diff options
Diffstat (limited to 'drivers/net/ixgbe')
| -rw-r--r-- | drivers/net/ixgbe/ixgbe_82598.c | 24 | ||||
| -rw-r--r-- | drivers/net/ixgbe/ixgbe_dcb_82598.c | 4 |
2 files changed, 14 insertions, 14 deletions
diff --git a/drivers/net/ixgbe/ixgbe_82598.c b/drivers/net/ixgbe/ixgbe_82598.c index 7e09dab0c29..ad5699d9ab0 100644 --- a/drivers/net/ixgbe/ixgbe_82598.c +++ b/drivers/net/ixgbe/ixgbe_82598.c @@ -177,9 +177,9 @@ static s32 ixgbe_get_link_capabilities_82598(struct ixgbe_hw *hw, * * Determines the link capabilities by reading the AUTOC register. **/ -s32 ixgbe_get_copper_link_capabilities_82598(struct ixgbe_hw *hw, - ixgbe_link_speed *speed, - bool *autoneg) +static s32 ixgbe_get_copper_link_capabilities_82598(struct ixgbe_hw *hw, + ixgbe_link_speed *speed, + bool *autoneg) { s32 status = IXGBE_ERR_LINK_SETUP; u16 speed_ability; @@ -242,7 +242,7 @@ static enum ixgbe_media_type ixgbe_get_media_type_82598(struct ixgbe_hw *hw) * Configures the flow control settings based on SW configuration. This * function is used for 802.3x flow control configuration only. **/ -s32 ixgbe_setup_fc_82598(struct ixgbe_hw *hw, s32 packetbuf_num) +static s32 ixgbe_setup_fc_82598(struct ixgbe_hw *hw, s32 packetbuf_num) { u32 frctl_reg; u32 rmcs_reg; @@ -726,7 +726,7 @@ static s32 ixgbe_reset_hw_82598(struct ixgbe_hw *hw) * @rar: receive address register index to associate with a VMDq index * @vmdq: VMDq set index **/ -s32 ixgbe_set_vmdq_82598(struct ixgbe_hw *hw, u32 rar, u32 vmdq) +static s32 ixgbe_set_vmdq_82598(struct ixgbe_hw *hw, u32 rar, u32 vmdq) { u32 rar_high; @@ -770,8 +770,8 @@ static s32 ixgbe_clear_vmdq_82598(struct ixgbe_hw *hw, u32 rar, u32 vmdq) * * Turn on/off specified VLAN in the VLAN filter table. **/ -s32 ixgbe_set_vfta_82598(struct ixgbe_hw *hw, u32 vlan, u32 vind, - bool vlan_on) +static s32 ixgbe_set_vfta_82598(struct ixgbe_hw *hw, u32 vlan, u32 vind, + bool vlan_on) { u32 regindex; u32 bitindex; @@ -894,7 +894,7 @@ static s32 ixgbe_blink_led_stop_82598(struct ixgbe_hw *hw, u32 index) * * Performs read operation to Atlas analog register specified. **/ -s32 ixgbe_read_analog_reg8_82598(struct ixgbe_hw *hw, u32 reg, u8 *val) +static s32 ixgbe_read_analog_reg8_82598(struct ixgbe_hw *hw, u32 reg, u8 *val) { u32 atlas_ctl; @@ -916,7 +916,7 @@ s32 ixgbe_read_analog_reg8_82598(struct ixgbe_hw *hw, u32 reg, u8 *val) * * Performs write operation to Atlas analog register specified. **/ -s32 ixgbe_write_analog_reg8_82598(struct ixgbe_hw *hw, u32 reg, u8 val) +static s32 ixgbe_write_analog_reg8_82598(struct ixgbe_hw *hw, u32 reg, u8 val) { u32 atlas_ctl; @@ -937,8 +937,8 @@ s32 ixgbe_write_analog_reg8_82598(struct ixgbe_hw *hw, u32 reg, u8 val) * * Performs byte read operation to SFP module's EEPROM over I2C interface. **/ -s32 ixgbe_read_i2c_eeprom_82598(struct ixgbe_hw *hw, u8 byte_offset, - u8 *eeprom_data) +static s32 ixgbe_read_i2c_eeprom_82598(struct ixgbe_hw *hw, u8 byte_offset, + u8 *eeprom_data) { s32 status = 0; u16 sfp_addr = 0; @@ -997,7 +997,7 @@ out: * * Determines physical layer capabilities of the current configuration. **/ -s32 ixgbe_get_supported_physical_layer_82598(struct ixgbe_hw *hw) +static s32 ixgbe_get_supported_physical_layer_82598(struct ixgbe_hw *hw) { s32 physical_layer = IXGBE_PHYSICAL_LAYER_UNKNOWN; diff --git a/drivers/net/ixgbe/ixgbe_dcb_82598.c b/drivers/net/ixgbe/ixgbe_dcb_82598.c index fce6867a451..2c046b0b5d2 100644 --- a/drivers/net/ixgbe/ixgbe_dcb_82598.c +++ b/drivers/net/ixgbe/ixgbe_dcb_82598.c @@ -97,8 +97,8 @@ s32 ixgbe_dcb_get_pfc_stats_82598(struct ixgbe_hw *hw, * * Configure packet buffers for DCB mode. */ -s32 ixgbe_dcb_config_packet_buffers_82598(struct ixgbe_hw *hw, - struct ixgbe_dcb_config *dcb_config) +static s32 ixgbe_dcb_config_packet_buffers_82598(struct ixgbe_hw *hw, + struct ixgbe_dcb_config *dcb_config) { s32 ret_val = 0; u32 value = IXGBE_RXPBSIZE_64KB; |