diff options
Diffstat (limited to 'drivers/isdn/hisax')
-rw-r--r-- | drivers/isdn/hisax/nj_s.c | 194 |
1 files changed, 108 insertions, 86 deletions
diff --git a/drivers/isdn/hisax/nj_s.c b/drivers/isdn/hisax/nj_s.c index c09ffb13533..fa2db87667c 100644 --- a/drivers/isdn/hisax/nj_s.c +++ b/drivers/isdn/hisax/nj_s.c @@ -148,107 +148,87 @@ NETjet_S_card_msg(struct IsdnCardState *cs, int mt, void *arg) return(0); } -static struct pci_dev *dev_netjet __devinitdata = NULL; - -int __devinit -setup_netjet_s(struct IsdnCard *card) +static int __devinit njs_pci_probe(struct pci_dev *dev_netjet, + struct IsdnCardState *cs) { - int bytecnt,cfg; - struct IsdnCardState *cs = card->cs; - char tmp[64]; + int cfg; -#ifdef __BIG_ENDIAN -#error "not running on big endian machines now" -#endif - strcpy(tmp, NETjet_S_revision); - printk(KERN_INFO "HiSax: Traverse Tech. NETjet-S driver Rev. %s\n", HiSax_getrev(tmp)); - if (cs->typ != ISDN_CTYPE_NETJET_S) + if (pci_enable_device(dev_netjet)) return(0); - test_and_clear_bit(FLG_LOCK_ATOMIC, &cs->HW_Flags); + pci_set_master(dev_netjet); + cs->irq = dev_netjet->irq; + if (!cs->irq) { + printk(KERN_WARNING "NETjet-S: No IRQ for PCI card found\n"); + return(0); + } + cs->hw.njet.base = pci_resource_start(dev_netjet, 0); + if (!cs->hw.njet.base) { + printk(KERN_WARNING "NETjet-S: No IO-Adr for PCI card found\n"); + return(0); + } + /* the TJ300 and TJ320 must be detected, the IRQ handling is different + * unfortunatly the chips use the same device ID, but the TJ320 has + * the bit20 in status PCI cfg register set + */ + pci_read_config_dword(dev_netjet, 0x04, &cfg); + if (cfg & 0x00100000) + cs->subtyp = 1; /* TJ320 */ + else + cs->subtyp = 0; /* TJ300 */ + /* 2001/10/04 Christoph Ersfeld, Formula-n Europe AG www.formula-n.com */ + if ((dev_netjet->subsystem_vendor == 0x55) && + (dev_netjet->subsystem_device == 0x02)) { + printk(KERN_WARNING "Netjet: You tried to load this driver with an incompatible TigerJet-card\n"); + printk(KERN_WARNING "Use type=41 for Formula-n enter:now ISDN PCI and compatible\n"); + return(0); + } + /* end new code */ -#ifdef CONFIG_PCI + return(1); +} - for ( ;; ) - { - if ((dev_netjet = pci_find_device(PCI_VENDOR_ID_TIGERJET, - PCI_DEVICE_ID_TIGERJET_300, dev_netjet))) { - if (pci_enable_device(dev_netjet)) - return(0); - pci_set_master(dev_netjet); - cs->irq = dev_netjet->irq; - if (!cs->irq) { - printk(KERN_WARNING "NETjet-S: No IRQ for PCI card found\n"); - return(0); - } - cs->hw.njet.base = pci_resource_start(dev_netjet, 0); - if (!cs->hw.njet.base) { - printk(KERN_WARNING "NETjet-S: No IO-Adr for PCI card found\n"); - return(0); - } - /* the TJ300 and TJ320 must be detected, the IRQ handling is different - * unfortunatly the chips use the same device ID, but the TJ320 has - * the bit20 in status PCI cfg register set - */ - pci_read_config_dword(dev_netjet, 0x04, &cfg); - if (cfg & 0x00100000) - cs->subtyp = 1; /* TJ320 */ - else - cs->subtyp = 0; /* TJ300 */ - /* 2001/10/04 Christoph Ersfeld, Formula-n Europe AG www.formula-n.com */ - if ((dev_netjet->subsystem_vendor == 0x55) && - (dev_netjet->subsystem_device == 0x02)) { - printk(KERN_WARNING "Netjet: You tried to load this driver with an incompatible TigerJet-card\n"); - printk(KERN_WARNING "Use type=41 for Formula-n enter:now ISDN PCI and compatible\n"); - return(0); - } - /* end new code */ - } else { - printk(KERN_WARNING "NETjet-S: No PCI card