diff options
Diffstat (limited to 'arch/s390/kernel/head.S')
| -rw-r--r-- | arch/s390/kernel/head.S | 101 |
1 files changed, 70 insertions, 31 deletions
diff --git a/arch/s390/kernel/head.S b/arch/s390/kernel/head.S index 805b6686b64..984726cbce1 100644 --- a/arch/s390/kernel/head.S +++ b/arch/s390/kernel/head.S @@ -52,7 +52,7 @@ __HEAD .long 0x02000370,0x60000050 # the channel program the PSW .long 0x020003c0,0x60000050 # at location 0 is loaded. .long 0x02000410,0x60000050 # Initial processing starts - .long 0x02000460,0x60000050 # at 0xf0 = iplstart. + .long 0x02000460,0x60000050 # at 0x200 = iplstart. .long 0x020004b0,0x60000050 .long 0x02000500,0x60000050 .long 0x02000550,0x60000050 @@ -62,11 +62,54 @@ __HEAD .long 0x02000690,0x60000050 .long 0x020006e0,0x20000050 - .org 0xf0 + .org 0x200 +# +# subroutine to set architecture mode +# +.Lsetmode: +#ifdef CONFIG_64BIT + mvi __LC_AR_MODE_ID,1 # set esame flag + slr %r0,%r0 # set cpuid to zero + lhi %r1,2 # mode 2 = esame (dump) + sigp %r1,%r0,0x12 # switch to esame mode + bras %r13,0f + .fill 16,4,0x0 +0: lmh %r0,%r15,0(%r13) # clear high-order half of gprs + sam31 # switch to 31 bit addressing mode +#else + mvi __LC_AR_MODE_ID,0 # set ESA flag (mode 0) +#endif + br %r14 + +# +# subroutine to wait for end I/O +# +.Lirqwait: +#ifdef CONFIG_64BIT + mvc 0x1f0(16),.Lnewpsw # set up IO interrupt psw + lpsw .Lwaitpsw +.Lioint: + br %r14 + .align 8 +.Lnewpsw: + .quad 0x0000000080000000,.Lioint +#else + mvc 0x78(8),.Lnewpsw # set up IO interrupt psw + lpsw .Lwaitpsw +.Lioint: + br %r14 + .align 8 +.Lnewpsw: + .long 0x00080000,0x80000000+.Lioint +#endif +.Lwaitpsw: + .long 0x020a0000,0x80000000+.Lioint + # # subroutine for loading cards from the reader # .Lloader: + la %r4,0(%r14) la %r3,.Lorb # r2 = address of orb into r2 la %r5,.Lirb # r4 = address of irb la %r6,.Lccws @@ -83,9 +126,7 @@ __HEAD ssch 0(%r3) # load chunk of 1600 bytes bnz .Llderr .Lwait4irq: - mvc 0x78(8),.Lnewpsw # set up IO interrupt psw - lpsw .Lwaitpsw -.Lioint: + bas %r14,.Lirqwait c %r1,0xb8 # compare subchannel number bne .Lwait4irq tsch 0(%r5) @@ -104,7 +145,7 @@ __HEAD sr %r0,%r3 # #ccws*80-residual=#bytes read ar %r2,%r0 - br %r14 # r2 contains the total size + br %r4 # r2 contains the total size .Lcont: ahi %r2,0x640 # add 0x640 to total size @@ -128,10 +169,6 @@ __HEAD .Lloadp:.long 0,0 .align 8 .Lcrash:.long 0x000a0000,0x00000000 -.Lnewpsw: - .long 0x00080000,0x80000000+.Lioint -.Lwaitpsw: - .long 0x020a0000,0x80000000+.Lioint .align 8 .Lccws: .rept 19 @@ -140,6 +177,7 @@ __HEAD .long 0x02200050,0x00000000 iplstart: + bas %r14,.Lsetmode # Immediately switch to 64 bit mode lh %r1,0xb8 # test if subchannel number bct %r1,.Lnoload # is valid l %r1,0xb8 # load ipl subchannel number @@ -209,8 +247,8 @@ iplstart: # # reset files in VM reader # - stidp __LC_SAVE_AREA_SYNC # store cpuid - tm __LC_SAVE_AREA_SYNC,0xff# running VM ? + stidp .Lcpuid # store cpuid + tm .Lcpuid,0xff # running VM ? bno .Lnoreset la %r2,.Lreset lhi %r3,26 @@ -222,23 +260,14 @@ iplstart: tm 31(%r5),0xff # bits is set in the schib bz .Lnoreset .Lwaitforirq: - mvc 0x78(8),.Lrdrnewpsw # set up IO interrupt psw -.Lwaitrdrirq: - lpsw .Lrdrwaitpsw -.Lrdrint: + bas %r14,.Lirqwait # wait for IO interrupt c %r1,0xb8 # compare subchannel number - bne .Lwaitrdrirq + bne .Lwaitforirq la %r5,.Lirb tsch 0(%r5) .Lnoreset: b .Lnoload - .align 8 -.Lrdrnewpsw: - .long 0x00080000,0x80000000+.Lrdrint -.Lrdrwaitpsw: - .long 0x020a0000,0x80000000+.Lrdrint - # # everything loaded, go for it # @@ -254,6 +283,8 @@ iplstart: .byte 0xc8,0xd6,0xd3,0xc4 # "change rdr all keep nohold" .L_eof: .long 0xc5d6c600 /* C'EOF' */ .L_hdr: .long 0xc8c4d900 /* C'HDR' */ + .align 8 +.Lcpuid:.fill 8,1,0 # # SALIPL loader support. Based on a patch by Rob van der Heij. @@ -263,6 +294,7 @@ iplstart: .org 0x800 ENTRY(start) stm %r0,%r15,0x07b0 # store registers + bas %r14,.Lsetmode # Immediately switch to 64 bit mode basr %r12,%r0 .base: l %r11,.parm @@ -343,6 +375,18 @@ ENTRY(startup) ENTRY(startup_kdump) j .Lep_startup_kdump .Lep_startup_normal: +#ifdef CONFIG_64BIT + mvi __LC_AR_MODE_ID,1 # set esame flag + slr %r0,%r0 # set cpuid to zero + lhi %r1,2 # mode 2 = esame (dump) + sigp %r1,%r0,0x12 # switch to esame mode + bras %r13,0f + .fill 16,4,0x0 +0: lmh %r0,%r15,0(%r13) # clear high-order half of gprs + sam31 # switch to 31 bit addressing mode +#else + mvi __LC_AR_MODE_ID,0 # set ESA flag (mode 0) +#endif basr %r13,0 # get base .LPG0: xc 0x200(256),0x200 # partially clear lowcore @@ -410,22 +454,17 @@ ENTRY(startup_kdump) #endif #ifdef CONFIG_64BIT - mvi __LC_AR_MODE_ID,1 # set esame flag - slr %r0,%r0 # set cpuid to zero - lhi %r1,2 # mode 2 = esame (dump) - sigp %r1,%r0,0x12 # switch to esame mode + /* Continue with 64bit startup code in head64.S */ sam64 # switch to 64 bit mode - larl %r13,4f - lmh %r0,%r15,0(%r13) # clear high-order half jg startup_continue -4: .fill 16,4,0x0 #else - mvi __LC_AR_MODE_ID,0 # set ESA flag (mode 0) + /* Continue with 31bit startup code in head31.S */ l %r13,4f-.LPG0(%r13) b 0(%r13) .align 8 4: .long startup_continue #endif + .align 8 5: .long 0x7fffffff,0xffffffff |