diff options
Diffstat (limited to 'arch/sh/boards/mach-ecovec24/setup.c')
-rw-r--r-- | arch/sh/boards/mach-ecovec24/setup.c | 38 |
1 files changed, 8 insertions, 30 deletions
diff --git a/arch/sh/boards/mach-ecovec24/setup.c b/arch/sh/boards/mach-ecovec24/setup.c index 2eaeb9e5958..701667acfd8 100644 --- a/arch/sh/boards/mach-ecovec24/setup.c +++ b/arch/sh/boards/mach-ecovec24/setup.c @@ -473,6 +473,7 @@ static struct sh_mobile_sdhi_info sdhi0_info = { .dma_slave_tx = SHDMA_SLAVE_SDHI0_TX, .dma_slave_rx = SHDMA_SLAVE_SDHI0_RX, .set_pwr = sdhi0_set_pwr, + .tmio_caps = MMC_CAP_SDIO_IRQ | MMC_CAP_POWER_OFF_CARD, }; static struct resource sdhi0_resources[] = { @@ -511,6 +512,7 @@ static void sdhi1_set_pwr(struct platform_device *pdev, int state) static struct sh_mobile_sdhi_info sdhi1_info = { .dma_slave_tx = SHDMA_SLAVE_SDHI1_TX, .dma_slave_rx = SHDMA_SLAVE_SDHI1_RX, + .tmio_caps = MMC_CAP_SDIO_IRQ | MMC_CAP_POWER_OFF_CARD, .set_pwr = sdhi1_set_pwr, }; @@ -720,32 +722,6 @@ static struct platform_device camera_devices[] = { }; /* FSI */ -/* - * FSI-B use external clock which came from da7210. - * So, we should change parent of fsi - */ -#define FCLKBCR 0xa415000c -static void fsimck_init(struct clk *clk) -{ - u32 status = __raw_readl(clk->enable_reg); - - /* use external clock */ - status &= ~0x000000ff; - status |= 0x00000080; - - __raw_writel(status, clk->enable_reg); -} - -static struct clk_ops fsimck_clk_ops = { - .init = fsimck_init, -}; - -static struct clk fsimckb_clk = { - .ops = &fsimck_clk_ops, - .enable_reg = (void __iomem *)FCLKBCR, - .rate = 0, /* unknown */ -}; - static struct sh_fsi_platform_info fsi_info = { .portb_flags = SH_FSI_BRS_INV | SH_FSI_OUT_SLAVE_MODE | @@ -1264,10 +1240,10 @@ static int __init arch_setup(void) /* change parent of FSI B */ clk = clk_get(NULL, "fsib_clk"); if (!IS_ERR(clk)) { - clk_register(&fsimckb_clk); - clk_set_parent(clk, &fsimckb_clk); - clk_set_rate(clk, 11000); - clk_set_rate(&fsimckb_clk, 11000); + /* 48kHz dummy clock was used to make sure 1/1 divide */ + clk_set_rate(&sh7724_fsimckb_clk, 48000); + clk_set_parent(clk, &sh7724_fsimckb_clk); + clk_set_rate(clk, 48000); clk_put(clk); } @@ -1318,6 +1294,7 @@ static int __init arch_setup(void) i2c_register_board_info(1, i2c1_devices, ARRAY_SIZE(i2c1_devices)); +#if defined(CONFIG_VIDEO_SH_VOU) || defined(CONFIG_VIDEO_SH_VOU_MODULE) /* VOU */ gpio_request(GPIO_FN_DV_D15, NULL); gpio_request(GPIO_FN_DV_D14, NULL); @@ -1349,6 +1326,7 @@ static int __init arch_setup(void) /* Remove reset */ gpio_set_value(GPIO_PTG4, 1); +#endif return platform_add_devices(ecovec_devices, ARRAY_SIZE(ecovec_devices)); |