diff options
Diffstat (limited to 'drivers/net/wireless/ath/ath5k/phy.c')
| -rw-r--r-- | drivers/net/wireless/ath/ath5k/phy.c | 15 |
1 files changed, 6 insertions, 9 deletions
diff --git a/drivers/net/wireless/ath/ath5k/phy.c b/drivers/net/wireless/ath/ath5k/phy.c index 6284c389ba1..c7c44659237 100644 --- a/drivers/net/wireless/ath/ath5k/phy.c +++ b/drivers/net/wireless/ath/ath5k/phy.c @@ -115,7 +115,7 @@ static unsigned int ath5k_hw_rfb_op(struct ath5k_hw *ah, \**********************/ /* - * This code is used to optimize rf gain on different environments + * This code is used to optimize RF gain on different environments * (temperature mostly) based on feedback from a power detector. * * It's only used on RF5111 and RF5112, later RF chips seem to have @@ -302,7 +302,7 @@ static bool ath5k_hw_rf_check_gainf_readback(struct ath5k_hw *ah) } /* Perform gain_F adjustment by choosing the right set - * of parameters from rf gain optimization ladder */ + * of parameters from RF gain optimization ladder */ static s8 ath5k_hw_rf_gainf_adjust(struct ath5k_hw *ah) { const struct ath5k_gain_opt *go; @@ -367,7 +367,7 @@ done: return ret; } -/* Main callback for thermal rf gain calibration engine +/* Main callback for thermal RF gain calibration engine * Check for a new gain reading and schedule an adjustment * if needed. * @@ -433,7 +433,7 @@ done: return ah->ah_gain.g_state; } -/* Write initial rf gain table to set the RF sensitivity +/* Write initial RF gain table to set the RF sensitivity * this one works on all RF chips and has nothing to do * with gain_F calibration */ int ath5k_hw_rfgain_init(struct ath5k_hw *ah, unsigned int freq) @@ -496,7 +496,7 @@ int ath5k_hw_rfgain_init(struct ath5k_hw *ah, unsigned int freq) /* - * Setup RF registers by writing rf buffer on hw + * Setup RF registers by writing RF buffer on hw */ int ath5k_hw_rfregs_init(struct ath5k_hw *ah, struct ieee80211_channel *channel, unsigned int mode) @@ -571,7 +571,7 @@ int ath5k_hw_rfregs_init(struct ath5k_hw *ah, struct ieee80211_channel *channel, return -EINVAL; } - /* If it's the first time we set rf buffer, allocate + /* If it's the first time we set RF buffer, allocate * ah->ah_rf_banks based on ah->ah_rf_banks_size * we set above */ if (ah->ah_rf_banks == NULL) { @@ -3035,9 +3035,6 @@ ath5k_hw_txpower(struct ath5k_hw *ah, struct ieee80211_channel *channel, /* Limit max power if we have a CTL available */ ath5k_get_max_ctl_power(ah, channel); - /* FIXME: Tx power limit for this regdomain - * XXX: Mac80211/CRDA will do that anyway ? */ - /* FIXME: Antenna reduction stuff */ /* FIXME: Limit power on turbo modes */ |