diff options
Diffstat (limited to 'drivers/net/e1000/e1000_main.c')
-rw-r--r-- | drivers/net/e1000/e1000_main.c | 102 |
1 files changed, 94 insertions, 8 deletions
diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c index c062b0ad826..407abb2c054 100644 --- a/drivers/net/e1000/e1000_main.c +++ b/drivers/net/e1000/e1000_main.c @@ -398,6 +398,10 @@ e1000_reset(struct e1000_adapter *adapter) case e1000_82547_rev_2: pba = E1000_PBA_30K; break; + case e1000_82571: + case e1000_82572: + pba = E1000_PBA_38K; + break; case e1000_82573: pba = E1000_PBA_12K; break; @@ -475,6 +479,7 @@ e1000_probe(struct pci_dev *pdev, struct net_device *netdev; struct e1000_adapter *adapter; unsigned long mmio_start, mmio_len; + uint32_t ctrl_ext; uint32_t swsm; static int cards_found = 0; @@ -688,6 +693,12 @@ e1000_probe(struct pci_dev *pdev, /* Let firmware know the driver has taken over */ switch(adapter->hw.mac_type) { + case e1000_82571: + case e1000_82572: + ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); + E1000_WRITE_REG(&adapter->hw, CTRL_EXT, + ctrl_ext | E1000_CTRL_EXT_DRV_LOAD); + break; case e1000_82573: swsm = E1000_READ_REG(&adapter->hw, SWSM); E1000_WRITE_REG(&adapter->hw, SWSM, @@ -732,6 +743,7 @@ e1000_remove(struct pci_dev *pdev) { struct net_device *netdev = pci_get_drvdata(pdev); struct e1000_adapter *adapter = netdev_priv(netdev); + uint32_t ctrl_ext; uint32_t manc, swsm; flush_scheduled_work(); @@ -746,6 +758,12 @@ e1000_remove(struct pci_dev *pdev) } switch(adapter->hw.mac_type) { + case e1000_82571: + case e1000_82572: + ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); + E1000_WRITE_REG(&adapter->hw, CTRL_EXT, + ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD); + break; case e1000_82573: swsm = E1000_READ_REG(&adapter->hw, SWSM); E1000_WRITE_REG(&adapter->hw, SWSM, @@ -1236,7 +1254,7 @@ e1000_setup_rctl(struct e1000_adapter *adapter) rctl |= E1000_RCTL_LPE; /* Setup buffer sizes */ - if(adapter->hw.mac_type == e1000_82573) { + if(adapter->hw.mac_type >= e1000_82571) { /* We can now specify buffers in 1K increments. * BSIZE and BSEX are ignored in this case. */ rctl |= adapter->rx_buffer_len << 0x11; @@ -1352,7 +1370,7 @@ e1000_configure_rx(struct e1000_adapter *adapter) if(adapter->rx_csum == TRUE) { rxcsum |= E1000_RXCSUM_TUOFL; - /* Enable 82573 IPv4 payload checksum for UDP fragments + /* Enable 82571 IPv4 payload checksum for UDP fragments * Must be used in conjunction with packet-split. */ if((adapter->hw.mac_type > e1000_82547_rev_2) && (adapter->rx_ps)) { @@ -1608,6 +1626,22 @@ e1000_set_mac(struct net_device *netdev, void *p) e1000_rar_set(&adapter->hw, adapter->hw.mac_addr, 0); + /* With 82571 controllers, LAA may be overwritten (with the default) + * due to controller reset from the other port. */ + if (adapter->hw.mac_type == e1000_82571) { + /* activate the work around */ + adapter->hw.laa_is_present = 1; + + /* Hold a copy of the LAA in RAR[14] This is done so that + * between the time RAR[0] gets clobbered and the time it + * gets fixed (in e1000_watchdog), the actual LAA is in one + * of the RARs and no incoming packets directed to this port + * are dropped. Eventaully the LAA will be in RAR[0] and + * RAR[14] */ + e1000_rar_set(&adapter->hw, adapter->hw.mac_addr, + E1000_RAR_ENTRIES - 1); + } + if(adapter->hw.mac_type == e1000_82542_rev2_0) e1000_leave_82542_rst(adapter); @@ -1633,9 +1667,12 @@ e1000_set_multi(struct net_device *netdev) unsigned long flags; uint32_t rctl; uint32_t hash_value; - int i; + int i, rar_entries = E1000_RAR_ENTRIES; spin_lock_irqsave(&adapter->tx_lock, flags); + /* reserve RAR[14] for LAA over-write work-around */ + if (adapter->hw.mac_type == e1000_82571) + rar_entries--; /* Check for Promiscuous and All Multicast modes */ @@ -1660,11 +1697,12 @@ e1000_set_multi(struct net_device *netdev) /* load the first 14 multicast address into the exact filters 1-14 * RAR 0 is used for the station MAC adddress * if there are not 14 addresses, go