diff options
Diffstat (limited to 'drivers/net/3c503.c')
| -rw-r--r-- | drivers/net/3c503.c | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/drivers/net/3c503.c b/drivers/net/3c503.c index cb5ef75450d..64313e3dfcb 100644 --- a/drivers/net/3c503.c +++ b/drivers/net/3c503.c @@ -81,7 +81,7 @@ static void el2_get_8390_hdr(struct net_device *dev, struct e8390_pkt_hdr *hdr, int ring_page); static struct ethtool_ops netdev_ethtool_ops; - + /* This routine probes for a memory-mapped 3c503 board by looking for the "location register" at the end of the jumpered boot PROM space. This works even if a PROM isn't there. @@ -96,7 +96,7 @@ static int __init do_el2_probe(struct net_device *dev) int irq = dev->irq; SET_MODULE_OWNER(dev); - + if (base_addr > 0x1ff) /* Check a single specified location. */ return el2_probe1(dev, base_addr); else if (base_addr != 0) /* Don't probe at all. */ @@ -127,7 +127,7 @@ static int __init do_el2_probe(struct net_device *dev) /* Try all of the locations that aren't obviously empty. This touches a lot of locations, and is much riskier than the code above. */ -static int __init +static int __init el2_pio_probe(struct net_device *dev) { int i; @@ -173,7 +173,7 @@ out: /* Probe for the Etherlink II card at I/O port base IOADDR, returning non-zero on success. If found, set the station address and memory parameters in DEVICE. */ -static int __init +static int __init el2_probe1(struct net_device *dev, int ioaddr) { int i, iobase_reg, membase_reg, saved_406, wordlength, retval; @@ -367,7 +367,7 @@ out: release_region(ioaddr, EL2_IO_EXTENT); return retval; } - + static int el2_open(struct net_device *dev) { @@ -385,7 +385,7 @@ el2_open(struct net_device *dev) outb_p(0x04 << ((*irqp == 9) ? 2 : *irqp), E33G_IDCFR); outb_p(0x00, E33G_IDCFR); if (*irqp == probe_irq_off(cookie) /* It's a good IRQ line! */ - && ((retval = request_irq(dev->irq = *irqp, + && ((retval = request_irq(dev->irq = *irqp, ei_interrupt, 0, dev->name, dev)) == 0)) break; } |