diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-trans.h')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-trans.h | 38 |
1 files changed, 38 insertions, 0 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-trans.h b/drivers/net/wireless/iwlwifi/iwl-trans.h index 1f065cf4a4b..7b19274b550 100644 --- a/drivers/net/wireless/iwlwifi/iwl-trans.h +++ b/drivers/net/wireless/iwlwifi/iwl-trans.h @@ -193,12 +193,23 @@ static inline u32 iwl_rx_packet_payload_len(const struct iwl_rx_packet *pkt) * @CMD_ASYNC: Return right away and don't wait for the response * @CMD_WANT_SKB: valid only with CMD_SYNC. The caller needs the buffer of the * response. The caller needs to call iwl_free_resp when done. + * @CMD_HIGH_PRIO: The command is high priority - it goes to the front of the + * command queue, but after other high priority commands. valid only + * with CMD_ASYNC. + * @CMD_SEND_IN_IDLE: The command should be sent even when the trans is idle. + * @CMD_MAKE_TRANS_IDLE: The command response should mark the trans as idle. + * @CMD_WAKE_UP_TRANS: The command response should wake up the trans + * (i.e. mark it as non-idle). */ enum CMD_MODE { CMD_SYNC = 0, CMD_ASYNC = BIT(0), CMD_WANT_SKB = BIT(1), CMD_SEND_IN_RFKILL = BIT(2), + CMD_HIGH_PRIO = BIT(3), + CMD_SEND_IN_IDLE = BIT(4), + CMD_MAKE_TRANS_IDLE = BIT(5), + CMD_WAKE_UP_TRANS = BIT(6), }; #define DEF_CMD_PAYLOAD_SIZE 320 @@ -335,6 +346,9 @@ enum iwl_d3_status { * @STATUS_INT_ENABLED: interrupts are enabled * @STATUS_RFKILL: the HW RFkill switch is in KILL position * @STATUS_FW_ERROR: the fw is in error state + * @STATUS_TRANS_GOING_IDLE: shutting down the trans, only special commands + * are sent + * @STATUS_TRANS_IDLE: the trans is idle - general commands are not to be sent */ enum iwl_trans_status { STATUS_SYNC_HCMD_ACTIVE, @@ -343,6 +357,8 @@ enum iwl_trans_status { STATUS_INT_ENABLED, STATUS_RFKILL, STATUS_FW_ERROR, + STATUS_TRANS_GOING_IDLE, + STATUS_TRANS_IDLE, }; /** @@ -443,6 +459,11 @@ struct iwl_trans; * @release_nic_access: let the NIC go to sleep. The "flags" parameter * must be the same one that was sent before to the grab_nic_access. * @set_bits_mask - set SRAM register according to value and mask. + * @ref: grab a reference to the transport/FW layers, disallowing + * certain low power states + * @unref: release a reference previously taken with @ref. Note that + * initially the reference count is 1, making an initial @unref + * necessary to allow low power states. */ struct iwl_trans_ops { @@ -489,6 +510,8 @@ struct iwl_trans_ops { unsigned long *flags); void (*set_bits_mask)(struct iwl_trans *trans, u32 reg, u32 mask, u32 value); + void (*ref)(struct iwl_trans *trans); + void (*unref)(struct iwl_trans *trans); }; /** @@ -523,6 +546,7 @@ enum iwl_trans_state { * starting the firmware, used for tracing * @rx_mpdu_cmd_hdr_size: used for tracing, amount of data before the * start of the 802.11 header in the @rx_mpdu_cmd + * @dflt_pwr_limit: default power limit fetched from the platform (ACPI) */ struct iwl_trans { const struct iwl_trans_ops *ops; @@ -551,6 +575,8 @@ struct iwl_trans { struct lockdep_map sync_cmd_lockdep_map; #endif + u64 dflt_pwr_limit; + /* pointer to trans specific struct */ /*Ensure that this pointer will always be aligned to sizeof pointer */ char trans_specific[0] __aligned(sizeof(void *)); @@ -627,6 +653,18 @@ static inline int iwl_trans_d3_resume(struct iwl_trans *trans, return trans->ops->d3_resume(trans, status, test); } +static inline void iwl_trans_ref(struct iwl_trans *trans) +{ + if (trans->ops->ref) + trans->ops->ref(trans); +} + +static inline void iwl_trans_unref(struct iwl_trans *trans) +{ + if (trans->ops->unref) + trans->ops->unref(trans); +} + static inline int iwl_trans_send_cmd(struct iwl_trans *trans, struct iwl_host_cmd *cmd) { |