diff options
Diffstat (limited to 'drivers/net/sky2.c')
-rw-r--r-- | drivers/net/sky2.c | 175 |
1 files changed, 153 insertions, 22 deletions
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c index 3bb60530d4d..c83406f4f2a 100644 --- a/drivers/net/sky2.c +++ b/drivers/net/sky2.c @@ -284,6 +284,86 @@ static void sky2_power_aux(struct sky2_hw *hw) PC_VAUX_ON | PC_VCC_OFF)); } +static void sky2_power_state(struct sky2_hw *hw, pci_power_t state) +{ + u16 power_control = sky2_pci_read16(hw, hw->pm_cap + PCI_PM_CTRL); + int pex = pci_find_capability(hw->pdev, PCI_CAP_ID_EXP); + u32 reg; + + sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON); + + switch (state) { + case PCI_D0: + break; + + case PCI_D1: + power_control |= 1; + break; + + case PCI_D2: + power_control |= 2; + break; + + case PCI_D3hot: + case PCI_D3cold: + power_control |= 3; + if (hw->flags & SKY2_HW_ADV_POWER_CTL) { + /* additional power saving measurements */ + reg = sky2_pci_read32(hw, PCI_DEV_REG4); + + /* set gating core clock for LTSSM in L1 state */ + reg |= P_PEX_LTSSM_STAT(P_PEX_LTSSM_L1_STAT) | + /* auto clock gated scheme controlled by CLKREQ */ + P_ASPM_A1_MODE_SELECT | + /* enable Gate Root Core Clock */ + P_CLK_GATE_ROOT_COR_ENA; + + if (pex && (hw->flags & SKY2_HW_CLK_POWER)) { + /* enable Clock Power Management (CLKREQ) */ + u16 ctrl = sky2_pci_read16(hw, pex + PCI_EXP_DEVCTL); + + ctrl |= PCI_EXP_DEVCTL_AUX_PME; + sky2_pci_write16(hw, pex + PCI_EXP_DEVCTL, ctrl); + } else + /* force CLKREQ Enable in Our4 (A1b only) */ + reg |= P_ASPM_FORCE_CLKREQ_ENA; + + /* set Mask Register for Release/Gate Clock */ + sky2_pci_write32(hw, PCI_DEV_REG5, + P_REL_PCIE_EXIT_L1_ST | P_GAT_PCIE_ENTER_L1_ST | + P_REL_PCIE_RX_EX_IDLE | P_GAT_PCIE_RX_EL_IDLE | + P_REL_GPHY_LINK_UP | P_GAT_GPHY_LINK_DOWN); + } else + sky2_write8(hw, B28_Y2_ASF_STAT_CMD, Y2_ASF_CLK_HALT); + + /* put CPU into reset state */ + sky2_write8(hw, B28_Y2_ASF_STAT_CMD, HCU_CCSR_ASF_RESET); + if (hw->chip_id == CHIP_ID_YUKON_SUPR && hw->chip_rev == CHIP_REV_YU_SU_A0) + /* put CPU into halt state */ + sky2_write8(hw, B28_Y2_ASF_STAT_CMD, HCU_CCSR_ASF_HALTED); + + if (pex && !(hw->flags & SKY2_HW_RAM_BUFFER)) { + reg = sky2_pci_read32(hw, PCI_DEV_REG1); + /* force to PCIe L1 */ + reg |= PCI_FORCE_PEX_L1; + sky2_pci_write32(hw, PCI_DEV_REG1, reg); + } + break; + + default: + dev_warn(&hw->pdev->dev, PFX "Invalid power state (%d) ", + state); + return; + } + + power_control |= PCI_PM_CTRL_PME_ENABLE; + /* Finally, set the new power state. */ + sky2_pci_write32(hw, hw->pm_cap + PCI_PM_CTRL, power_control); + + sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF); + sky2_pci_read32(hw, B0_CTST); +} + static void sky2_gmac_reset(struct sky2_hw *hw, unsigned port) { u16 reg; @@ -619,28 +699,71 @@ static