found\n"); - return(0); - } +static int __devinit njs_cs_init(struct IsdnCard *card, + struct IsdnCardState *cs) +{ - cs->hw.njet.auxa = cs->hw.njet.base + NETJET_AUXDATA; - cs->hw.njet.isac = cs->hw.njet.base | NETJET_ISAC_OFF; + cs->hw.njet.auxa = cs->hw.njet.base + NETJET_AUXDATA; + cs->hw.njet.isac = cs->hw.njet.base | NETJET_ISAC_OFF; - cs->hw.njet.ctrl_reg = 0xff; /* Reset On */ - byteout(cs->hw.njet.base + NETJET_CTRL, cs->hw.njet.ctrl_reg); - mdelay(10); + cs->hw.njet.ctrl_reg = 0xff; /* Reset On */ + byteout(cs->hw.njet.base + NETJET_CTRL, cs->hw.njet.ctrl_reg); + mdelay(10); - cs->hw.njet.ctrl_reg = 0x00; /* Reset Off and status read clear */ - byteout(cs->hw.njet.base + NETJET_CTRL, cs->hw.njet.ctrl_reg); - mdelay(10); + cs->hw.njet.ctrl_reg = 0x00; /* Reset Off and status read clear */ + byteout(cs->hw.njet.base + NETJET_CTRL, cs->hw.njet.ctrl_reg); + mdelay(10); - cs->hw.njet.auxd = 0xC0; - cs->hw.njet.dmactrl = 0; + cs->hw.njet.auxd = 0xC0; + cs->hw.njet.dmactrl = 0; - byteout(cs->hw.njet.base + NETJET_AUXCTRL, ~NETJET_ISACIRQ); - byteout(cs->hw.njet.base + NETJET_IRQMASK1, NETJET_ISACIRQ); - byteout(cs->hw.njet.auxa, cs->hw.njet.auxd); + byteout(cs->hw.njet.base + NETJET_AUXCTRL, ~NETJET_ISACIRQ); + byteout(cs->hw.njet.base + NETJET_IRQMASK1, NETJET_ISACIRQ); + byteout(cs->hw.njet.auxa, cs->hw.njet.auxd); - switch ( ( ( NETjet_ReadIC( cs, ISAC_RBCH ) >> 5 ) & 3 ) ) - { - case 0 : - break; + switch ( ( ( NETjet_ReadIC( cs, ISAC_RBCH ) >> 5 ) & 3 ) ) + { + case 0 : + return 1; /* end loop */ - case 3 : - printk( KERN_WARNING "NETjet-S: NETspider-U PCI card found\n" ); - continue; + case 3 : + printk( KERN_WARNING "NETjet-S: NETspider-U PCI card found\n" ); + return -1; /* continue looping */ - default : - printk( KERN_WARNING "NETjet-S: No PCI card found\n" ); - return 0; - } - break; + default : + printk( KERN_WARNING "NETjet-S: No PCI card found\n" ); + return 0; /* end loop & function */ } -#else - - printk(KERN_WARNING "NETjet-S: NO_PCI_BIOS\n"); - printk(KERN_WARNING "NETjet-S: unable to config NETJET-S PCI\n"); - return (0); - -#endif /* CONFIG_PCI */ + return 1; /* end loop */ +} - bytecnt = 256; +static int __devinit njs_cs_init_rest(struct IsdnCard *card, + struct IsdnCardState *cs) +{ + const int bytecnt = 256; printk(KERN_INFO "NETjet-S: %s card configured at %#lx IRQ %d\n", @@ -273,5 +253,47 @@ setup_netjet_s(struct IsdnCard *card) cs->irq_func = &netjet_s_interrupt; cs->irq_flags |= IRQF_SHARED; ISACVersion(cs, "NETjet-S:"); + return (1); } + +static struct pci_dev *dev_netjet __devinitdata = NULL; + +int __devinit +setup_netjet_s(struct IsdnCard *card) +{ + int ret; + struct IsdnCardState *cs = card->cs; + char tmp[64]; + +#ifdef __BIG_ENDIAN +#error "not running on big endian machines now" +#endif + strcpy(tmp, NETjet_S_revision); + printk(KERN_INFO "HiSax: Traverse Tech. NETjet-S driver Rev. %s\n", HiSax_getrev(tmp)); + if (cs->typ != ISDN_CTYPE_NETJET_S) + return(0); + test_and_clear_bit(FLG_LOCK_ATOMIC, &cs->HW_Flags); + + for ( ;; ) + { + if ((dev_netjet = pci_find_device(PCI_VENDOR_ID_TIGERJET, + PCI_DEVICE_ID_TIGERJET_300, dev_netjet))) { + ret = njs_pci_probe(dev_netjet, cs); + if (!ret) + return(0); + } else { + printk(KERN_WARNING "NETjet-S: No PCI card found\n"); + return(0); + } + + ret = njs_cs_init(card, cs); + if (!ret) + return(0); + if (ret > 0) + break; + /* otherwise, ret < 0, continue looping */ + } + + return njs_cs_init_rest(card, cs); +} |