diff options
Diffstat (limited to 'drivers/net/sfc/spi.h')
| -rw-r--r-- | drivers/net/sfc/spi.h | 89 |
1 files changed, 42 insertions, 47 deletions
diff --git a/drivers/net/sfc/spi.h b/drivers/net/sfc/spi.h index 34412f3d41c..feef6194237 100644 --- a/drivers/net/sfc/spi.h +++ b/drivers/net/sfc/spi.h @@ -19,53 +19,48 @@ * *************************************************************************/ -/* - * Commands common to all known devices. - * +#define SPI_WRSR 0x01 /* Write status register */ +#define SPI_WRITE 0x02 /* Write data to memory array */ +#define SPI_READ 0x03 /* Read data from memory array */ +#define SPI_WRDI 0x04 /* Reset write enable latch */ +#define SPI_RDSR 0x05 /* Read status register */ +#define SPI_WREN 0x06 /* Set write enable latch */ + +#define SPI_STATUS_WPEN 0x80 /* Write-protect pin enabled */ +#define SPI_STATUS_BP2 0x10 /* Block protection bit 2 */ +#define SPI_STATUS_BP1 0x08 /* Block protection bit 1 */ +#define SPI_STATUS_BP0 0x04 /* Block protection bit 0 */ +#define SPI_STATUS_WEN 0x02 /* State of the write enable latch */ +#define SPI_STATUS_NRDY 0x01 /* Device busy flag */ + +/** + * struct efx_spi_device - an Efx SPI (Serial Peripheral Interface) device + * @efx: The Efx controller that owns this device + * @device_id: Controller's id for the device + * @size: Size (in bytes) + * @addr_len: Number of address bytes in read/write commands + * @munge_address: Flag whether addresses should be munged. + * Some devices with 9-bit addresses (e.g. AT25040A EEPROM) + * use bit 3 of the command byte as address bit A8, rather + * than having a two-byte address. If this flag is set, then + * commands should be munged in this way. + * @block_size: Write block size (in bytes). + * Write commands are limited to blocks with this size and alignment. + * @read: Read function for the device + * @write: Write function for the device */ - -/* Write status register */ -#define SPI_WRSR 0x01 - -/* Write data to memory array */ -#define SPI_WRITE 0x02 - -/* Read data from memory array */ -#define SPI_READ 0x03 - -/* Reset write enable latch */ -#define SPI_WRDI 0x04 - -/* Read status register */ -#define SPI_RDSR 0x05 - -/* Set write enable latch */ -#define SPI_WREN 0x06 - -/* SST: Enable write to status register */ -#define SPI_SST_EWSR 0x50 - -/* - * Status register bits. Not all bits are supported on all devices. - * - */ - -/* Write-protect pin enabled */ -#define SPI_STATUS_WPEN 0x80 - -/* Block protection bit 2 */ -#define SPI_STATUS_BP2 0x10 - -/* Block protection bit 1 */ -#define SPI_STATUS_BP1 0x08 - -/* Block protection bit 0 */ -#define SPI_STATUS_BP0 0x04 - -/* State of the write enable latch */ -#define SPI_STATUS_WEN 0x02 - -/* Device busy flag */ -#define SPI_STATUS_NRDY 0x01 +struct efx_spi_device { + struct efx_nic *efx; + int device_id; + unsigned int size; + unsigned int addr_len; + unsigned int munge_address:1; + unsigned int block_size; +}; + +int falcon_spi_read(const struct efx_spi_device *spi, loff_t start, + size_t len, size_t *retlen, u8 *buffer); +int falcon_spi_write(const struct efx_spi_device *spi, loff_t start, + size_t len, size_t *retlen, const u8 *buffer); #endif /* EFX_SPI_H */ |