diff options
Diffstat (limited to 'drivers/ide/palm_bk3710.c')
-rw-r--r-- | drivers/ide/palm_bk3710.c | 93 |
1 files changed, 30 insertions, 63 deletions
diff --git a/drivers/ide/palm_bk3710.c b/drivers/ide/palm_bk3710.c index c7acca0b873..09d813d313f 100644 --- a/drivers/ide/palm_bk3710.c +++ b/drivers/ide/palm_bk3710.c @@ -39,27 +39,12 @@ /* Primary Control Offset */ #define IDE_PALM_ATA_PRI_CTL_OFFSET 0x3F6 -/* - * PalmChip 3710 IDE Controller UDMA timing structure Definition - */ -struct palm_bk3710_udmatiming { - unsigned int rptime; /* Ready to pause time */ - unsigned int cycletime; /* Cycle Time */ -}; - #define BK3710_BMICP 0x00 #define BK3710_BMISP 0x02 #define BK3710_BMIDTP 0x04 -#define BK3710_BMICS 0x08 -#define BK3710_BMISS 0x0A -#define BK3710_BMIDTS 0x0C #define BK3710_IDETIMP 0x40 -#define BK3710_IDETIMS 0x42 -#define BK3710_SIDETIM 0x44 -#define BK3710_SLEWCTL 0x45 #define BK3710_IDESTATUS 0x47 #define BK3710_UDMACTL 0x48 -#define BK3710_UDMATIM 0x4A #define BK3710_MISCCTL 0x50 #define BK3710_REGSTB 0x54 #define BK3710_REGRCVR 0x58 @@ -71,17 +56,22 @@ struct palm_bk3710_udmatiming { #define BK3710_UDMATRP 0x70 #define BK3710_UDMAENV 0x74 #define BK3710_IORDYTMP 0x78 -#define BK3710_IORDYTMS 0x7C static unsigned ideclk_period; /* in nanoseconds */ +struct palm_bk3710_udmatiming { + unsigned int rptime; /* tRP -- Ready to pause time (nsec) */ + unsigned int cycletime; /* tCYCTYP2/2 -- avg Cycle Time (nsec) */ + /* tENV is always a minimum of 20 nsec */ +}; + static const struct palm_bk3710_udmatiming palm_bk3710_udmatimings[6] = { - {160, 240}, /* UDMA Mode 0 */ - {125, 160}, /* UDMA Mode 1 */ - {100, 120}, /* UDMA Mode 2 */ - {100, 90}, /* UDMA Mode 3 */ - {100, 60}, /* UDMA Mode 4 */ - {85, 40}, /* UDMA Mode 5 */ + { 160, 240 / 2 }, /* UDMA Mode 0 */ + { 125, 160 / 2 }, /* UDMA Mode 1 */ + { 100, 120 / 2 }, /* UDMA Mode 2 */ + { 100, 90 / 2 }, /* UDMA Mode 3 */ + { 100, 60 / 2 }, /* UDMA Mode 4 */ + { 85, 40 / 2 }, /* UDMA Mode 5 */ }; static void palm_bk3710_setudmamode(void __iomem *base, unsigned int dev, @@ -98,11 +88,6 @@ static void palm_bk3710_setudmamode(void __iomem *base, unsigned int dev, trp = DIV_ROUND_UP(palm_bk3710_udmatimings[mode].rptime, ideclk_period) - 1; - /* udmatim Register */ - val16 = readw(base + BK3710_UDMATIM) & (dev ? 0xFF0F : 0xFFF0); - val16 |= (mode << (dev ? 4 : 0)); - writew(val16, base + BK3710_UDMATIM); - /* udmastb Ultra DMA Access Strobe Width */ val32 = readl(base + BK3710_UDMASTB) & (0xFF << (dev ? 0 : 8)); val32 |= (t0 << (dev ? 8 : 0)); @@ -163,10 +148,11 @@ static void palm_bk3710_setpiomode(void __iomem *base, ide_drive_t *mate, u32 val32; struct ide_timing *t; + t = ide_timing_find_mode(XFER_PIO_0 + mode); + /* PIO Data Setup */ t0 = DIV_ROUND_UP(cycletime, ideclk_period); - t2 = DIV_ROUND_UP(ide_timing_find_mode(XFER_PIO_0 + mode)->active, - ideclk_period); + t2 = DIV_ROUND_UP(t->active, ideclk_period); t2i = t0 - t2 - 1; t2 -= 1; @@ -187,7 +173,6 @@ static void palm_bk3710_setpiomode(void __iomem *base, ide_drive_t *mate, } /* TASKFILE Setup */ - t = ide_timing_find_mode(XFER_PIO_0 + mode); t0 = DIV_ROUND_UP(t->cyc8b, ideclk_period); t2 = DIV_ROUND_UP(t->act8b, ideclk_period); @@ -236,42 +221,23 @@ static void palm_bk3710_set_pio_mode(ide_drive_t *drive, u8 pio) static void __devinit palm_bk3710_chipinit(void __iomem *base) { /* - * enable the reset_en of ATA controller so that when ata signals - * are brought out, by writing into device config. at that - * time por_n signal should not be 'Z' and have a stable value. + * REVISIT: the ATA reset signal needs to be managed through a + * GPIO, which means it should come from platform_data. Until + * we get and use such information, we have to trust that things + * have been reset before we get here. */ - writel(0x0300, base + BK3710_MISCCTL); - - /* wait for some time and deassert the reset of ATA Device. */ - mdelay(100); - - /* Deassert the Reset */ - writel(0x0200, base + BK3710_MISCCTL); /* * Program the IDETIMP Register Value based on the following assumptions * * (ATA_IDETIMP_IDEEN , ENABLE ) | - * (ATA_IDETIMP_SLVTIMEN , DISABLE) | - * (ATA_IDETIMP_RDYSMPL , 70NS) | - * (ATA_IDETIMP_RDYRCVRY , 50NS) | - * (ATA_IDETIMP_DMAFTIM1 , PIOCOMP) | * (ATA_IDETIMP_PREPOST1 , DISABLE) | - * (ATA_IDETIMP_RDYSEN1 , DISABLE) | - * (ATA_IDETIMP_PIOFTIM1 , DISABLE) | - * (ATA_IDETIMP_DMAFTIM0 , PIOCOMP) | * (ATA_IDETIMP_PREPOST0 , DISABLE) | - * (ATA_IDETIMP_RDYSEN0 , DISABLE) | - * (ATA_IDETIMP_PIOFTIM0 , DISABLE) - */ - writew(0xB388, base + BK3710_IDETIMP); - - /* - * Configure SIDETIM Register - * (ATA_SIDETIM_RDYSMPS1 ,120NS ) | - * (ATA_SIDETIM_RDYRCYS1 ,120NS ) + * + * DM6446 silicon rev 2.1 and earlier have no observed net benefit + * from enabling prefetch/postwrite. */ - writeb(0, base + BK3710_SIDETIM); + writew(BIT(15), base + BK3710_IDETIMP); /* * UDMACTL Ultra-ATA DMA Control @@ -283,11 +249,11 @@ static void __devinit palm_bk3710_chipinit(void __iomem *base) /* * MISCCTL Miscellaneous Conrol Register - * (ATA_MISCCTL_RSTMODEP , 1) | - * (ATA_MISCCTL_RESETP , 0) | + * (ATA_MISCCTL_HWNHLD1P , 1 cycle) + * (ATA_MISCCTL_HWNHLD0P , 1 cycle) * (ATA_MISCCTL_TIMORIDE , 1) */ - writel(0x201, base + BK3710_MISCCTL); + writel(0x001, base + BK3710_MISCCTL); /* * IORDYTMP IORDY Timer for Primary Register @@ -357,10 +323,9 @@ static int __init palm_bk3710_probe(struct platform_device *pdev) clk_enable(clk); rate = clk_get_rate(clk); - ideclk_period = 1000000000UL / rate; - /* Register the IDE interface with Linux ATA Interface */ - memset(&hw, 0, sizeof(hw)); + /* NOTE: round *down* to meet minimum timings; we count in clocks */ + ideclk_period = 1000000000UL / rate; mem = platform_get_resource(pdev, IORESOURCE_MEM, 0); if (mem == NULL) { @@ -390,6 +355,7 @@ static int __init palm_bk3710_probe(struct platform_device *pdev) /* Configure the Palm Chip controller */ palm_bk3710_chipinit(base); + memset(&hw, 0, sizeof(hw)); for (i = 0; i < IDE_NR_PORTS - 2; i++) hw.io_ports_array[i] = (unsigned long) (base + IDE_PALM_ATA_PRI_REG_OFFSET + i); @@ -402,6 +368,7 @@ static int __init palm_bk3710_probe(struct platform_device *pdev) palm_bk3710_port_info.udma_mask = rate < 100000000 ? ATA_UDMA4 : ATA_UDMA5; + /* Register the IDE interface with Linux */ rc = ide_host_add(&palm_bk3710_port_info, hws, NULL); if (rc) goto out; |