup" @@ -626,20 +639,6 @@ config ADVANCED_OPTIONS comment "Default settings for advanced configuration options are used" depends on !ADVANCED_OPTIONS -config HIGHMEM_START_BOOL - bool "Set high memory pool address" - depends on ADVANCED_OPTIONS && HIGHMEM - help - This option allows you to set the base address of the kernel virtual - area used to map high memory pages. This can be useful in - optimizing the layout of kernel virtual memory. - - Say N here unless you know what you are doing. - -config HIGHMEM_START - hex "Virtual start address of high memory pool" if HIGHMEM_START_BOOL - default "0xfe000000" - config LOWMEM_SIZE_BOOL bool "Set maximum low memory" depends on ADVANCED_OPTIONS @@ -656,21 +655,76 @@ config LOWMEM_SIZE hex "Maximum low memory size (in bytes)" if LOWMEM_SIZE_BOOL default "0x30000000" +config RELOCATABLE + bool "Build a relocatable kernel (EXPERIMENTAL)" + depends on EXPERIMENTAL && ADVANCED_OPTIONS && FLATMEM && FSL_BOOKE + help + This builds a kernel image that is capable of running at the + location the kernel is loaded at (some alignment restrictions may + exist). + + One use is for the kexec on panic case where the recovery kernel + must live at a different physical address than the primary + kernel. + + Note: If CONFIG_RELOCATABLE=y, then the kernel runs from the address + it has been loaded at and the compile time physical addresses + CONFIG_PHYSICAL_START is ignored. However CONFIG_PHYSICAL_START + setting can still be useful to bootwrappers that need to know the + load location of the kernel (eg. u-boot/mkimage). + +config PAGE_OFFSET_BOOL + bool "Set custom page offset address" + depends on ADVANCED_OPTIONS + help + This option allows you to set the kernel virtual address at which + the kernel will map low memory. This can be useful in optimizing + the virtual memory layout of the system. + + Say N here unless you know what you are doing. + +config PAGE_OFFSET + hex "Virtual address of memory base" if PAGE_OFFSET_BOOL + default "0xc0000000" + config KERNEL_START_BOOL bool "Set custom kernel base address" depends on ADVANCED_OPTIONS help This option allows you to set the kernel virtual address at which - the kernel will map low memory (the kernel image will be linked at - this address). This can be useful in optimizing the virtual memory - layout of the system. + the kernel will be loaded. Normally this should match PAGE_OFFSET + however there are times (like kdump) that one might not want them + to be the same. Say N here unless you know what you are doing. config KERNEL_START hex "Virtual address of kernel base" if KERNEL_START_BOOL + default PAGE_OFFSET if PAGE_OFFSET_BOOL + default "0xc2000000" if CRASH_DUMP default "0xc0000000" +config PHYSICAL_START_BOOL + bool "Set physical address where the kernel is loaded" + depends on ADVANCED_OPTIONS && FLATMEM && FSL_BOOKE + help + This gives the physical address where the kernel is loaded. + + Say N here unless you know what you are doing. + +config PHYSICAL_START + hex "Physical address where the kernel is loaded" if PHYSICAL_START_BOOL + default "0x02000000" if PPC_STD_MMU && CRASH_DUMP + default "0x00000000" + +config PHYSICAL_ALIGN + hex + default "0x10000000" if FSL_BOOKE + help + This value puts the alignment restrictions on physical address + where kernel is loaded and run from. Kernel is compiled for an + address which meets above alignment restriction. + config TASK_SIZE_BOOL bool "Set custom user task size" depends on ADVANCED_OPTIONS @@ -717,9 +771,17 @@ config PIN_TLB endmenu if PPC64 +config PAGE_OFFSET + hex + default "0xc000000000000000" config KERNEL_START hex + default "0xc000000002000000" if CRASH_DUMP default "0xc000000000000000" +config PHYSICAL_START + hex + default "0x02000000" if CRASH_DUMP + default "0x00000000" endif source "net/Kconfig" @@ -754,3 +816,4 @@ config PPC_CLOCK config PPC_LIB_RHEAP bool +source "arch/powerpc/kvm/Kconfig" |