diff options
Diffstat (limited to 'drivers/ata/pata_optidma.c')
| -rw-r--r-- | drivers/ata/pata_optidma.c | 58 |
1 files changed, 33 insertions, 25 deletions
diff --git a/drivers/ata/pata_optidma.c b/drivers/ata/pata_optidma.c index d80b36e209c..b70e04c144d 100644 --- a/drivers/ata/pata_optidma.c +++ b/drivers/ata/pata_optidma.c @@ -33,7 +33,7 @@ #include <linux/libata.h> #define DRV_NAME "pata_optidma" -#define DRV_VERSION "0.2.3" +#define DRV_VERSION "0.3.2" enum { READ_REG = 0, /* index of Read cycle timing register */ @@ -62,7 +62,6 @@ static int optidma_pre_reset(struct ata_port *ap) if (ap->port_no && !pci_test_config_bits(pdev, &optidma_enable_bits)) return -ENOENT; - ap->cbl = ATA_CBL_PATA40; return ata_std_prereset(ap); } @@ -115,7 +114,7 @@ static void optidma_lock(struct ata_port *ap) } /** - * optidma_set_mode - set mode data + * optidma_mode_setup - set mode data * @ap: ATA interface * @adev: ATA device * @mode: Mode to set @@ -128,7 +127,7 @@ static void optidma_lock(struct ata_port *ap) * IRQ here we depend on the host set locking to avoid catastrophe. */ -static void optidma_set_mode(struct ata_port *ap, struct ata_device *adev, u8 mode) +static void optidma_mode_setup(struct ata_port *ap, struct ata_device *adev, u8 mode) { struct ata_device *pair = ata_dev_pair(adev); int pio = adev->pio_mode - XFER_PIO_0; @@ -202,7 +201,7 @@ static void optidma_set_mode(struct ata_port *ap, struct ata_device *adev, u8 mo } /** - * optiplus_set_mode - DMA setup for Firestar Plus + * optiplus_mode_setup - DMA setup for Firestar Plus * @ap: ATA port * @adev: device * @mode: desired mode @@ -213,7 +212,7 @@ static void optidma_set_mode(struct ata_port *ap, struct ata_device *adev, u8 mo * one */ -static void optiplus_set_mode(struct ata_port *ap, struct ata_device *adev, u8 mode) +static void optiplus_mode_setup(struct ata_port *ap, struct ata_device *adev, u8 mode) { struct pci_dev *pdev = to_pci_dev(ap->host->dev); u8 udcfg; @@ -225,7 +224,7 @@ static void optiplus_set_mode(struct ata_port *ap, struct ata_device *adev, u8 m pci_read_config_byte(pdev, 0x44, &udcfg); if (mode <= XFER_UDMA_0) { udcfg &= ~(1 << unit); - optidma_set_mode(ap, adev, adev->dma_mode); + optidma_mode_setup(ap, adev, adev->dma_mode); } else { udcfg |= (1 << unit); if (ap->port_no) { @@ -253,7 +252,7 @@ static void optiplus_set_mode(struct ata_port *ap, struct ata_device *adev, u8 m static void optidma_set_pio_mode(struct ata_port *ap, struct ata_device *adev) { - optidma_set_mode(ap, adev, adev->pio_mode); + optidma_mode_setup(ap, adev, adev->pio_mode); } /** @@ -268,7 +267,7 @@ static void optidma_set_pio_mode(struct ata_port *ap, struct ata_device *adev) static void optidma_set_dma_mode(struct ata_port *ap, struct ata_device *adev) { - optidma_set_mode(ap, adev, adev->dma_mode); + optidma_mode_setup(ap, adev, adev->dma_mode); } /** @@ -283,7 +282,7 @@ static void optidma_set_dma_mode(struct ata_port *ap, struct ata_device *adev) static void optiplus_set_pio_mode(struct ata_port *ap, struct ata_device *adev) { - optiplus_set_mode(ap, adev, adev->pio_mode); + optiplus_mode_setup(ap, adev, adev->pio_mode); } /** @@ -298,7 +297,7 @@ static void optiplus_set_pio_mode(struct ata_port *ap, struct ata_device *adev) static void optiplus_set_dma_mode(struct ata_port *ap, struct ata_device *adev) { - optiplus_set_mode(ap, adev, adev->dma_mode); + optiplus_mode_setup(ap, adev, adev->dma_mode); } /** @@ -322,26 +321,29 @@ static u8 optidma_make_bits43(struct ata_device *adev) } /** - * optidma_post_set_mode - finalize PCI setup + * optidma_set_mode - mode setup * @ap: port to set up * - * Finalise the configuration by writing the nibble of extra bits - * of data into the chip. + * Use the standard setup to tune the chipset and then finalise the + * configuration by writing the nibble of extra bits of data into + * the chip. */ -static void optidma_post_set_mode(struct ata_port *ap) +static int optidma_set_mode(struct ata_port *ap, struct ata_device **r_failed) { u8 r; int nybble = 4 * ap->port_no; struct pci_dev *pdev = to_pci_dev(ap->host->dev); - - pci_read_config_byte(pdev, 0x43, &r); - - r &= (0x0F << nybble); - r |= (optidma_make_bits43(&ap->device[0]) + - (optidma_make_bits43(&ap->device[0]) << 2)) << nybble; - - pci_write_config_byte(pdev, 0x43, r); + int rc = ata_do_set_mode(ap, r_failed); + if (rc == 0) { + pci_read_config_byte(pdev, 0x43, &r); + + r &= (0x0F << nybble); + r |= (optidma_make_bits43(&ap->device[0]) + + (optidma_make_bits43(&ap->device[0]) << 2)) << nybble; + pci_write_config_byte(pdev, 0x43, r); + } + return rc; } static struct scsi_host_template optidma_sht = { @@ -360,8 +362,10 @@ static struct scsi_host_template optidma_sht = { .slave_configure = ata_scsi_slave_config, .slave_destroy = ata_scsi_slave_destroy, .bios_param = ata_std_bios_param, +#ifdef CONFIG_PM .resume = ata_scsi_device_resume, .suspend = ata_scsi_device_suspend, +#endif }; static struct ata_port_operations optidma_port_ops = { @@ -379,7 +383,8 @@ static struct ata_port_operations optidma_port_ops = { .thaw = ata_bmdma_thaw, .post_internal_cmd = ata_bmdma_post_internal_cmd, .error_handler = optidma_error_handler, - .post_set_mode = optidma_post_set_mode, + .set_mode = optidma_set_mode, + .cable_detect = ata_cable_40wire, .bmdma_setup = ata_bmdma_setup, .bmdma_start = ata_bmdma_start, @@ -414,7 +419,8 @@ static struct ata_port_operations optiplus_port_ops = { .thaw = ata_bmdma_thaw, .post_internal_cmd = ata_bmdma_post_internal_cmd, .error_handler = optidma_error_handler, - .post_set_mode = optidma_post_set_mode, + .set_mode = optidma_set_mode, + .cable_detect = ata_cable_40wire, .bmdma_setup = ata_bmdma_setup, .bmdma_start = ata_bmdma_start, @@ -524,8 +530,10 @@ static struct pci_driver optidma_pci_driver = { .id_table = optidma, .probe = optidma_init_one, .remove = ata_pci_remove_one, +#ifdef CONFIG_PM .suspend = ata_pci_device_suspend, .resume = ata_pci_device_resume, +#endif }; static int __init optidma_init(void) |