diff options
Diffstat (limited to 'drivers/net/gianfar.c')
| -rw-r--r-- | drivers/net/gianfar.c | 68 |
1 files changed, 50 insertions, 18 deletions
diff --git a/drivers/net/gianfar.c b/drivers/net/gianfar.c index b666a0cc064..f92690555dd 100644 --- a/drivers/net/gianfar.c +++ b/drivers/net/gianfar.c @@ -130,6 +130,9 @@ static int gfar_remove(struct platform_device *pdev); static void free_skb_resources(struct gfar_private *priv); static void gfar_set_multi(struct net_device *dev); static void gfar_set_hash_for_addr(struct net_device *dev, u8 *addr); +static void gfar_configure_serdes(struct net_device *dev); +extern int gfar_local_mdio_write(struct gfar_mii *regs, int mii_id, int regnum, u16 value); +extern int gfar_local_mdio_read(struct gfar_mii *regs, int mii_id, int regnum); #ifdef CONFIG_GFAR_NAPI static int gfar_poll(struct net_device *dev, int *budget); #endif @@ -140,7 +143,6 @@ int gfar_clean_rx_ring(struct net_device *dev, int rx_work_limit); static int gfar_process_frame(struct net_device *dev, struct sk_buff *skb, int length); static void gfar_vlan_rx_register(struct net_device *netdev, struct vlan_group *grp); -static void gfar_vlan_rx_kill_vid(struct net_device *netdev, uint16_t vid); void gfar_halt(struct net_device *dev); void gfar_start(struct net_device *dev); static void gfar_clear_exact_match(struct net_device *dev); @@ -284,7 +286,6 @@ static int gfar_probe(struct platform_device *pdev) if (priv->einfo->device_flags & FSL_GIANFAR_DEV_HAS_VLAN) { dev->vlan_rx_register = gfar_vlan_rx_register; - dev->vlan_rx_kill_vid = gfar_vlan_rx_kill_vid; dev->features |= NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX; @@ -419,8 +420,18 @@ static phy_interface_t gfar_get_interface(struct net_device *dev) if (ecntrl & ECNTRL_REDUCED_MODE) { if (ecntrl & ECNTRL_REDUCED_MII_MODE) return PHY_INTERFACE_MODE_RMII; - else + else { + phy_interface_t interface = priv->einfo->interface; + + /* + * This isn't autodetected right now, so it must + * be set by the device tree or platform code. + */ + if (interface == PHY_INTERFACE_MODE_RGMII_ID) + return PHY_INTERFACE_MODE_RGMII_ID; + return PHY_INTERFACE_MODE_RGMII; + } } if (priv->einfo->device_flags & FSL_GIANFAR_DEV_HAS_GIGABIT) @@ -453,6 +464,9 @@ static int init_phy(struct net_device *dev) phydev = phy_connect(dev, phy_id, &adjust_link, 0, interface); + if (interface == PHY_INTERFACE_MODE_SGMII) + gfar_configure_serdes(dev); + if (IS_ERR(phydev)) { printk(KERN_ERR "%s: Could not attach to PHY\n", dev->name); return PTR_ERR(phydev); @@ -467,6 +481,27 @@ static int init_phy(struct net_device *dev) return 0; } +static void gfar_configure_serdes(struct net_device *dev) +{ + struct gfar_private *priv = netdev_priv(dev); + struct gfar_mii __iomem *regs = + (void __iomem *)&priv->regs->gfar_mii_regs; + + /* Initialise TBI i/f to communicate with serdes (lynx phy) */ + + /* Single clk mode, mii mode off(for aerdes communication) */ + gfar_local_mdio_write(regs, TBIPA_VALUE, MII_TBICON, TBICON_CLK_SELECT); + + /* Supported pause and full-duplex, no half-duplex */ + gfar_local_mdio_write(regs, TBIPA_VALUE, MII_ADVERTISE, + ADVERTISE_1000XFULL | ADVERTISE_1000XPAUSE | + ADVERTISE_1000XPSE_ASYM); + + /* ANEG enable, restart ANEG, full duplex mode, speed[1] set */ + gfar_local_mdio_write(regs, TBIPA_VALUE, MII_BMCR, BMCR_ANENABLE | + BMCR_ANRESTART | BMCR_FULLDPLX | BMCR_SPEED1000); +} + static void init_registers(struct net_device *dev) { struct gfar_private *priv = netdev_priv(dev); @@ -946,7 +981,7 @@ static inline void gfar_tx_checksum(struct sk_buff *skb, struct txfcb *fcb) flags |= TXFCB_UDP; fcb->phcs = udp_hdr(skb)->check; } else - fcb->phcs = udp_hdr(skb)->check; + fcb->phcs = tcp_hdr(skb)->check; /* l3os is the distance between the start of the * frame (skb->data) and the start of the IP hdr. @@ -1025,6 +1060,15 @@ static int gfar_start_xmit(struct sk_buff *skb, struct net_device *dev) dev->trans_start = jiffies; + /* The powerpc-specific eieio() is used, as wmb() has too strong + * semantics (it requires synchronization between cacheable and + * uncacheable mappings, which eieio doesn't provide and which we + * don't need), thus requiring a more expensive sync instruction. At + * some point, the set of architecture-independent barrier functions + * should be expanded to include weaker barriers. + */ + + eieio(); txbdp->status = status; /* If this was the last BD in the ring, the next one */ @@ -1124,20 +1168,6 @@ static void gfar_vlan_rx_register(struct net_device *dev, spin_unlock_irqrestore(&priv->rxlock, flags); } - -static void gfar_vlan_rx_kill_vid(struct net_device *dev, uint16_t vid) -{ - struct gfar_private *priv = netdev_priv(dev); - unsigned long flags; - - spin_lock_irqsave(&priv->rxlock, flags); - - vlan_group_set_device(priv->vlgrp, vid, NULL); - - spin_unlock_irqrestore(&priv->rxlock, flags); -} - - static int gfar_change_mtu(struct net_device *dev, int new_mtu) { int tempsize, tempval; @@ -1301,6 +1331,7 @@ struct sk_buff * gfar_new_skb(struct net_device *dev, struct rxbd8 *bdp) bdp->length = 0; /* Mark the buffer empty */ + eieio(); bdp->status |= (RXBD_EMPTY | RXBD_INTERRUPT); return skb; @@ -1484,6 +1515,7 @@ int gfar_clean_rx_ring(struct net_device *dev, int rx_work_limit) bdp = priv->cur_rx; while (!((bdp->status & RXBD_EMPTY) || (--rx_work_limit < 0))) { + rmb(); skb = priv->rx_skbuff[priv->skb_currx]; if (!(bdp->status & |