diff options
Diffstat (limited to 'drivers/net/e1000')
| -rw-r--r-- | drivers/net/e1000/e1000_ethtool.c | 2 | ||||
| -rw-r--r-- | drivers/net/e1000/e1000_hw.c | 12 | ||||
| -rw-r--r-- | drivers/net/e1000/e1000_hw.h | 19 | ||||
| -rw-r--r-- | drivers/net/e1000/e1000_main.c | 5 |
4 files changed, 36 insertions, 2 deletions
diff --git a/drivers/net/e1000/e1000_ethtool.c b/drivers/net/e1000/e1000_ethtool.c index 8363d8d8631..0f9c86057a5 100644 --- a/drivers/net/e1000/e1000_ethtool.c +++ b/drivers/net/e1000/e1000_ethtool.c @@ -1628,6 +1628,7 @@ e1000_get_wol(struct net_device *netdev, struct ethtool_wolinfo *wol) case E1000_DEV_ID_82546EB_FIBER: case E1000_DEV_ID_82546GB_FIBER: + case E1000_DEV_ID_82571EB_FIBER: /* Wake events only supported on port A for dual fiber */ if(E1000_READ_REG(hw, STATUS) & E1000_STATUS_FUNC_1) { wol->supported = 0; @@ -1671,6 +1672,7 @@ e1000_set_wol(struct net_device *netdev, struct ethtool_wolinfo *wol) case E1000_DEV_ID_82546EB_FIBER: case E1000_DEV_ID_82546GB_FIBER: + case E1000_DEV_ID_82571EB_FIBER: /* Wake events only supported on port A for dual fiber */ if(E1000_READ_REG(hw, STATUS) & E1000_STATUS_FUNC_1) return wol->wolopts ? -EOPNOTSUPP : 0; diff --git a/drivers/net/e1000/e1000_hw.c b/drivers/net/e1000/e1000_hw.c index ac227c7847f..2437d362ff6 100644 --- a/drivers/net/e1000/e1000_hw.c +++ b/drivers/net/e1000/e1000_hw.c @@ -318,6 +318,8 @@ e1000_set_mac_type(struct e1000_hw *hw) case E1000_DEV_ID_82546GB_FIBER: case E1000_DEV_ID_82546GB_SERDES: case E1000_DEV_ID_82546GB_PCIE: + case E1000_DEV_ID_82546GB_QUAD_COPPER: + case E1000_DEV_ID_82546GB_QUAD_COPPER_KSP3: hw->mac_type = e1000_82546_rev_3; break; case E1000_DEV_ID_82541EI: @@ -639,6 +641,7 @@ e1000_init_hw(struct e1000_hw *hw) uint16_t cmd_mmrbc; uint16_t stat_mmrbc; uint32_t mta_size; + uint32_t ctrl_ext; DEBUGFUNC("e1000_init_hw"); @@ -774,6 +777,15 @@ e1000_init_hw(struct e1000_hw *hw) */ e1000_clear_hw_cntrs(hw); + if (hw->device_id == E1000_DEV_ID_82546GB_QUAD_COPPER || + hw->device_id == E1000_DEV_ID_82546GB_QUAD_COPPER_KSP3) { + ctrl_ext = E1000_READ_REG(hw, CTRL_EXT); + /* Relaxed ordering must be disabled to avoid a parity + * error crash in a PCI slot. */ + ctrl_ext |= E1000_CTRL_EXT_RO_DIS; + E1000_WRITE_REG(hw, CTRL_EXT, ctrl_ext); + } + return ret_val; } diff --git a/drivers/net/e1000/e1000_hw.h b/drivers/net/e1000/e1000_hw.h index 600570ff254..0b8f6f2b774 100644 --- a/drivers/net/e1000/e1000_hw.h +++ b/drivers/net/e1000/e1000_hw.h @@ -439,6 +439,7 @@ int32_t e1000_check_phy_reset_block(struct e1000_hw *hw); #define E1000_DEV_ID_82546GB_FIBER 0x107A #define E1000_DEV_ID_82546GB_SERDES 0x107B #define E1000_DEV_ID_82546GB_PCIE 0x108A +#define E1000_DEV_ID_82546GB_QUAD_COPPER 0x1099 #define E1000_DEV_ID_82547EI 0x1019 #define E1000_DEV_ID_82571EB_COPPER 0x105E #define E1000_DEV_ID_82571EB_FIBER 0x105F @@ -449,6 +450,7 @@ int32_t e1000_check_phy_reset_block(struct e1000_hw *hw); #define E1000_DEV_ID_82573E 0x108B #define E1000_DEV_ID_82573E_IAMT 0x108C #define E1000_DEV_ID_82573L 0x109A +#define E1000_DEV_ID_82546GB_QUAD_COPPER_KSP3 0x10B5 #define NODE_ADDRESS_SIZE 6 @@ -1955,6 +1957,23 @@ struct e1000_host_command_info { #define E1000_MDALIGN 4096 +/* PCI-Ex registers */ + +/* PCI-Ex Control Register */ +#define E1000_GCR_RXD_NO_SNOOP 0x00000001 +#define E1000_GCR_RXDSCW_NO_SNOOP 0x00000002 +#define E1000_GCR_RXDSCR_NO_SNOOP 0x00000004 +#define E1000_GCR_TXD_NO_SNOOP 0x00000008 +#define E1000_GCR_TXDSCW_NO_SNOOP 0x00000010 +#define E1000_GCR_TXDSCR_NO_SNOOP 0x00000020 + +#define PCI_EX_NO_SNOOP_ALL (E1000_GCR_RXD_NO_SNOOP | \ + E1000_GCR_RXDSCW_NO_SNOOP | \ + E1000_GCR_RXDSCR_NO_SNOOP | \ + E1000_GCR TXD_NO_SNOOP | \ + E1000_GCR_TXDSCW_NO_SNOOP | \ + E1000_GCR_TXDSCR_NO_SNOOP) + #define E1000_GCR_L1_ACT_WITHOUT_L0S_RX 0x08000000 /* Function Active and Power State to MNG */ #define E1000_FACTPS_FUNC0_POWER_STATE_MASK 0x00000003 diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c index 72a80099f4a..ca4e5e9255d 100644 --- a/drivers/net/e1000/e1000_main.c +++ b/drivers/net/e1000/e1000_main.c @@ -97,7 +97,9 @@ static struct pci_device_id e1000_pci_tbl[] = { INTEL_E1000_ETHERNET_DEVICE(0x108A), INTEL_E1000_ETHERNET_DEVICE(0x108B), INTEL_E1000_ETHERNET_DEVICE(0x108C), + INTEL_E1000_ETHERNET_DEVICE(0x1099), INTEL_E1000_ETHERNET_DEVICE(0x109A), + INTEL_E1000_ETHERNET_DEVICE(0x10B5), /* required last entry */ {0,} }; @@ -791,8 +793,7 @@ e1000_probe(struct pci_dev *pdev, case e1000_82546: case e1000_82546_rev_3: case e1000_82571: - if((E1000_READ_REG(&adapter->hw, STATUS) & E1000_STATUS_FUNC_1) - && (adapter->hw.media_type == e1000_media_type_copper)) { + if(E1000_READ_REG(&adapter->hw, STATUS) & E1000_STATUS_FUNC_1){ e1000_read_eeprom(&adapter->hw, EEPROM_INIT_CONTROL3_PORT_B, 1, &eeprom_data); break; |