void sky2_phy_init(struct sky2_hw *hw, unsigned port) gm_phy_write(hw, port, PHY_MARV_INT_MASK, PHY_M_DEF_MSK); } -static void sky2_phy_power(struct sky2_hw *hw, unsigned port, int onoff) +static const u32 phy_power[] = { PCI_Y2_PHY1_POWD, PCI_Y2_PHY2_POWD }; +static const u32 coma_mode[] = { PCI_Y2_PHY1_COMA, PCI_Y2_PHY2_COMA }; + +static void sky2_phy_power_up(struct sky2_hw *hw, unsigned port) { u32 reg1; - static const u32 phy_power[] = { PCI_Y2_PHY1_POWD, PCI_Y2_PHY2_POWD }; - static const u32 coma_mode[] = { PCI_Y2_PHY1_COMA, PCI_Y2_PHY2_COMA }; sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON); reg1 = sky2_pci_read32(hw, PCI_DEV_REG1); - /* Turn on/off phy power saving */ - if (onoff) - reg1 &= ~phy_power[port]; - else - reg1 |= phy_power[port]; + reg1 &= ~phy_power[port]; - if (onoff && hw->chip_id == CHIP_ID_YUKON_XL && hw->chip_rev > 1) + if (hw->chip_id == CHIP_ID_YUKON_XL && hw->chip_rev > 1) reg1 |= coma_mode[port]; sky2_pci_write32(hw, PCI_DEV_REG1, reg1); sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF); sky2_pci_read32(hw, PCI_DEV_REG1); +} + +static void sky2_phy_power_down(struct sky2_hw *hw, unsigned port) +{ + u32 reg1; + u16 ctrl; + + /* release GPHY Control reset */ + sky2_write8(hw, SK_REG(port, GPHY_CTRL), GPC_RST_CLR); - udelay(100); + /* release GMAC reset */ + sky2_write8(hw, SK_REG(port, GMAC_CTRL), GMC_RST_CLR); + + if (hw->flags & SKY2_HW_NEWER_PHY) { + /* select page 2 to access MAC control register */ + gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 2); + + ctrl = gm_phy_read(hw, port, PHY_MARV_PHY_CTRL); + /* allow GMII Power Down */ + ctrl &= ~PHY_M_MAC_GMIF_PUP; + gm_phy_write(hw, port, PHY_MARV_PHY_CTRL, ctrl); + + /* set page register back to 0 */ + gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0); + } + + /* setup General Purpose Control Register */ + gma_write16(hw, port, GM_GP_CTRL, + GM_GPCR_FL_PASS | GM_GPCR_SPEED_100 | GM_GPCR_AU_ALL_DIS); + + if (hw->chip_id != CHIP_ID_YUKON_EC) { + if (hw->chip_id == CHIP_ID_YUKON_EC_U) { + ctrl = gm_phy_read(hw, port, PHY_MARV_PHY_CTRL); + + /* enable Power Down */ + ctrl |= PHY_M_PC_POW_D_ENA; + gm_phy_write(hw, port, PHY_MARV_PHY_CTRL, ctrl); + } + + /* set IEEE compatible Power Down Mode (dev. #4.99) */ + gm_phy_write(hw, port, PHY_MARV_CTRL, PHY_CT_PDOWN); + } + + sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON); + reg1 = sky2_pci_read32(hw, PCI_DEV_REG1); + reg1 |= phy_power[port]; /* set PHY to PowerDown/COMA Mode */ + sky2_pci_write32(hw, PCI_DEV_REG1, reg1); + sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF); } /* Force a renegotiation */ @@ -675,8 +798,11 @@ static void sky2_wol_init(struct sky2_port *sky2) sky2->advertising &= ~(ADVERTISED_1000baseT_Half|ADVERTISED_1000baseT_Full); sky2->flow_mode = FC_NONE; - sky2_phy_power(hw, port, 1); - sky2_phy_reinit(sky2); + + spin_lock_bh(&sky2->phy_lock); + sky2_phy_power_up(hw, port); + sky2_phy_init(hw, port); + spin_unlock_bh(&sky2->phy_lock); sky2->flow_mode = save_mode; sky2->advertising = ctrl; @@ -781,6 +907,7 @@ static void sky2_mac_init(struct sky2_hw *hw, unsigned port) sky2_write8(hw, SK_REG(port, GMAC_IRQ_MSK), GMAC_DEF_MSK); spin_lock_bh(&sky2->phy_lock); + sky2_phy_power_up(hw, port); sky2_phy_init(hw, port); spin_unlock_bh(&sky2->phy_lock); @@ -1385,8 +1512,6 @@ static int sky2_up(struct net_device *dev) if (!sky2->rx_ring) goto err_out; - sky2_phy_power(hw, port, 1); - sky2_mac_init(hw, port); /* Register is number of 4K blocks on internal RAM buffer. */ @@ -1767,7 +1892,7 @@ static int sky2_down(struct net_device *dev) sky2_write8(hw, SK_REG(port, RX_GMF_CTRL_T), GMF_RST_SET); sky2_write8(hw, SK_REG(port, TX_GMF_CTRL_T), GMF_RST_SET); - sky2_phy_power(hw, port, 0); + sky2_phy_power_down(hw, port); netif_carrier_off(dev); @@ -2741,6 +2866,10 @@ static int __devinit sky2_init(struct sky2_hw *hw) hw->flags = SKY2_HW_GIGABIT | SKY2_HW_NEWER_PHY | SKY2_HW_ADV_POWER_CTL; + + /* check for Rev. A1 dev 4200 */ + if (sky2_read16(hw, Q_ADDR(Q_XA1, Q_WM)) == 0) + hw->flags |= SKY2_HW_CLK_POWER; break; case CHIP_ID_YUKON_EX: @@ -2791,6 +2920,11 @@ static int __devinit sky2_init(struct sky2_hw *hw) if (hw->pmd_type == 'L' || hw->pmd_type == 'S' || hw->pmd_type == 'P') hw->flags |= SKY2_HW_FIBRE_PHY; + hw->pm_cap = pci_find_capability(hw->pdev, PCI_CAP_ID_PM); + if (hw->pm_cap == 0) { + dev_err(&hw->pdev->dev, "cannot find PowerManagement capability\n"); + return -EIO; + } hw->ports = 1; t8 = sky2_read8(hw, B2_Y2_HW_RES); @@ -3378,7 +3512,7 @@ static void sky2_led(struct sky2_port *sky2, enum led_mode mode) gm_phy_write(hw, port, PHY_MARV_EXT_ADR, pg); } else - gm_phy_write(hw, port, PHY_MARV_LED_OVER, + gm_phy_write(hw, port, PHY_MARV_LED_OVER, PHY_M_LED_MO_DUP(mode) | PHY_M_LED_MO_10(mode) | PHY_M_LED_MO_100(mode) | @@ -4362,7 +4496,7 @@ static int sky2_suspend(struct pci_dev *pdev, pm_message_t state) pci_save_state(pdev); pci_enable_wake(pdev, pci_choose_state(pdev, state), wol); - pci_set_power_state(pdev, pci_choose_state(pdev, state)); + sky2_power_state(hw, pci_choose_state(pdev, state)); return 0; } @@ -4375,9 +4509,7 @@ static int sky2_resume(struct pci_dev *pdev) if (!hw) return 0; - err = pci_set_power_state(pdev, PCI_D0); - if (err) - goto out; + sky2_power_state(hw, PCI_D0); err = pci_restore_state(pdev); if (err) @@ -4445,8 +4577,7 @@ static void sky2_shutdown(struct pci_dev *pdev) pci_enable_wake(pdev, PCI_D3cold, wol); pci_disable_device(pdev); - pci_set_power_state(pdev, PCI_D3hot); - + sky2_power_state(hw, PCI_D3hot); } static struct pci_driver sky2_driver = { |