diff options
Diffstat (limited to 'drivers/net/ethernet/realtek/8139cp.c')
| -rw-r--r-- | drivers/net/ethernet/realtek/8139cp.c | 75 |
1 files changed, 44 insertions, 31 deletions
diff --git a/drivers/net/ethernet/realtek/8139cp.c b/drivers/net/ethernet/realtek/8139cp.c index 609125a249d..cb6fc5a743c 100644 --- a/drivers/net/ethernet/realtek/8139cp.c +++ b/drivers/net/ethernet/realtek/8139cp.c @@ -648,6 +648,7 @@ static void cp_tx (struct cp_private *cp) { unsigned tx_head = cp->tx_head; unsigned tx_tail = cp->tx_tail; + unsigned bytes_compl = 0, pkts_compl = 0; while (tx_tail != tx_head) { struct cp_desc *txd = cp->tx_ring + tx_tail; @@ -666,6 +667,9 @@ static void cp_tx (struct cp_private *cp) le32_to_cpu(txd->opts1) & 0xffff, PCI_DMA_TODEVICE); + bytes_compl += skb->len; + pkts_compl++; + if (status & LastFrag) { if (status & (TxError | TxFIFOUnder)) { netif_dbg(cp, tx_err, cp->dev, @@ -697,6 +701,7 @@ static void cp_tx (struct cp_private *cp) cp->tx_tail = tx_tail; + netdev_completed_queue(cp->dev, pkts_compl, bytes_compl); if (TX_BUFFS_AVAIL(cp) > (MAX_SKB_FRAGS + 1)) netif_wake_queue(cp->dev); } @@ -843,6 +848,8 @@ static netdev_tx_t cp_start_xmit (struct sk_buff *skb, wmb(); } cp->tx_head = entry; + + netdev_sent_queue(dev, skb->len); netif_dbg(cp, tx_queued, cp->dev, "tx queued, slot %d, skblen %d\n", entry, skb->len); if (TX_BUFFS_AVAIL(cp) <= (MAX_SKB_FRAGS + 1)) @@ -937,6 +944,8 @@ static void cp_stop_hw (struct cp_private *cp) cp->rx_tail = 0; cp->tx_head = cp->tx_tail = 0; + + netdev_reset_queue(cp->dev); } static void cp_reset_hw (struct cp_private *cp) @@ -957,8 +966,38 @@ static void cp_reset_hw (struct cp_private *cp) static inline void cp_start_hw (struct cp_private *cp) { + dma_addr_t ring_dma; + cpw16(CpCmd, cp->cpcmd); + + /* + * These (at least TxRingAddr) need to be configured after the + * corresponding bits in CpCmd are enabled. Datasheet v1.6 ยง6.33 + * (C+ Command Register) recommends that these and more be configured + * *after* the [RT]xEnable bits in CpCmd are set. And on some hardware + * it's been observed that the TxRingAddr is actually reset to garbage + * when C+ mode Tx is enabled in CpCmd. + */ + cpw32_f(HiTxRingAddr, 0); + cpw32_f(HiTxRingAddr + 4, 0); + + ring_dma = cp->ring_dma; + cpw32_f(RxRingAddr, ring_dma & 0xffffffff); + cpw32_f(RxRingAddr + 4, (ring_dma >> 16) >> 16); + + ring_dma += sizeof(struct cp_desc) * CP_RX_RING_SIZE; + cpw32_f(TxRingAddr, ring_dma & 0xffffffff); + cpw32_f(TxRingAddr + 4, (ring_dma >> 16) >> 16); + + /* + * Strictly speaking, the datasheet says this should be enabled + * *before* setting the descriptor addresses. But what, then, would + * prevent it from doing DMA to random unconfigured addresses? + * This variant appears to work fine. + */ cpw8(Cmd, RxOn | TxOn); + + netdev_reset_queue(cp->dev); } static void cp_enable_irq(struct cp_private *cp) @@ -969,7 +1008,6 @@ static void cp_enable_irq(struct cp_private *cp) static void cp_init_hw (struct cp_private *cp) { struct net_device *dev = cp->dev; - dma_addr_t ring_dma; cp_reset_hw(cp); @@ -992,17 +1030,6 @@ static void cp_init_hw (struct cp_private *cp) cpw8(Config5, cpr8(Config5) & PMEStatus); - cpw32_f(HiTxRingAddr, 0); - cpw32_f(HiTxRingAddr + 4, 0); - - ring_dma = cp->ring_dma; - cpw32_f(RxRingAddr, ring_dma & 0xffffffff); - cpw32_f(RxRingAddr + 4, (ring_dma >> 16) >> 16); - - ring_dma += sizeof(struct cp_desc) * CP_RX_RING_SIZE; - cpw32_f(TxRingAddr, ring_dma & 0xffffffff); - cpw32_f(TxRingAddr + 4, (ring_dma >> 16) >> 16); - cpw16(MultiIntr, 0); cpw8_f(Cfg9346, Cfg9346_Lock); @@ -1197,18 +1224,16 @@ static void cp_tx_timeout(struct net_device *dev) cp_clean_rings(cp); rc = cp_init_rings(cp); cp_start_hw(cp); + cp_enable_irq(cp); netif_wake_queue(dev); spin_unlock_irqrestore(&cp->lock, flags); } -#ifdef BROKEN static int cp_change_mtu(struct net_device *dev, int new_mtu) { struct cp_private *cp = netdev_priv(dev); - int rc; - unsigned long flags; /* check for invalid MTU, according to hardware limits */ if (new_mtu < CP_MIN_MTU || new_mtu > CP_MAX_MTU) @@ -1221,22 +1246,12 @@ static int cp_change_mtu(struct net_device *dev, int new_mtu) return 0; } - spin_lock_irqsave(&cp->lock, flags); - - cp_stop_hw(cp); /* stop h/w and free rings */ - cp_clean_rings(cp); - + /* network IS up, close it, reset MTU, and come up again. */ + cp_close(dev); dev->mtu = new_mtu; - cp_set_rxbufsize(cp); /* set new rx buf size */ - - rc = cp_init_rings(cp); /* realloc and restart h/w */ - cp_start_hw(cp); - - spin_unlock_irqrestore(&cp->lock, flags); - - return rc; + cp_set_rxbufsize(cp); + return cp_open(dev); } -#endif /* BROKEN */ static const char mii_2_8139_map[8] = { BasicModeCtrl, @@ -1812,9 +1827,7 @@ static const struct net_device_ops cp_netdev_ops = { .ndo_start_xmit = cp_start_xmit, .ndo_tx_timeout = cp_tx_timeout, .ndo_set_features = cp_set_features, -#ifdef BROKEN .ndo_change_mtu = cp_change_mtu, -#endif #ifdef CONFIG_NET_POLL_CONTROLLER .ndo_poll_controller = cp_poll_controller, |