diff options
Diffstat (limited to 'drivers/net/wireless/libertas/if_spi.c')
| -rw-r--r-- | drivers/net/wireless/libertas/if_spi.c | 134 |
1 files changed, 87 insertions, 47 deletions
diff --git a/drivers/net/wireless/libertas/if_spi.c b/drivers/net/wireless/libertas/if_spi.c index 078ef43d957..67de5b3c68b 100644 --- a/drivers/net/wireless/libertas/if_spi.c +++ b/drivers/net/wireless/libertas/if_spi.c @@ -143,8 +143,10 @@ static void spu_transaction_finish(struct if_spi_card *card) card->prev_xfer_time = jiffies; } -/* Write out a byte buffer to an SPI register, - * using a series of 16-bit transfers. */ +/* + * Write out a byte buffer to an SPI register, + * using a series of 16-bit transfers. + */ static int spu_write(struct if_spi_card *card, u16 reg, const u8 *buf, int len) { int err = 0; @@ -208,8 +210,10 @@ static int spu_read(struct if_spi_card *card, u16 reg, u8 *buf, int len) struct spi_transfer dummy_trans; struct spi_transfer data_trans; - /* You must take an even number of bytes from the SPU, even if you - * don't care about the last one. */ + /* + * You must take an even number of bytes from the SPU, even if you + * don't care about the last one. + */ BUG_ON(len & 0x1); spu_transaction_init(card); @@ -258,8 +262,10 @@ static inline int spu_read_u16(struct if_spi_card *card, u16 reg, u16 *val) return ret; } -/* Read 32 bits from an SPI register. - * The low 16 bits are read first. */ +/* + * Read 32 bits from an SPI register. + * The low 16 bits are read first. + */ static int spu_read_u32(struct if_spi_card *card, u16 reg, u32 *val) { __le32 buf; @@ -271,13 +277,15 @@ static int spu_read_u32(struct if_spi_card *card, u16 reg, u32 *val) return err; } -/* Keep reading 16 bits from an SPI register until you get the correct result. +/* + * Keep reading 16 bits from an SPI register until you get the correct result. * * If mask = 0, the correct result is any non-zero number. * If mask != 0, the correct result is any number where * number & target_mask == target * - * Returns -ETIMEDOUT if a second passes without the correct result. */ + * Returns -ETIMEDOUT if a second passes without the correct result. + */ static int spu_wait_for_u16(struct if_spi_card *card, u16 reg, u16 target_mask, u16 target) { @@ -305,8 +313,10 @@ static int spu_wait_for_u16(struct if_spi_card *card, u16 reg, } } -/* Read 16 bits from an SPI register until you receive a specific value. - * Returns -ETIMEDOUT if a 4 tries pass without success. */ +/* + * Read 16 bits from an SPI register until you receive a specific value. + * Returns -ETIMEDOUT if a 4 tries pass without success. + */ static int spu_wait_for_u32(struct if_spi_card *card, u32 reg, u32 target) { int err, try; @@ -328,8 +338,10 @@ static int spu_set_interrupt_mode(struct if_spi_card *card, { int err = 0; - /* We can suppress a host interrupt by clearing the appropriate - * bit in the "host interrupt status mask" register */ + /* + * We can suppress a host interrupt by clearing the appropriate + * bit in the "host interrupt status mask" register + */ if (suppress_host_int) { err = spu_write_u16(card, IF_SPI_HOST_INT_STATUS_MASK_REG, 0); if (err) @@ -345,10 +357,12 @@ static int spu_set_interrupt_mode(struct if_spi_card *card, return err; } - /* If auto-interrupts are on, the completion of certain transactions + /* + * If auto-interrupts are on, the completion of certain transactions * will trigger an interrupt automatically. If auto-interrupts * are off, we need to set the "Card Interrupt Cause" register to - * trigger a card interrupt. */ + * trigger a card interrupt. + */ if (auto_int) { err = spu_write_u16(card, IF_SPI_HOST_INT_CTRL_REG, IF_SPI_HICT_TX_DOWNLOAD_OVER_AUTO | @@ -402,8 +416,10 @@ static int spu_init(struct if_spi_card *card, int use_dummy_writes) int err = 0; u32 delay; - /* We have to start up in timed delay mode so that we can safely - * read the Delay Read Register. */ + /* + * We have to start up in timed delay mode so that we can safely + * read the Delay Read Register. + */ card->use_dummy_writes = 0; err = spu_set_bus_mode(card, IF_SPI_BUS_MODE_SPI_CLOCK_PHASE_RISING | @@ -459,8 +475,10 @@ static int if_spi_prog_helper_firmware(struct if_spi_card *card, /* Load helper firmware image */ while (bytes_remaining > 0) { - /* Scratch pad 1 should contain the number of bytes we - * want to download to the firmware */ + /* + * Scratch pad 1 should contain the number of bytes we + * want to download to the firmware + */ err = spu_write_u16(card, IF_SPI_SCRATCH_1_REG, HELPER_FW_LOAD_CHUNK_SZ); if (err) @@ -472,8 +490,10 @@ static int if_spi_prog_helper_firmware(struct if_spi_card *card, if (err) goto out; - /* Feed the data into the command read/write port reg - * in chunks of 64 bytes */ + /* + * Feed the data into the command read/write port reg + * in chunks of 64 bytes + */ memset(temp, 0, sizeof(temp)); memcpy(temp, fw, min(bytes_remaining, HELPER_FW_LOAD_CHUNK_SZ)); @@ -495,9 +515,11 @@ static int if_spi_prog_helper_firmware(struct if_spi_card *card, fw += HELPER_FW_LOAD_CHUNK_SZ; } - /* Once