diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-csr.h')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-csr.h | 38 |
1 files changed, 38 insertions, 0 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-csr.h b/drivers/net/wireless/iwlwifi/iwl-csr.h index f13dec9ad9c..fe129c94ae3 100644 --- a/drivers/net/wireless/iwlwifi/iwl-csr.h +++ b/drivers/net/wireless/iwlwifi/iwl-csr.h @@ -139,6 +139,13 @@ #define CSR_ANA_PLL_CFG (CSR_BASE+0x20c) /* + * CSR HW resources monitor registers + */ +#define CSR_MONITOR_CFG_REG (CSR_BASE+0x214) +#define CSR_MONITOR_STATUS_REG (CSR_BASE+0x228) +#define CSR_MONITOR_XTAL_RESOURCES (0x00000010) + +/* * CSR Hardware Revision Workaround Register. Indicates hardware rev; * "step" determines CCK backoff for txpower calculation. Used for 4965 only. * See also CSR_HW_REV register. @@ -173,6 +180,7 @@ #define CSR_HW_IF_CONFIG_REG_BIT_NIC_READY (0x00400000) /* PCI_OWN_SEM */ #define CSR_HW_IF_CONFIG_REG_BIT_NIC_PREPARE_DONE (0x02000000) /* ME_OWN */ #define CSR_HW_IF_CONFIG_REG_PREPARE (0x08000000) /* WAKE_ME */ +#define CSR_HW_IF_CONFIG_REG_PERSIST_MODE (0x40000000) /* PERSISTENCE */ #define CSR_INT_PERIODIC_DIS (0x00) /* disable periodic int*/ #define CSR_INT_PERIODIC_ENA (0xFF) /* 255*32 usec ~ 8 msec*/ @@ -240,6 +248,7 @@ * 001 -- MAC power-down * 010 -- PHY (radio) power-down * 011 -- Error + * 10: XTAL ON request * 9-6: SYS_CONFIG * Indicates current system configuration, reflecting pins on chip * as forced high/low by device circuit board. @@ -271,6 +280,7 @@ #define CSR_GP_CNTRL_REG_FLAG_INIT_DONE (0x00000004) #define CSR_GP_CNTRL_REG_FLAG_MAC_ACCESS_REQ (0x00000008) #define CSR_GP_CNTRL_REG_FLAG_GOING_TO_SLEEP (0x00000010) +#define CSR_GP_CNTRL_REG_FLAG_XTAL_ON (0x00000400) #define CSR_GP_CNTRL_REG_VAL_MAC_ACCESS_EN (0x00000001) @@ -396,6 +406,34 @@ #define CSR_DRAM_INIT_TBL_WRAP_CHECK (1 << 27) /* + * SHR target access (Shared block memory space) + * + * Shared internal registers can be accessed directly from PCI bus through SHR + * arbiter without need for the MAC HW to be powered up. This is possible due to + * indirect read/write via HEEP_CTRL_WRD_PCIEX_CTRL (0xEC) and + * HEEP_CTRL_WRD_PCIEX_DATA (0xF4) registers. + * + * Use iwl_write32()/iwl_read32() family to access these registers. The MAC HW + * need not be powered up so no "grab inc access" is required. + */ + +/* + * Registers for accessing shared registers (e.g. SHR_APMG_GP1, + * SHR_APMG_XTAL_CFG). For example, to read from SHR_APMG_GP1 register (0x1DC), + * first, write to the control register: + * HEEP_CTRL_WRD_PCIEX_CTRL[15:0] = 0x1DC (offset of the SHR_APMG_GP1 register) + * HEEP_CTRL_WRD_PCIEX_CTRL[29:28] = 2 (read access) + * second, read from the data register HEEP_CTRL_WRD_PCIEX_DATA[31:0]. + * + * To write the register, first, write to the data register + * HEEP_CTRL_WRD_PCIEX_DATA[31:0] and then: + * HEEP_CTRL_WRD_PCIEX_CTRL[15:0] = 0x1DC (offset of the SHR_APMG_GP1 register) + * HEEP_CTRL_WRD_PCIEX_CTRL[29:28] = 3 (write access) + */ +#define HEEP_CTRL_WRD_PCIEX_CTRL_REG (CSR_BASE+0x0ec) +#define HEEP_CTRL_WRD_PCIEX_DATA_REG (CSR_BASE+0x0f4) + +/* * HBUS (Host-side Bus) * * HBUS registers are mapped directly into PCI bus space, but are used |