diff options
Diffstat (limited to 'arch/powerpc/kernel/exceptions-64s.S')
| -rw-r--r-- | arch/powerpc/kernel/exceptions-64s.S | 74 |
1 files changed, 40 insertions, 34 deletions
diff --git a/arch/powerpc/kernel/exceptions-64s.S b/arch/powerpc/kernel/exceptions-64s.S index 050f79a4a16..c2df8150bd7 100644 --- a/arch/powerpc/kernel/exceptions-64s.S +++ b/arch/powerpc/kernel/exceptions-64s.S @@ -15,6 +15,7 @@ #include <asm/hw_irq.h> #include <asm/exception-64s.h> #include <asm/ptrace.h> +#include <asm/cpuidle.h> /* * We layout physical memory as follows: @@ -101,23 +102,34 @@ system_reset_pSeries: #ifdef CONFIG_PPC_P7_NAP BEGIN_FTR_SECTION /* Running native on arch 2.06 or later, check if we are - * waking up from nap. We only handle no state loss and - * supervisor state loss. We do -not- handle hypervisor - * state loss at this time. + * waking up from nap/sleep/winkle. */ mfspr r13,SPRN_SRR1 rlwinm. r13,r13,47-31,30,31 beq 9f - /* waking up from powersave (nap) state */ - cmpwi cr1,r13,2 - /* Total loss of HV state is fatal, we could try to use the - * PIR to locate a PACA, then use an emergency stack etc... - * OPAL v3 based powernv platforms have new idle states - * which fall in this catagory. + cmpwi cr3,r13,2 + + /* + * Check if last bit of HSPGR0 is set. This indicates whether we are + * waking up from winkle. */ - bgt cr1,8f GET_PACA(r13) + clrldi r5,r13,63 + clrrdi r13,r13,1 + cmpwi cr4,r5,1 + mtspr SPRN_HSPRG0,r13 + + lbz r0,PACA_THREAD_IDLE_STATE(r13) + cmpwi cr2,r0,PNV_THREAD_NAP + bgt cr2,8f /* Either sleep or Winkle */ + + /* Waking up from nap should not cause hypervisor state loss */ + bgt cr3,. + + /* Waking up from nap */ + li r0,PNV_THREAD_RUNNING + stb r0,PACA_THREAD_IDLE_STATE(r13) /* Clear thread state */ #ifdef CONFIG_KVM_BOOK3S_HV_POSSIBLE li r0,KVM_HWTHREAD_IN_KERNEL @@ -131,7 +143,9 @@ BEGIN_FTR_SECTION 1: #endif - beq cr1,2f + /* Return SRR1 from power7_nap() */ + mfspr r3,SPRN_SRR1 + beq cr3,2f b power7_wakeup_noloss 2: b power7_wakeup_loss @@ -292,15 +306,26 @@ decrementer_pSeries: . = 0xc00 .globl system_call_pSeries system_call_pSeries: - HMT_MEDIUM + /* + * If CONFIG_KVM_BOOK3S_64_HANDLER is set, save the PPR (on systems + * that support it) before changing to HMT_MEDIUM. That allows the KVM + * code to save that value into the guest state (it is the guest's PPR + * value). Otherwise just change to HMT_MEDIUM as userspace has + * already saved the PPR. + */ #ifdef CONFIG_KVM_BOOK3S_64_HANDLER SET_SCRATCH0(r13) GET_PACA(r13) std r9,PACA_EXGEN+EX_R9(r13) + OPT_GET_SPR(r9, SPRN_PPR, CPU_FTR_HAS_PPR); + HMT_MEDIUM; std r10,PACA_EXGEN+EX_R10(r13) + OPT_SAVE_REG_TO_PACA(PACA_EXGEN+EX_PPR, r9, CPU_FTR_HAS_PPR); mfcr r9 KVMTEST(0xc00) GET_SCRATCH0(r13) +#else + HMT_MEDIUM; #endif SYSCALL_PSERIES_1 SYSCALL_PSERIES_2_RFID @@ -1270,11 +1295,6 @@ hmi_exception_early: addi r3,r1,STACK_FRAME_OVERHEAD bl hmi_exception_realmode /* Windup the stack. */ - /* Clear MSR_RI before setting SRR0 and SRR1. */ - li r0,MSR_RI - mfmsr r9 /* get MSR value */ - andc r9,r9,r0 - mtmsrd r9,1 /* Clear MSR_RI */ /* Move original HSRR0 and HSRR1 into the respective regs */ ld r9,_MSR(r1) mtspr SPRN_HSRR1,r9 @@ -1306,23 +1326,6 @@ hmi_exception_after_realmode: EXCEPTION_PROLOG_0(PACA_EXGEN) b hmi_exception_hv -#ifdef CONFIG_PPC_POWERNV -_GLOBAL(opal_mc_secondary_handler) - HMT_MEDIUM_PPR_DISCARD - SET_SCRATCH0(r13) - GET_PACA(r13) - clrldi r3,r3,2 - tovirt(r3,r3) - std r3,PACA_OPAL_MC_EVT(r13) - ld r13,OPAL_MC_SRR0(r3) - mtspr SPRN_SRR0,r13 - ld r13,OPAL_MC_SRR1(r3) - mtspr SPRN_SRR1,r13 - ld r3,OPAL_MC_GPR3(r3) - GET_SCRATCH0(r13) - b machine_check_pSeries -#endif /* CONFIG_PPC_POWERNV */ - #define MACHINE_CHECK_HANDLER_WINDUP \ /* Clear MSR_RI before setting SRR0 and SRR1. */\ @@ -1391,6 +1394,7 @@ machine_check_handle_early: MACHINE_CHECK_HANDLER_WINDUP GET_PACA(r13) ld r1,PACAR1(r13) + li r3,PNV_THREAD_NAP b power7_enter_nap_mode 4: #endif @@ -1576,9 +1580,11 @@ do_hash_page: * r3 contains the faulting address * r4 contains the required access permissions * r5 contains the trap number + * r6 contains dsisr * * at return r3 = 0 for success, 1 for page fault, negative for error */ + ld r6,_DSISR(r1) bl hash_page /* build HPTE if possible */ cmpdi r3,0 /* see if hash_page succeeded */ |