diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-agn.c')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-agn.c | 36 |
1 files changed, 23 insertions, 13 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn.c b/drivers/net/wireless/iwlwifi/iwl-agn.c index ed09e48b1b6..e01f048a02d 100644 --- a/drivers/net/wireless/iwlwifi/iwl-agn.c +++ b/drivers/net/wireless/iwlwifi/iwl-agn.c @@ -29,7 +29,6 @@ #include <linux/kernel.h> #include <linux/module.h> -#include <linux/version.h> #include <linux/init.h> #include <linux/pci.h> #include <linux/dma-mapping.h> @@ -182,14 +181,14 @@ static int iwl4965_check_rxon_cmd(struct iwl_rxon_cmd *rxon) } /** - * iwl4965_full_rxon_required - check if full RXON (vs RXON_ASSOC) cmd is needed + * iwl_full_rxon_required - check if full RXON (vs RXON_ASSOC) cmd is needed * @priv: staging_rxon is compared to active_rxon * * If the RXON structure is changing enough to require a new tune, * or is clearing the RXON_FILTER_ASSOC_MSK, then return 1 to indicate that * a new tune (full RXON command, rather than RXON_ASSOC cmd) is required. */ -static int iwl4965_full_rxon_required(struct iwl_priv *priv) +static int iwl_full_rxon_required(struct iwl_priv *priv) { /* These items are only settable from the full RXON command */ @@ -208,7 +207,6 @@ static int iwl4965_full_rxon_required(struct iwl_priv *priv) priv->active_rxon.ofdm_ht_single_stream_basic_rates) || (priv->staging_rxon.ofdm_ht_dual_stream_basic_rates != priv->active_rxon.ofdm_ht_dual_stream_basic_rates) || - (priv->staging_rxon.rx_chain != priv->active_rxon.rx_chain) || (priv->staging_rxon.assoc_id != priv->active_rxon.assoc_id)) return 1; @@ -264,7 +262,7 @@ static int iwl4965_commit_rxon(struct iwl_priv *priv) /* If we don't need to send a full RXON, we can use * iwl4965_rxon_assoc_cmd which is used to reconfigure filter * and other flags for the current radio configuration. */ - if (!iwl4965_full_rxon_required(priv)) { + if (!iwl_full_rxon_required(priv)) { ret = iwl_send_rxon_assoc(priv); if (ret) { IWL_ERROR("Error setting RXON_ASSOC (%d)\n", ret); @@ -588,8 +586,6 @@ static void iwl4965_ht_conf(struct iwl_priv *priv, iwl_conf->supported_chan_width = 0; } - iwl_conf->tx_mimo_ps_mode = - (u8)((ht_conf->cap & IEEE80211_HT_CAP_MIMO_PS) >> 2); memcpy(iwl_conf->supp_mcs_set, ht_conf->supp_mcs_set, 16); iwl_conf->control_channel = ht_bss_conf->primary_channel; @@ -2191,7 +2187,10 @@ static void __iwl4965_down(struct iwl_priv *priv) udelay(5); /* FIXME: apm_ops.suspend(priv) */ - priv->cfg->ops->lib->apm_ops.reset(priv); + if (exit_pending || test_bit(STATUS_IN_SUSPEND, &priv->status)) + priv->cfg->ops->lib->apm_ops.stop(priv); + else + priv->cfg->ops->lib->apm_ops.reset(priv); priv->cfg->ops->lib->free_shared_mem(priv); exit: @@ -2603,6 +2602,7 @@ static int iwl4965_mac_start(struct ieee80211_hw *hw) { struct iwl_priv *priv = hw->priv; int ret; + u16 pci_cmd; IWL_DEBUG_MAC80211("enter\n"); @@ -2613,6 +2613,13 @@ static int iwl4965_mac_start(struct ieee80211_hw *hw) pci_restore_state(priv->pci_dev); pci_enable_msi(priv->pci_dev); + /* enable interrupts if needed: hw bug w/a */ + pci_read_config_word(priv->pci_dev, PCI_COMMAND, &pci_cmd); + if (pci_cmd & PCI_COMMAND_INTX_DISABLE) { + pci_cmd &= ~PCI_COMMAND_INTX_DISABLE; + pci_write_config_word(priv->pci_dev, PCI_COMMAND, pci_cmd); + } + ret = request_irq(priv->pci_dev->irq, iwl4965_isr, IRQF_SHARED, DRV_NAME, priv); if (ret) { @@ -3581,7 +3588,7 @@ static int iwl4965_mac_beacon_update(struct ieee80211_hw *hw, struct sk_buff *sk priv->assoc_id = 0; timestamp = ((struct ieee80211_mgmt *)skb->data)->u.beacon.timestamp; - priv->timestamp = le64_to_cpu(timestamp) + (priv->beacon_int * 1000); + priv->timestamp = le64_to_cpu(timestamp); IWL_DEBUG_MAC80211("leave\n"); spin_unlock_irqrestore(&priv->lock, flags); @@ -4365,15 +4372,18 @@ static void __devexit iwl4965_pci_remove(struct pci_dev *pdev) iwl_dbgfs_unregister(priv); sysfs_remove_group(&pdev->dev.kobj, &iwl4965_attribute_group); + /* ieee80211_unregister_hw call wil cause iwl4965_mac_stop to + * to be called and iwl4965_down since we are removing the device + * we need to set STATUS_EXIT_PENDING bit. + */ + set_bit(STATUS_EXIT_PENDING, &priv->status); if (priv->mac80211_registered) { ieee80211_unregister_hw(priv->hw); priv->mac80211_registered = 0; + } else { + iwl4965_down(priv); } - set_bit(STATUS_EXIT_PENDING, &priv->status); - - iwl4965_down(priv); - /* make sure we flush any pending irq or * tasklet for the driver */ |