diff options
Diffstat (limited to 'drivers/infiniband/hw/ipath/ipath_iba6120.c')
| -rw-r--r-- | drivers/infiniband/hw/ipath/ipath_iba6120.c | 163 |
1 files changed, 154 insertions, 9 deletions
diff --git a/drivers/infiniband/hw/ipath/ipath_iba6120.c b/drivers/infiniband/hw/ipath/ipath_iba6120.c index 57915fd718e..597192e912d 100644 --- a/drivers/infiniband/hw/ipath/ipath_iba6120.c +++ b/drivers/infiniband/hw/ipath/ipath_iba6120.c @@ -329,6 +329,9 @@ static const struct ipath_cregs ipath_pe_cregs = { #define INFINIPATH_HWE_PCIE0PLLFAILED 0x0800000000000000ULL #define INFINIPATH_HWE_SERDESPLLFAILED 0x1000000000000000ULL +#define IBA6120_IBCS_LINKTRAININGSTATE_MASK 0xf +#define IBA6120_IBCS_LINKSTATE_SHIFT 4 + /* kr_extstatus bits */ #define INFINIPATH_EXTS_FREQSEL 0x2 #define INFINIPATH_EXTS_SERDESSEL 0x4 @@ -936,12 +939,27 @@ static int ipath_setup_pe_config(struct ipath_devdata *dd, else ipath_dev_err(dd, "Can't find PCI Express " "capability!\n"); + + dd->ipath_link_width_supported = IB_WIDTH_1X | IB_WIDTH_4X; + dd->ipath_link_speed_supported = IPATH_IB_SDR; + dd->ipath_link_width_enabled = IB_WIDTH_4X; + dd->ipath_link_speed_enabled = dd->ipath_link_speed_supported; + /* these can't change for this chip, so set once */ + dd->ipath_link_width_active = dd->ipath_link_width_enabled; + dd->ipath_link_speed_active = dd->ipath_link_speed_enabled; return 0; } static void ipath_init_pe_variables(struct ipath_devdata *dd) { /* + * setup the register offsets, since they are different for each + * chip + */ + dd->ipath_kregs = &ipath_pe_kregs; + dd->ipath_cregs = &ipath_pe_cregs; + + /* * bits for selecting i2c direction and values, * used for I2C serial flash */ @@ -950,6 +968,37 @@ static void ipath_init_pe_variables(struct ipath_devdata *dd) dd->ipath_gpio_sda = IPATH_GPIO_SDA; dd->ipath_gpio_scl = IPATH_GPIO_SCL; + /* + * Fill in data for field-values that change in newer chips. + * We dynamically specify only the mask for LINKTRAININGSTATE + * and only the shift for LINKSTATE, as they are the only ones + * that change. Also precalculate the 3 link states of interest + * and the combined mask. + */ + dd->ibcs_ls_shift = IBA6120_IBCS_LINKSTATE_SHIFT; + dd->ibcs_lts_mask = IBA6120_IBCS_LINKTRAININGSTATE_MASK; + dd->ibcs_mask = (INFINIPATH_IBCS_LINKSTATE_MASK << + dd->ibcs_ls_shift) | dd->ibcs_lts_mask; + dd->ib_init = (INFINIPATH_IBCS_LT_STATE_LINKUP << + INFINIPATH_IBCS_LINKTRAININGSTATE_SHIFT) | + (INFINIPATH_IBCS_L_STATE_INIT << dd->ibcs_ls_shift); + dd->ib_arm = (INFINIPATH_IBCS_LT_STATE_LINKUP << + INFINIPATH_IBCS_LINKTRAININGSTATE_SHIFT) | + (INFINIPATH_IBCS_L_STATE_ARM << dd->ibcs_ls_shift); + dd->ib_active = (INFINIPATH_IBCS_LT_STATE_LINKUP << + INFINIPATH_IBCS_LINKTRAININGSTATE_SHIFT) | + (INFINIPATH_IBCS_L_STATE_ACTIVE << dd->ibcs_ls_shift); + + /* + * Fill