the helper / single stage firmware download is complete, + /* + * Once the helper / single stage firmware download is complete, * write 0 to scratch pad 1 and interrupt the - * bootloader. This completes the helper download. */ + * bootloader. This completes the helper download. + */ err = spu_write_u16(card, IF_SPI_SCRATCH_1_REG, FIRMWARE_DNLD_OK); if (err) goto out; @@ -517,16 +539,20 @@ out: return err; } -/* Returns the length of the next packet the firmware expects us to send - * Sets crc_err if the previous transfer had a CRC error. */ +/* + * Returns the length of the next packet the firmware expects us to send. + * Sets crc_err if the previous transfer had a CRC error. + */ static int if_spi_prog_main_firmware_check_len(struct if_spi_card *card, int *crc_err) { u16 len; int err = 0; - /* wait until the host interrupt status register indicates - * that we are ready to download */ + /* + * wait until the host interrupt status register indicates + * that we are ready to download + */ err = spu_wait_for_u16(card, IF_SPI_HOST_INT_STATUS_REG, IF_SPI_HIST_CMD_DOWNLOAD_RDY, IF_SPI_HIST_CMD_DOWNLOAD_RDY); @@ -587,8 +613,10 @@ static int if_spi_prog_main_firmware(struct if_spi_card *card, goto out; } if (bytes < 0) { - /* If there are no more bytes left, we would normally - * expect to have terminated with len = 0 */ + /* + * If there are no more bytes left, we would normally + * expect to have terminated with len = 0 + */ lbs_pr_err("Firmware load wants more bytes " "than we have to offer.\n"); break; @@ -660,14 +688,18 @@ static int if_spi_c2h_cmd(struct if_spi_card *card) u16 len; u8 i; - /* We need a buffer big enough to handle whatever people send to - * hw_host_to_card */ + /* + * We need a buffer big enough to handle whatever people send to + * hw_host_to_card + */ BUILD_BUG_ON(IF_SPI_CMD_BUF_SIZE < LBS_CMD_BUFFER_SIZE); BUILD_BUG_ON(IF_SPI_CMD_BUF_SIZE < LBS_UPLD_SIZE); - /* It's just annoying if the buffer size isn't a multiple of 4, because - * then we might have len < IF_SPI_CMD_BUF_SIZE but - * ALIGN(len, 4) > IF_SPI_CMD_BUF_SIZE */ + /* + * It's just annoying if the buffer size isn't a multiple of 4, because + * then we might have len < IF_SPI_CMD_BUF_SIZE but + * ALIGN(len, 4) > IF_SPI_CMD_BUF_SIZE + */ BUILD_BUG_ON(IF_SPI_CMD_BUF_SIZE % 4 != 0); lbs_deb_enter(LBS_DEB_SPI); @@ -838,8 +870,10 @@ static void if_spi_host_to_card_worker(struct work_struct *work) lbs_deb_enter(LBS_DEB_SPI); - /* Read the host interrupt status register to see what we - * can do. */ + /* + * Read the host interrupt status register to see what we + * can do. + */ err = spu_read_u16(card, IF_SPI_HOST_INT_STATUS_REG, &hiStatus); if (err) { @@ -858,12 +892,15 @@ static void if_spi_host_to_card_worker(struct work_struct *work) goto err; } - /* workaround: in PS mode, the card does not set the Command - * Download Ready bit, but it sets TX Download Ready. */ + /* + * workaround: in PS mode, the card does not set the Command + * Download Ready bit, but it sets TX Download Ready. + */ if (hiStatus & IF_SPI_HIST_CMD_DOWNLOAD_RDY || (card->priv->psstate != PS_STATE_FULL_POWER && (hiStatus & IF_SPI_HIST_TX_DOWNLOAD_RDY))) { - /* This means two things. First of all, + /* + * This means two things. First of all, * if there was a previous command sent, the card has * successfully received it. * Secondly, it is now ready to download another @@ -871,8 +908,7 @@ static void if_spi_host_to_card_worker(struct work_struct *work) */ lbs_host_to_card_done(card->priv); - /* Do we have any command packets from the host to - * send? */ + /* Do we have any command packets from the host to send? */ packet = NULL; spin_lock_irqsave(&card->buffer_lock, flags); if (!list_empty(&card->cmd_packet_list)) { @@ -886,8 +922,7 @@ static void if_spi_host_to_card_worker(struct work_struct *work) if_spi_h2c(card, packet, MVMS_CMD); } if (hiStatus & IF_SPI_HIST_TX_DOWNLOAD_RDY) { - /* Do we have any data packets from the host to - * send? */ + /* Do we have any data packets from the host to send? */ packet = NULL; spin_lock_irqsave(&card->buffer_lock, flags); if (!list_empty(&card->data_packet_list)) { @@ -914,7 +949,8 @@ err: * Host to Card * * Called from Libertas to transfer some data to the WLAN device - * We can't sleep here. */ + * We can't sleep here. + */ static int if_spi_host_to_card(struct lbs_private *priv, u8 type, u8 *buf, u16 nb) { @@ -1125,8 +1161,10 @@ static int __devinit if_spi_probe(struct spi_device *spi) if (err) goto free_card; - /* Register our card with libertas. - * This will call alloc_etherdev */ + /* + * Register our card with libertas. + * This will call alloc_etherdev. + */ priv = lbs_add_card(card, &spi->dev); if (!priv) { err = -ENOMEM; @@ -1153,9 +1191,11 @@ static int __devinit if_spi_probe(struct spi_device *spi) goto terminate_workqueue; } - /* Start the card. + /* + * Start the card. * This will call register_netdev, and we'll start - * getting interrupts... */ + * getting interrupts... + */ err = lbs_start_card(priv); if (err) goto release_irq; |