ahead and clear the filters + * -- with 82571 controllers only 0-13 entries are filled here */ mc_ptr = netdev->mc_list; - for(i = 1; i < E1000_RAR_ENTRIES; i++) { - if(mc_ptr) { + for(i = 1; i < rar_entries; i++) { + if (mc_ptr) { e1000_rar_set(hw, mc_ptr->dmi_addr, i); mc_ptr = mc_ptr->next; } else { @@ -1848,6 +1886,11 @@ e1000_watchdog_task(struct e1000_adapter *adapter) /* Force detection of hung controller every watchdog period */ adapter->detect_tx_hung = TRUE; + /* With 82571 controllers, LAA may be overwritten due to controller + * reset from the other port. Set the appropriate LAA in RAR[0] */ + if (adapter->hw.mac_type == e1000_82571 && adapter->hw.laa_is_present) + e1000_rar_set(&adapter->hw, adapter->hw.mac_addr, 0); + /* Reset the timer */ mod_timer(&adapter->watchdog_timer, jiffies + 2 * HZ); } @@ -2269,6 +2312,27 @@ e1000_xmit_frame(struct sk_buff *skb, struct net_device *netdev) local_irq_restore(flags); return NETDEV_TX_LOCKED; } +#ifdef NETIF_F_TSO + /* TSO Workaround for 82571/2 Controllers -- if skb->data + * points to just header, pull a few bytes of payload from + * frags into skb->data */ + if (skb_shinfo(skb)->tso_size) { + uint8_t hdr_len; + hdr_len = ((skb->h.raw - skb->data) + (skb->h.th->doff << 2)); + if (skb->data_len && (hdr_len < (skb->len - skb->data_len)) && + (adapter->hw.mac_type == e1000_82571 || + adapter->hw.mac_type == e1000_82572)) { + unsigned int pull_size; + pull_size = min((unsigned int)4, skb->data_len); + if (!__pskb_pull_tail(skb, pull_size)) { + printk(KERN_ERR "__pskb_pull_tail failed.\n"); + dev_kfree_skb_any(skb); + return -EFAULT; + } + } + } +#endif + if(adapter->hw.tx_pkt_filtering && (adapter->hw.mac_type == e1000_82573) ) e1000_transfer_dhcp_info(adapter, skb); @@ -2310,7 +2374,7 @@ e1000_xmit_frame(struct sk_buff *skb, struct net_device *netdev) tx_flags |= E1000_TX_FLAGS_CSUM; /* Old method was to assume IPv4 packet by default if TSO was enabled. - * 82573 hardware supports TSO capabilities for IPv6 as well... + * 82571 hardware supports TSO capabilities for IPv6 as well... * no longer assume, we must. */ if(likely(skb->protocol == ntohs(ETH_P_IP))) tx_flags |= E1000_TX_FLAGS_IPV4; @@ -2389,9 +2453,18 @@ e1000_change_mtu(struct net_device *netdev, int new_mtu) return -EINVAL; } -#define MAX_STD_JUMBO_FRAME_SIZE 9216 +#define MAX_STD_JUMBO_FRAME_SIZE 9234 /* might want this to be bigger enum check... */ - if (adapter->hw.mac_type == e1000_82573 && + /* 82571 controllers limit jumbo frame size to 10500 bytes */ + if ((adapter->hw.mac_type == e1000_82571 || + adapter->hw.mac_type == e1000_82572) && + max_frame > MAX_STD_JUMBO_FRAME_SIZE) { + DPRINTK(PROBE, ERR, "MTU > 9216 bytes not supported " + "on 82571 and 82572 controllers.\n"); + return -EINVAL; + } + + if(adapter->hw.mac_type == e1000_82573 && max_frame > MAXIMUM_ETHERNET_FRAME_SIZE) { DPRINTK(PROBE, ERR, "Jumbo Frames not supported " "on 82573\n"); @@ -3716,6 +3789,12 @@ e1000_suspend(struct pci_dev *pdev, pm_message_t state) } switch(adapter->hw.mac_type) { + case e1000_82571: + case e1000_82572: + ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); + E1000_WRITE_REG(&adapter->hw, CTRL_EXT, + ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD); + break; case e1000_82573: swsm = E1000_READ_REG(&adapter->hw, SWSM); E1000_WRITE_REG(&adapter->hw, SWSM, @@ -3738,6 +3817,7 @@ e1000_resume(struct pci_dev *pdev) struct net_device *netdev = pci_get_drvdata(pdev); struct e1000_adapter *adapter = netdev_priv(netdev); uint32_t manc, ret_val, swsm; + uint32_t ctrl_ext; pci_set_power_state(pdev, PCI_D0); pci_restore_state(pdev); @@ -3763,6 +3843,12 @@ e1000_resume(struct pci_dev *pdev) } switch(adapter->hw.mac_type) { + case e1000_82571: + case e1000_82572: + ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); + E1000_WRITE_REG(&adapter->hw, CTRL_EXT, + ctrl_ext | E1000_CTRL_EXT_DRV_LOAD); + break; case e1000_82573: swsm = E1000_READ_REG(&adapter->hw, SWSM); E1000_WRITE_REG(&adapter->hw, SWSM, |