diff options
Diffstat (limited to 'drivers/net/e1000/e1000_main.c')
-rw-r--r-- | drivers/net/e1000/e1000_main.c | 42 |
1 files changed, 30 insertions, 12 deletions
diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c index 93b861d032b..ddc5c533e89 100644 --- a/drivers/net/e1000/e1000_main.c +++ b/drivers/net/e1000/e1000_main.c @@ -962,13 +962,13 @@ static int __devinit e1000_probe(struct pci_dev *pdev, if (err) return err; - if (!pci_set_dma_mask(pdev, DMA_64BIT_MASK) && - !pci_set_consistent_dma_mask(pdev, DMA_64BIT_MASK)) { + if (!pci_set_dma_mask(pdev, DMA_BIT_MASK(64)) && + !pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(64))) { pci_using_dac = 1; } else { - err = pci_set_dma_mask(pdev, DMA_32BIT_MASK); + err = pci_set_dma_mask(pdev, DMA_BIT_MASK(32)); if (err) { - err = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK); + err = pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(32)); if (err) { E1000_ERR("No usable DMA configuration, " "aborting\n"); @@ -2335,6 +2335,12 @@ static void e1000_set_rx_mode(struct net_device *netdev) int mta_reg_count = (hw->mac_type == e1000_ich8lan) ? E1000_NUM_MTA_REGISTERS_ICH8LAN : E1000_NUM_MTA_REGISTERS; + u32 *mcarray = kcalloc(mta_reg_count, sizeof(u32), GFP_ATOMIC); + + if (!mcarray) { + DPRINTK(PROBE, ERR, "memory allocation failed\n"); + return; + } if (hw->mac_type == e1000_ich8lan) rar_entries = E1000_RAR_ENTRIES_ICH8LAN; @@ -2401,22 +2407,34 @@ static void e1000_set_rx_mode(struct net_device *netdev) } WARN_ON(uc_ptr != NULL); - /* clear the old settings from the multicast hash table */ - - for (i = 0; i < mta_reg_count; i++) { - E1000_WRITE_REG_ARRAY(hw, MTA, i, 0); - E1000_WRITE_FLUSH(); - } - /* load any remaining addresses into the hash table */ for (; mc_ptr; mc_ptr = mc_ptr->next) { + u32 hash_reg, hash_bit, mta; hash_value = e1000_hash_mc_addr(hw, mc_ptr->da_addr); - e1000_mta_set(hw, hash_value); + hash_reg = (hash_value >> 5) & 0x7F; + hash_bit = hash_value & 0x1F; + mta = (1 << hash_bit); + mcarray[hash_reg] |= mta; } + /* write the hash table completely, write from bottom to avoid + * both stupid write combining chipsets, and flushing each write */ + for (i = mta_reg_count - 1; i >= 0 ; i--) { + /* + * If we are on an 82544 has an errata where writing odd + * offsets overwrites the previous even offset, but writing + * backwards over the range solves the issue by always + * writing the odd offset first + */ + E1000_WRITE_REG_ARRAY(hw, MTA, i, mcarray[i]); + } + E1000_WRITE_FLUSH(); + if (hw->mac_type == e1000_82542_rev2_0) e1000_leave_82542_rst(adapter); + + kfree(mcarray); } /* Need to wait a few seconds after link up to get diagnostic information from |