diff options
Diffstat (limited to 'arch/powerpc/kernel/head_64.S')
| -rw-r--r-- | arch/powerpc/kernel/head_64.S | 62 |
1 files changed, 21 insertions, 41 deletions
diff --git a/arch/powerpc/kernel/head_64.S b/arch/powerpc/kernel/head_64.S index 06c7251c1bf..58bddee8e1e 100644 --- a/arch/powerpc/kernel/head_64.S +++ b/arch/powerpc/kernel/head_64.S @@ -32,13 +32,13 @@ #include <asm/cputable.h> #include <asm/setup.h> #include <asm/hvcall.h> -#include <asm/iseries/lpar_map.h> #include <asm/thread_info.h> #include <asm/firmware.h> #include <asm/page_64.h> #include <asm/irqflags.h> #include <asm/kvm_book3s_asm.h> #include <asm/ptrace.h> +#include <asm/hw_irq.h> /* The physical memory is laid out such that the secondary processor * spin code sits at 0x0000...0x00ff. On server, the vectors follow @@ -57,10 +57,6 @@ * entry in r9 for debugging purposes * 2. Secondary processors enter at 0x60 with PIR in gpr3 * - * For iSeries: - * 1. The MMU is on (as it always is for iSeries) - * 2. The kernel is entered at system_reset_iSeries - * * For Book3E processors: * 1. The MMU is on running in AS0 in a state defined in ePAPR * 2. The kernel is entered at __start @@ -93,15 +89,6 @@ __secondary_hold_spinloop: __secondary_hold_acknowledge: .llong 0x0 -#ifdef CONFIG_PPC_ISERIES - /* - * At offset 0x20, there is a pointer to iSeries LPAR data. - * This is required by the hypervisor - */ - . = 0x20 - .llong hvReleaseData-KERNELBASE -#endif /* CONFIG_PPC_ISERIES */ - #ifdef CONFIG_RELOCATABLE /* This flag is set to 1 by a loader if the kernel should run * at the loaded address instead of the linked address. This @@ -564,7 +551,8 @@ _GLOBAL(pmac_secondary_start) */ li r0,0 stb r0,PACASOFTIRQEN(r13) - stb r0,PACAHARDIRQEN(r13) + li r0,PACA_IRQ_HARD_DIS + stb r0,PACAIRQHAPPENED(r13) /* Create a temp kernel stack for use before relocation is on. */ ld r1,PACAEMERGSP(r13) @@ -582,7 +570,7 @@ _GLOBAL(pmac_secondary_start) * 1. Processor number * 2. Segment table pointer (virtual address) * On entry the following are set: - * r1 = stack pointer. vaddr for iSeries, raddr (temp stack) for pSeries + * r1 = stack pointer (real addr of temp stack) * r24 = cpu# (in Linux terms) * r13 = paca virtual address * SPRG_PACA = paca virtual address @@ -595,7 +583,7 @@ __secondary_start: /* Set thread priority to MEDIUM */ HMT_MEDIUM - /* Initialize the kernel stack. Just a repeat for iSeries. */ + /* Initialize the kernel stack */ LOAD_REG_ADDR(r3, current_set) sldi r28,r24,3 /* get current_set[cpu#] */ ldx r14,r3,r28 @@ -615,20 +603,16 @@ __secondary_start: li r7,0 mtlr r7 + /* Mark interrupts soft and hard disabled (they might be enabled + * in the PACA when doing hotplug) + */ + stb r7,PACASOFTIRQEN(r13) + li r0,PACA_IRQ_HARD_DIS + stb r0,PACAIRQHAPPENED(r13) + /* enable MMU and jump to start_secondary */ LOAD_REG_ADDR(r3, .start_secondary_prolog) LOAD_REG_IMMEDIATE(r4, MSR_KERNEL) -#ifdef CONFIG_PPC_ISERIES -BEGIN_FW_FTR_SECTION - ori r4,r4,MSR_EE - li r8,1 - stb r8,PACAHARDIRQEN(r13) -END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES) -#endif -BEGIN_FW_FTR_SECTION - stb r7,PACAHARDIRQEN(r13) -END_FW_FTR_SECTION_IFCLR(FW_FEATURE_ISERIES) - stb r7,PACASOFTIRQEN(r13) mtspr SPRN_SRR0,r3 mtspr SPRN_SRR1,r4 @@ -771,22 +755,18 @@ _INIT_GLOBAL(start_here_common) /* Load the TOC (virtual address) */ ld r2,PACATOC(r13) + /* Do more system initializations in virtual mode */ bl .setup_system - /* Load up the kernel context */ -5: - li r5,0 - stb r5,PACASOFTIRQEN(r13) /* Soft Disabled */ -#ifdef CONFIG_PPC_ISERIES -BEGIN_FW_FTR_SECTION - mfmsr r5 - ori r5,r5,MSR_EE /* Hard Enabled on iSeries*/ - mtmsrd r5 - li r5,1 -END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES) -#endif - stb r5,PACAHARDIRQEN(r13) /* Hard Disabled on others */ + /* Mark interrupts soft and hard disabled (they might be enabled + * in the PACA when doing hotplug) + */ + li r0,0 + stb r0,PACASOFTIRQEN(r13) + li r0,PACA_IRQ_HARD_DIS + stb r0,PACAIRQHAPPENED(r13) + /* Generic kernel entry */ bl .start_kernel /* Not reached */ |