diff options
Diffstat (limited to 'drivers/block/Kconfig')
| -rw-r--r-- | drivers/block/Kconfig | 44 |
1 files changed, 7 insertions, 37 deletions
diff --git a/drivers/block/Kconfig b/drivers/block/Kconfig index b4c8319138b..6e23af1ecbd 100644 --- a/drivers/block/Kconfig +++ b/drivers/block/Kconfig @@ -2,9 +2,12 @@ # Block device driver configuration # -if BLOCK +menuconfig BLK_DEV + bool "Block devices" + depends on BLOCK + default y -menu "Block devices" +if BLK_DEV config BLK_DEV_FD tristate "Normal floppy disk support" @@ -56,40 +59,9 @@ config AMIGA_Z2RAM To compile this driver as a module, choose M here: the module will be called z2ram. -config ATARI_ACSI - tristate "Atari ACSI support" - depends on ATARI && BROKEN - ---help--- - This enables support for the Atari ACSI interface. The driver - supports hard disks and CD-ROMs, which have 512-byte sectors, or can - be switched to that mode. Due to the ACSI command format, only disks - up to 1 GB are supported. Special support for certain ACSI to SCSI - adapters, which could relax that, isn't included yet. The ACSI - driver is also the basis for certain other drivers for devices - attached to the ACSI bus: Atari SLM laser printer, BioNet-100 - Ethernet, and PAMsNet Ethernet. If you want to use one of these - devices, you need ACSI support, too. - - To compile this driver as a module, choose M here: the - module will be called acsi. - -comment "Some devices (e.g. CD jukebox) support multiple LUNs" - depends on ATARI && ATARI_ACSI - -config ACSI_MULTI_LUN - bool "Probe all LUNs on each ACSI device" - depends on ATARI_ACSI - help - If you have a ACSI device that supports more than one LUN (Logical - Unit Number), e.g. a CD jukebox, you should say Y here so that all - will be found by the ACSI driver. An ACSI device with multiple LUNs - acts logically like multiple ACSI devices. The vast majority of ACSI - devices have only one LUN, and so most people can say N here and - should in fact do so, because it is safer. - config ATARI_SLM tristate "Atari SLM laser printer support" - depends on ATARI && ATARI_ACSI!=n + depends on ATARI help If you have an Atari SLM laser printer, say Y to include support for it in the kernel. Otherwise, say N. This driver is also available as @@ -453,6 +425,4 @@ config ATA_OVER_ETH source "drivers/s390/block/Kconfig" -endmenu - -endif +endif # BLK_DEV |