diff options
Diffstat (limited to 'drivers/i2c/busses/i2c-i801.c')
| -rw-r--r-- | drivers/i2c/busses/i2c-i801.c | 57 |
1 files changed, 48 insertions, 9 deletions
diff --git a/drivers/i2c/busses/i2c-i801.c b/drivers/i2c/busses/i2c-i801.c index 6ab4f1cb21f..8fafb254e42 100644 --- a/drivers/i2c/busses/i2c-i801.c +++ b/drivers/i2c/busses/i2c-i801.c @@ -2,7 +2,7 @@ Copyright (c) 1998 - 2002 Frodo Looijaard <frodol@dds.nl>, Philip Edelbrock <phil@netroedge.com>, and Mark D. Studebaker <mdsxyz123@yahoo.com> - Copyright (C) 2007 - 2012 Jean Delvare <jdelvare@suse.de> + Copyright (C) 2007 - 2014 Jean Delvare <jdelvare@suse.de> Copyright (C) 2010 Intel Corporation, David Woodhouse <dwmw2@infradead.org> @@ -59,6 +59,7 @@ * Wildcat Point-LP (PCH) 0x9ca2 32 hard yes yes yes * BayTrail (SOC) 0x0f12 32 hard yes yes yes * Sunrise Point-H (PCH) 0xa123 32 hard yes yes yes + * Sunrise Point-LP (PCH) 0x9d23 32 hard yes yes yes * * Features supported by this driver: * Software PEC no @@ -109,12 +110,16 @@ /* PCI Address Constants */ #define SMBBAR 4 +#define SMBPCICTL 0x004 #define SMBPCISTS 0x006 #define SMBHSTCFG 0x040 /* Host status bits for SMBPCISTS */ #define SMBPCISTS_INTS 0x08 +/* Control bits for SMBPCICTL */ +#define SMBPCICTL_INTDIS 0x0400 + /* Host configuration bits for SMBHSTCFG */ #define SMBHSTCFG_HST_EN 1 #define SMBHSTCFG_SMB_SMI_EN 2 @@ -182,6 +187,7 @@ #define PCI_DEVICE_ID_INTEL_LYNXPOINT_LP_SMBUS 0x9c22 #define PCI_DEVICE_ID_INTEL_WILDCATPOINT_LP_SMBUS 0x9ca2 #define PCI_DEVICE_ID_INTEL_SUNRISEPOINT_H_SMBUS 0xa123 +#define PCI_DEVICE_ID_INTEL_SUNRISEPOINT_LP_SMBUS 0x9d23 struct i801_mux_config { char *gpio_chip; @@ -371,6 +377,7 @@ static int i801_transaction(struct i801_priv *priv, int xact) { int status; int result; + const struct i2c_adapter *adap = &priv->adapter; result = i801_check_pre(priv); if (result < 0) @@ -379,7 +386,14 @@ static int i801_transaction(struct i801_priv *priv, int xact) if (priv->features & FEATURE_IRQ) { outb_p(xact | SMBHSTCNT_INTREN | SMBHSTCNT_START, SMBHSTCNT(priv)); - wait_event(priv->waitq, (status = priv->status)); + result = wait_event_timeout(priv->waitq, + (status = priv->status), + adap->timeout); + if (!result) { + status = -ETIMEDOUT; + dev_warn(&priv->pci_dev->dev, + "Timeout waiting for interrupt!\n"); + } priv->status = 0; return i801_check_post(priv, status); } @@ -493,9 +507,6 @@ static irqreturn_t i801_isr(int irq, void *dev_id) return IRQ_NONE; status = inb_p(SMBHSTSTS(priv)); - if (status != 0x42) - dev_dbg(&priv->pci_dev->dev, "irq: status = %02x\n", status); - if (status & SMBHSTSTS_BYTE_DONE) i801_isr_byte_done(priv); @@ -527,6 +538,7 @@ static int i801_block_transaction_byte_by_byte(struct i801_priv *priv, int smbcmd; int status; int result; + const struct i2c_adapter *adap = &priv->adapter; result = i801_check_pre(priv); if (result < 0) @@ -555,7 +567,14 @@ static int i801_block_transaction_byte_by_byte(struct i801_priv *priv, priv->data = &data->block[1]; outb_p(priv->cmd | SMBHSTCNT_START, SMBHSTCNT(priv)); - wait_event(priv->waitq, (status = priv->status)); + result = wait_event_timeout(priv->waitq, + (status = priv->status), + adap->timeout); + if (!result) { + status = -ETIMEDOUT; + dev_warn(&priv->pci_dev->dev, + "Timeout waiting for interrupt!\n"); + } priv->status = 0; return i801_check_post(priv, status); } @@ -829,6 +848,7 @@ static const struct pci_device_id i801_ids[] = { { PCI_DEVICE(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_BAYTRAIL_SMBUS) }, { PCI_DEVICE(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_BRASWELL_SMBUS) }, { PCI_DEVICE(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_SUNRISEPOINT_H_SMBUS) }, + { PCI_DEVICE(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_SUNRISEPOINT_LP_SMBUS) }, { 0, } }; @@ -1212,6 +1232,25 @@ static int i801_probe(struct pci_dev *dev, const struct pci_device_id *id) outb_p(inb_p(SMBAUXCTL(priv)) & ~(SMBAUXCTL_CRC | SMBAUXCTL_E32B), SMBAUXCTL(priv)); + /* Default timeout in interrupt mode: 200 ms */ + priv->adapter.timeout = HZ / 5; + + if (priv->features & FEATURE_IRQ) { + u16 pcictl, pcists; + + /* Complain if an interrupt is already pending */ + pci_read_config_word(priv->pci_dev, SMBPCISTS, &pcists); + if (pcists & SMBPCISTS_INTS) + dev_warn(&dev->dev, "An interrupt is pending!\n"); + + /* Check if interrupts have been disabled */ + pci_read_config_word(priv->pci_dev, SMBPCICTL, &pcictl); + if (pcictl & SMBPCICTL_INTDIS) { + dev_info(&dev->dev, "Interrupts are disabled\n"); + priv->features &= ~FEATURE_IRQ; + } + } + if (priv->features & FEATURE_IRQ) { init_waitqueue_head(&priv->waitq); @@ -1220,10 +1259,11 @@ static int i801_probe(struct pci_dev *dev, const struct pci_device_id *id) if (err) { dev_err(&dev->dev, "Failed to allocate irq %d: %d\n", dev->irq, err); - goto exit_release; + priv->features &= ~FEATURE_IRQ; } - dev_info(&dev->dev, "SMBus using PCI Interrupt\n"); } + dev_info(&dev->dev, "SMBus using %s\n", + priv->features & FEATURE_IRQ ? "PCI interrupt" : "polling"); /* set up the sysfs linkage to our parent device */ priv->adapter.dev.parent = &dev->dev; @@ -1250,7 +1290,6 @@ static int i801_probe(struct pci_dev *dev, const struct pci_device_id *id) exit_free_irq: if (priv->features & FEATURE_IRQ) free_irq(dev->irq, priv); -exit_release: pci_release_region(dev, SMBBAR); exit: kfree(priv); |