in data for ibcc field-values that change in newer chips. + * We dynamically specify only the mask for LINKINITCMD + * and only the shift for LINKCMD and MAXPKTLEN, as they are + * the only ones that change. + */ + dd->ibcc_lic_mask = INFINIPATH_IBCC_LINKINITCMD_MASK; + dd->ibcc_lc_shift = INFINIPATH_IBCC_LINKCMD_SHIFT; + dd->ibcc_mpl_shift = INFINIPATH_IBCC_MAXPKTLEN_SHIFT; + /* Fill in shifts for RcvCtrl. */ dd->ipath_r_portenable_shift = INFINIPATH_R_PORTENABLE_SHIFT; dd->ipath_r_intravail_shift = INFINIPATH_R_INTRAVAIL_SHIFT; @@ -1003,6 +1052,8 @@ static void ipath_init_pe_variables(struct ipath_devdata *dd) dd->ipath_i_rcvavail_mask = INFINIPATH_I_RCVAVAIL_MASK; dd->ipath_i_rcvurg_mask = INFINIPATH_I_RCVURG_MASK; + dd->ipath_i_rcvavail_shift = INFINIPATH_I_RCVAVAIL_SHIFT; + dd->ipath_i_rcvurg_shift = INFINIPATH_I_RCVURG_SHIFT; /* * EEPROM error log 0 is TXE Parity errors. 1 is RXE Parity. @@ -1024,6 +1075,7 @@ static void ipath_init_pe_variables(struct ipath_devdata *dd) INFINIPATH_E_INVALIDADDR | INFINIPATH_E_RESET; + dd->delay_mult = 2; /* SDR, 4X, can't change */ } /* setup the MSI stuff again after a reset. I'd like to just call @@ -1329,6 +1381,9 @@ static int ipath_pe_early_init(struct ipath_devdata *dd) */ dd->ipath_rcvhdrentsize = 24; dd->ipath_rcvhdrsize = IPATH_DFLT_RCVHDRSIZE; + dd->ipath_rhf_offset = 0; + dd->ipath_egrtidbase = (u64 __iomem *) + ((char __iomem *) dd->ipath_kregbase + dd->ipath_rcvegrbase); /* * To truly support a 4KB MTU (for usermode), we need to @@ -1399,6 +1454,14 @@ static void ipath_pe_free_irq(struct ipath_devdata *dd) dd->ipath_irq = 0; } + +static struct ipath_message_header * +ipath_pe_get_msgheader(struct ipath_devdata *dd, __le32 *rhf_addr) +{ + return (struct ipath_message_header *) + &rhf_addr[sizeof(u64) / sizeof(u32)]; +} + static void ipath_pe_config_ports(struct ipath_devdata *dd, ushort cfgports) { dd->ipath_portcnt = @@ -1534,6 +1597,88 @@ static int ipath_pe_txe_recover(struct ipath_devdata *dd) return 1; } +/* no interrupt fallback for these chips */ +static int ipath_pe_nointr_fallback(struct ipath_devdata *dd) +{ + return 0; +} + + +/* + * reset the XGXS (between serdes and IBC). Slightly less intrusive + * than resetting the IBC or external link state, and useful in some + * cases to cause some retraining. To do this right, we reset IBC + * as well. + */ +static void ipath_pe_xgxs_reset(struct ipath_devdata *dd) +{ + u64 val, prev_val; + + prev_val = ipath_read_kreg64(dd, dd->ipath_kregs->kr_xgxsconfig); + val = prev_val | INFINIPATH_XGXS_RESET; + prev_val &= ~INFINIPATH_XGXS_RESET; /* be sure */ + ipath_write_kreg(dd, dd->ipath_kregs->kr_control, + dd->ipath_control & ~INFINIPATH_C_LINKENABLE); + ipath_write_kreg(dd, dd->ipath_kregs->kr_xgxsconfig, val); + ipath_read_kreg32(dd, dd->ipath_kregs->kr_scratch); + ipath_write_kreg(dd, dd->ipath_kregs->kr_xgxsconfig, prev_val); + ipath_write_kreg(dd, dd->ipath_kregs->kr_control, + dd->ipath_control); +} + + +static int ipath_pe_get_ib_cfg(struct ipath_devdata *dd, int which) +{ + int ret; + + switch (which) { + case IPATH_IB_CFG_LWID: + ret = dd->ipath_link_width_active; + break; + case IPATH_IB_CFG_SPD: + ret = dd->ipath_link_speed_active; + break; + case IPATH_IB_CFG_LWID_ENB: + ret = dd->ipath_link_width_enabled; + break; + case IPATH_IB_CFG_SPD_ENB: + ret = dd->ipath_link_speed_enabled; + break; + default: + ret = -ENOTSUPP; + break; + } + return ret; +} + + +/* we assume range checking is already done, if needed */ +static int ipath_pe_set_ib_cfg(struct ipath_devdata *dd, int which, u32 val) +{ + int ret = 0; + + if (which == IPATH_IB_CFG_LWID_ENB) + dd->ipath_link_width_enabled = val; + else if (which == IPATH_IB_CFG_SPD_ENB) + dd->ipath_link_speed_enabled = val; + else + ret = -ENOTSUPP; + return ret; +} + +static void ipath_pe_config_jint(struct ipath_devdata *dd, u16 a, u16 b) +{ +} + + +static int ipath_pe_ib_updown(struct ipath_devdata *dd, int ibup, u64 ibcs) +{ + ipath_setup_pe_setextled(dd, ipath_ib_linkstate(dd, ibcs), + ipath_ib_linktrstate(dd, ibcs)); + return 0; +} + + /** * ipath_init_iba6120_funcs - set up the chip-specific function pointers * @dd: the infinipath device @@ -1554,7 +1699,7 @@ void ipath_init_iba6120_funcs(struct ipath_devdata *dd) dd->ipath_f_bringup_serdes = ipath_pe_bringup_serdes; dd->ipath_f_clear_tids = ipath_pe_clear_tids; /* - * this may get changed after we read the chip revision, + * _f_put_tid may get changed after we read the chip revision, * but we start with the safe version for all revs */ dd->ipath_f_put_tid = ipath_pe_put_tid; @@ -1562,19 +1707,19 @@ void ipath_init_iba6120_funcs(struct ipath_devdata *dd) dd->ipath_f_setextled = ipath_setup_pe_setextled; dd->ipath_f_get_base_info = ipath_pe_get_base_info; dd->ipath_f_free_irq = ipath_pe_free_irq; - - /* initialize chip-specific variables */ dd->ipath_f_tidtemplate = ipath_pe_tidtemplate; + dd->ipath_f_intr_fallback = ipath_pe_nointr_fallback; + dd->ipath_f_xgxs_reset = ipath_pe_xgxs_reset; + dd->ipath_f_get_msgheader = ipath_pe_get_msgheader; dd->ipath_f_config_ports = ipath_pe_config_ports; dd->ipath_f_read_counters = ipath_pe_read_counters; + dd->ipath_f_get_ib_cfg = ipath_pe_get_ib_cfg; + dd->ipath_f_set_ib_cfg = ipath_pe_set_ib_cfg; + dd->ipath_f_config_jint = ipath_pe_config_jint; + dd->ipath_f_ib_updown = ipath_pe_ib_updown; - /* - * setup the register offsets, since they are different for each - * chip - */ - dd->ipath_kregs = &ipath_pe_kregs; - dd->ipath_cregs = &ipath_pe_cregs; + /* initialize chip-specific variables */ ipath_init_pe_variables(dd); } |