diff options
Diffstat (limited to 'drivers/gpio/Kconfig')
| -rw-r--r-- | drivers/gpio/Kconfig | 12 |
1 files changed, 10 insertions, 2 deletions
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index b46442d7d66..d3b29530554 100644 --- a/drivers/gpio/Kconfig +++ b/drivers/gpio/Kconfig @@ -100,18 +100,21 @@ config GPIO_VR41XX Say yes here to support the NEC VR4100 series General-purpose I/O Uint config GPIO_SCH - tristate "Intel SCH GPIO" + tristate "Intel SCH/TunnelCreek GPIO" depends on GPIOLIB && PCI && X86 select MFD_CORE select LPC_SCH help - Say yes here to support GPIO interface on Intel Poulsbo SCH. + Say yes here to support GPIO interface on Intel Poulsbo SCH + or Intel Tunnel Creek processor. The Intel SCH contains a total of 14 GPIO pins. Ten GPIOs are powered by the core power rail and are turned off during sleep modes (S3 and higher). The remaining four GPIOs are powered by the Intel SCH suspend power supply. These GPIOs remain active during S3. The suspend powered GPIOs can be used to wake the system from the Suspend-to-RAM state. + The Intel Tunnel Creek processor has 5 GPIOs powered by the + core power rail and 9 from suspend power supply. This driver can also be built as a module. If so, the module will be called sch-gpio. @@ -411,4 +414,9 @@ config GPIO_JANZ_TTL This driver provides support for driving the pins in output mode only. Input mode is not supported. +config AB8500_GPIO + bool "ST-Ericsson AB8500 Mixed Signal Circuit gpio functions" + depends on AB8500_CORE && BROKEN + help + Select this to enable the AB8500 IC GPIO driver endif |