diff options
Diffstat (limited to 'drivers/net/ethernet/marvell/sky2.c')
| -rw-r--r-- | drivers/net/ethernet/marvell/sky2.c | 28 |
1 files changed, 22 insertions, 6 deletions
diff --git a/drivers/net/ethernet/marvell/sky2.c b/drivers/net/ethernet/marvell/sky2.c index cace36f2ab9..2b0748dba8b 100644 --- a/drivers/net/ethernet/marvell/sky2.c +++ b/drivers/net/ethernet/marvell/sky2.c @@ -141,6 +141,7 @@ static DEFINE_PCI_DEVICE_TABLE(sky2_id_table) = { { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4370) }, /* 88E8075 */ { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4380) }, /* 88E8057 */ { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4381) }, /* 88E8059 */ + { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4382) }, /* 88E8079 */ { 0 } }; @@ -3079,8 +3080,10 @@ static irqreturn_t sky2_intr(int irq, void *dev_id) /* Reading this mask interrupts as side effect */ status = sky2_read32(hw, B0_Y2_SP_ISRC2); - if (status == 0 || status == ~0) + if (status == 0 || status == ~0) { + sky2_write32(hw, B0_Y2_SP_ICR, 2); return IRQ_NONE; + } prefetch(&hw->st_le[hw->st_idx]); @@ -3349,6 +3352,17 @@ static void sky2_reset(struct sky2_hw *hw) sky2_pci_write16(hw, pdev->pcie_cap + PCI_EXP_LNKCTL, reg); + if (hw->chip_id == CHIP_ID_YUKON_PRM && + hw->chip_rev == CHIP_REV_YU_PRM_A0) { + /* change PHY Interrupt polarity to low active */ + reg = sky2_read16(hw, GPHY_CTRL); + sky2_write16(hw, GPHY_CTRL, reg | GPC_INTPOL); + + /* adapt HW for low active PHY Interrupt */ + reg = sky2_read16(hw, Y2_CFG_SPC + PCI_LDO_CTRL); + sky2_write16(hw, Y2_CFG_SPC + PCI_LDO_CTRL, reg | PHY_M_UNDOC1); + } + sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF); /* re-enable PEX PM in PEX PHY debug reg. 8 (clear bit 12) */ @@ -4381,10 +4395,12 @@ static int sky2_set_features(struct net_device *dev, netdev_features_t features) struct sky2_port *sky2 = netdev_priv(dev); netdev_features_t changed = dev->features ^ features; - if (changed & NETIF_F_RXCSUM) { - bool on = features & NETIF_F_RXCSUM; - sky2_write32(sky2->hw, Q_ADDR(rxqaddr[sky2->port], Q_CSR), - on ? BMU_ENA_RX_CHKSUM : BMU_DIS_RX_CHKSUM); + if ((changed & NETIF_F_RXCSUM) && + !(sky2->hw->flags & SKY2_HW_NEW_LE)) { + sky2_write32(sky2->hw, + Q_ADDR(rxqaddr[sky2->port], Q_CSR), + (features & NETIF_F_RXCSUM) + ? BMU_ENA_RX_CHKSUM : BMU_DIS_RX_CHKSUM); } if (changed & NETIF_F_RXHASH) @@ -4869,7 +4885,7 @@ static const char *sky2_name(u8 chipid, char *buf, int sz) "UL 2", /* 0xba */ "Unknown", /* 0xbb */ "Optima", /* 0xbc */ - "Optima Prime", /* 0xbd */ + "OptimaEEE", /* 0xbd */ "Optima 2", /* 0xbe */ }; |