diff options
Diffstat (limited to 'drivers/ide/icside.c')
| -rw-r--r-- | drivers/ide/icside.c | 67 |
1 files changed, 62 insertions, 5 deletions
diff --git a/drivers/ide/icside.c b/drivers/ide/icside.c index 0f67f1abbbd..4a697a238e2 100644 --- a/drivers/ide/icside.c +++ b/drivers/ide/icside.c @@ -65,6 +65,8 @@ static struct cardinfo icside_cardinfo_v6_2 = { }; struct icside_state { + unsigned int channel; + unsigned int enabled; void __iomem *irq_port; void __iomem *ioc_base; unsigned int sel; @@ -114,11 +116,18 @@ static void icside_irqenable_arcin_v6 (struct expansion_card *ec, int irqnr) struct icside_state *state = ec->irq_data; void __iomem *base = state->irq_port; - writeb(0, base + ICS_ARCIN_V6_INTROFFSET_1); - readb(base + ICS_ARCIN_V6_INTROFFSET_2); + state->enabled = 1; - writeb(0, base + ICS_ARCIN_V6_INTROFFSET_2); - readb(base + ICS_ARCIN_V6_INTROFFSET_1); + switch (state->channel) { + case 0: + writeb(0, base + ICS_ARCIN_V6_INTROFFSET_1); + readb(base + ICS_ARCIN_V6_INTROFFSET_2); + break; + case 1: + writeb(0, base + ICS_ARCIN_V6_INTROFFSET_2); + readb(base + ICS_ARCIN_V6_INTROFFSET_1); + break; + } } /* Prototype: icside_irqdisable_arcin_v6 (struct expansion_card *ec, int irqnr) @@ -128,6 +137,8 @@ static void icside_irqdisable_arcin_v6 (struct expansion_card *ec, int irqnr) { struct icside_state *state = ec->irq_data; + state->enabled = 0; + readb(state->irq_port + ICS_ARCIN_V6_INTROFFSET_1); readb(state->irq_port + ICS_ARCIN_V6_INTROFFSET_2); } @@ -149,6 +160,44 @@ static const expansioncard_ops_t icside_ops_arcin_v6 = { .irqpending = icside_irqpending_arcin_v6, }; +/* + * Handle routing of interrupts. This is called before + * we write the command to the drive. + */ +static void icside_maskproc(ide_drive_t *drive, int mask) +{ + ide_hwif_t *hwif = drive->hwif; + struct expansion_card *ec = ECARD_DEV(hwif->dev); + struct icside_state *state = ecard_get_drvdata(ec); + unsigned long flags; + + local_irq_save(flags); + + state->channel = hwif->channel; + + if (state->enabled && !mask) { + switch (hwif->channel) { + case 0: + writeb(0, state->irq_port + ICS_ARCIN_V6_INTROFFSET_1); + readb(state->irq_port + ICS_ARCIN_V6_INTROFFSET_2); + break; + case 1: + writeb(0, state->irq_port + ICS_ARCIN_V6_INTROFFSET_2); + readb(state->irq_port + ICS_ARCIN_V6_INTROFFSET_1); + break; + } + } else { + readb(state->irq_port + ICS_ARCIN_V6_INTROFFSET_2); + readb(state->irq_port + ICS_ARCIN_V6_INTROFFSET_1); + } + + local_irq_restore(flags); +} + +static const struct ide_port_ops icside_v6_no_dma_port_ops = { + .maskproc = icside_maskproc, +}; + #ifdef CONFIG_BLK_DEV_IDEDMA_ICS /* * SG-DMA support. @@ -185,10 +234,11 @@ static const expansioncard_ops_t icside_ops_arcin_v6 = { * MW1 80 50 50 150 C * MW2 70 25 25 120 C */ -static void icside_set_dma_mode(ide_drive_t *drive, const u8 xfer_mode) +static void icside_set_dma_mode(ide_hwif_t *hwif, ide_drive_t *drive) { unsigned long cycle_time; int use_dma_info = 0; + const u8 xfer_mode = drive->dma_mode; switch (xfer_mode) { case XFER_MW_DMA_2: @@ -228,6 +278,7 @@ static void icside_set_dma_mode(ide_drive_t *drive, const u8 xfer_mode) static const struct ide_port_ops icside_v6_port_ops = { .set_dma_mode = icside_set_dma_mode, + .maskproc = icside_maskproc, }; static void icside_dma_host_set(ide_drive_t *drive, int on) @@ -272,6 +323,11 @@ static int icside_dma_setup(ide_drive_t *drive, struct ide_cmd *cmd) BUG_ON(dma_channel_active(ec->dma)); /* + * Ensure that we have the right interrupt routed. + */ + icside_maskproc(drive, 0); + + /* * Route the DMA signals to the correct interface. */ writeb(state->sel | hwif->channel, state->ioc_base); @@ -399,6 +455,7 @@ err_free: static const struct ide_port_info icside_v6_port_info __initdata = { .init_dma = icside_dma_off_init, + .port_ops = &icside_v6_no_dma_port_ops, .dma_ops = &icside_v6_dma_ops, .host_flags = IDE_HFLAG_SERIALIZE | IDE_HFLAG_MMIO, .mwdma_mask = ATA_MWDMA2, |