diff options
Diffstat (limited to 'arch/sparc/Kconfig')
-rw-r--r-- | arch/sparc/Kconfig | 64 |
1 files changed, 8 insertions, 56 deletions
diff --git a/arch/sparc/Kconfig b/arch/sparc/Kconfig index aba05394d30..3cfb8be3ff6 100644 --- a/arch/sparc/Kconfig +++ b/arch/sparc/Kconfig @@ -25,62 +25,6 @@ source "init/Kconfig" menu "General machine setup" -config VT - bool - select INPUT - default y - ---help--- - If you say Y here, you will get support for terminal devices with - display and keyboard devices. These are called "virtual" because you - can run several virtual terminals (also called virtual consoles) on - one physical terminal. This is rather useful, for example one - virtual terminal can collect system messages and warnings, another - one can be used for a text-mode user session, and a third could run - an X session, all in parallel. Switching between virtual terminals - is done with certain key combinations, usually Alt-<function key>. - - The setterm command ("man setterm") can be used to change the - properties (such as colors or beeping) of a virtual terminal. The - man page console_codes(4) ("man console_codes") contains the special - character sequences that can be used to change those properties - directly. The fonts used on virtual terminals can be changed with - the setfont ("man setfont") command and the key bindings are defined - with the loadkeys ("man loadkeys") command. - - You need at least one virtual terminal device in order to make use - of your keyboard and monitor. Therefore, only people configuring an - embedded system would want to say N here in order to save some - memory; the only way to log into such a system is then via a serial - or network connection. - - If unsure, say Y, or else you won't be able to do much with your new - shiny Linux system :-) - -config VT_CONSOLE - bool - default y - ---help--- - The system console is the device which receives all kernel messages - and warnings and which allows logins in single user mode. If you - answer Y here, a virtual terminal (the device used to interact with - a physical terminal) can be used as system console. This is the most - common mode of operations, so you should say Y here unless you want - the kernel messages be output only to a serial port (in which case - you should say Y to "Console on serial port", below). - - If you do say Y here, by default the currently visible virtual - terminal (/dev/tty0) will be used as system console. You can change - that with a kernel command line option such as "console=tty3" which - would use the third virtual terminal as system console. (Try "man - bootparam" or see the documentation of your boot loader (lilo or - loadlin) about how to pass options to the kernel at boot time.) - - If unsure, say Y. - -config HW_CONSOLE - bool - default y - config SMP bool "Symmetric multi-processing support (does not work on sun4/sun4c)" depends on BROKEN @@ -257,6 +201,14 @@ config SUN_OPENPROMFS Only choose N if you know in advance that you will not need to modify OpenPROM settings on the running system. +config SPARC_LED + tristate "Sun4m LED driver" + help + This driver toggles the front-panel LED on sun4m systems + in a user-specifyable manner. It's state can be probed + by reading /proc/led and it's blinking mode can be changed + via writes to /proc/led + source "fs/Kconfig.binfmt" config SUNOS_EMUL |