summaryrefslogtreecommitdiffstats
path: root/drivers/net/wireless/Kconfig
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/wireless/Kconfig')
-rw-r--r--drivers/net/wireless/Kconfig23
1 files changed, 6 insertions, 17 deletions
diff --git a/drivers/net/wireless/Kconfig b/drivers/net/wireless/Kconfig
index 2e8ac995d56..bd4a68c85a4 100644
--- a/drivers/net/wireless/Kconfig
+++ b/drivers/net/wireless/Kconfig
@@ -271,25 +271,14 @@ config IPW2200_DEBUG
bool "Enable full debugging output in IPW2200 module."
depends on IPW2200
---help---
- This option will enable debug tracing output for the IPW2200.
+ This option will enable low level debug tracing output for IPW2200.
- This will result in the kernel module being ~100k larger. You can
- control which debug output is sent to the kernel log by setting the
- value in
-
- /sys/bus/pci/drivers/ipw2200/debug_level
-
- This entry will only exist if this option is enabled.
+ Note, normal debug code is already compiled in. This low level
+ debug option enables debug on hot paths (e.g Tx, Rx, ISR) and
+ will result in the kernel module being ~70 larger. Most users
+ will typically not need this high verbosity debug information.
- To set a value, simply echo an 8-byte hex value to the same file:
-
- % echo 0x00000FFO > /sys/bus/pci/drivers/ipw2200/debug_level
-
- You can find the list of debug mask values in
- drivers/net/wireless/ipw2200.h
-
- If you are not trying to debug or develop the IPW2200 driver, you
- most likely want to say N here.
+ If you are not sure, say N here.
config AIRO
tristate "Cisco/Aironet 34X/35X/4500/4800 ISA and PCI cards"