diff options
Diffstat (limited to 'drivers/input/touchscreen/ads7846.c')
| -rw-r--r-- | drivers/input/touchscreen/ads7846.c | 62 |
1 files changed, 10 insertions, 52 deletions
diff --git a/drivers/input/touchscreen/ads7846.c b/drivers/input/touchscreen/ads7846.c index 57a1c28bf12..907a45fe9d4 100644 --- a/drivers/input/touchscreen/ads7846.c +++ b/drivers/input/touchscreen/ads7846.c @@ -28,13 +28,6 @@ #include <linux/spi/ads7846.h> #include <asm/irq.h> -#ifdef CONFIG_ARM -#include <asm/mach-types.h> -#ifdef CONFIG_ARCH_OMAP -#include <asm/arch/gpio.h> -#endif -#endif - /* * This code has been heavily tested on a Nokia 770, and lightly @@ -87,6 +80,7 @@ struct ads7846 { #endif u16 model; + u16 vref_mv; u16 vref_delay_usecs; u16 x_plate_ohms; u16 pressure_max; @@ -184,9 +178,6 @@ struct ads7846 { * The range is GND..vREF. The ads7843 and ads7835 must use external vREF; * ads7846 lets that pin be unconnected, to use internal vREF. */ -static unsigned vREF_mV; -module_param(vREF_mV, uint, 0); -MODULE_PARM_DESC(vREF_mV, "external vREF voltage, in milliVolts"); struct ser_req { u8 ref_on; @@ -213,7 +204,6 @@ static int ads7846_read12_ser(struct device *dev, unsigned command) struct ads7846 *ts = dev_get_drvdata(dev); struct ser_req *req = kzalloc(sizeof *req, GFP_KERNEL); int status; - int uninitialized_var(sample); int use_internal; if (!req) @@ -270,13 +260,13 @@ static int ads7846_read12_ser(struct device *dev, unsigned command) if (status == 0) { /* on-wire is a must-ignore bit, a BE12 value, then padding */ - sample = be16_to_cpu(req->sample); - sample = sample >> 3; - sample &= 0x0fff; + status = be16_to_cpu(req->sample); + status = status >> 3; + status &= 0x0fff; } kfree(req); - return status ? status : sample; + return status; } #if defined(CONFIG_HWMON) || defined(CONFIG_HWMON_MODULE) @@ -317,7 +307,7 @@ static inline unsigned vaux_adjust(struct ads7846 *ts, ssize_t v) unsigned retval = v; /* external resistors may scale vAUX into 0..vREF */ - retval *= vREF_mV; + retval *= ts->vref_mv; retval = retval >> 12; return retval; } @@ -375,14 +365,14 @@ static int ads784x_hwmon_register(struct spi_device *spi, struct ads7846 *ts) /* hwmon sensors need a reference voltage */ switch (ts->model) { case 7846: - if (!vREF_mV) { + if (!ts->vref_mv) { dev_dbg(&spi->dev, "assuming 2.5V internal vREF\n"); - vREF_mV = 2500; + ts->vref_mv = 2500; } break; case 7845: case 7843: - if (!vREF_mV) { + if (!ts->vref_mv) { dev_warn(&spi->dev, "external vREF for ADS%d not specified\n", ts->model); @@ -875,6 +865,7 @@ static int __devinit ads7846_probe(struct spi_device *spi) ts->spi = spi; ts->input = input_dev; + ts->vref_mv = pdata->vref_mv; hrtimer_init(&ts->timer, CLOCK_MONOTONIC, HRTIMER_MODE_REL); ts->timer.function = ads7846_timer; @@ -1174,31 +1165,6 @@ static struct spi_driver ads7846_driver = { static int __init ads7846_init(void) { - /* grr, board-specific init should stay out of drivers!! */ - -#ifdef CONFIG_ARCH_OMAP - if (machine_is_omap_osk()) { - /* GPIO4 = PENIRQ; GPIO6 = BUSY */ - omap_request_gpio(4); - omap_set_gpio_direction(4, 1); - omap_request_gpio(6); - omap_set_gpio_direction(6, 1); - } - // also TI 1510 Innovator, bitbanging through FPGA - // also Nokia 770 - // also Palm Tungsten T2 -#endif - - // PXA: - // also Dell Axim X50 - // also HP iPaq H191x/H192x/H415x/H435x - // also Intel Lubbock (additional to UCB1400; as temperature sensor) - // also Sharp Zaurus C7xx, C8xx (corgi/sheperd/husky) - - // Atmel at91sam9261-EK uses ads7843 - - // also various AMD Au1x00 devel boards - return spi_register_driver(&ads7846_driver); } module_init(ads7846_init); @@ -1206,14 +1172,6 @@ module_init(ads7846_init); static void __exit ads7846_exit(void) { spi_unregister_driver(&ads7846_driver); - -#ifdef CONFIG_ARCH_OMAP - if (machine_is_omap_osk()) { - omap_free_gpio(4); - omap_free_gpio(6); - } -#endif - } module_exit(ads7846_exit); |