diff options
Diffstat (limited to 'drivers/net')
| -rw-r--r-- | drivers/net/Kconfig | 4 | ||||
| -rw-r--r-- | drivers/net/au1000_eth.c | 31 | ||||
| -rw-r--r-- | drivers/net/smc91x.h | 37 |
3 files changed, 9 insertions, 63 deletions
diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig index ebe68395ecf..5a6895320b4 100644 --- a/drivers/net/Kconfig +++ b/drivers/net/Kconfig @@ -484,7 +484,7 @@ config XTENSA_XT2000_SONIC config MIPS_AU1X00_ENET tristate "MIPS AU1000 Ethernet support" - depends on SOC_AU1X00 + depends on MIPS_ALCHEMY select PHYLIB select CRC32 help @@ -914,7 +914,7 @@ config SMC91X tristate "SMC 91C9x/91C1xxx support" select CRC32 select MII - depends on ARM || REDWOOD_5 || REDWOOD_6 || M32R || SUPERH || \ + depends on ARM || M32R || SUPERH || \ MIPS || BLACKFIN || MN10300 || COLDFIRE help This is a driver for SMC's 91x series of Ethernet chipsets, diff --git a/drivers/net/au1000_eth.c b/drivers/net/au1000_eth.c index 386d4feec65..15ae6df2ff0 100644 --- a/drivers/net/au1000_eth.c +++ b/drivers/net/au1000_eth.c @@ -104,14 +104,6 @@ MODULE_VERSION(DRV_VERSION); * complete immediately. */ -/* These addresses are only used if yamon doesn't tell us what - * the mac address is, and the mac address is not passed on the - * command line. - */ -static unsigned char au1000_mac_addr[6] __devinitdata = { - 0x00, 0x50, 0xc2, 0x0c, 0x30, 0x00 -}; - struct au1000_private *au_macs[NUM_ETH_INTERFACES]; /* @@ -1002,7 +994,6 @@ static int __devinit au1000_probe(struct platform_device *pdev) db_dest_t *pDB, *pDBfree; int irq, i, err = 0; struct resource *base, *macen; - char ethaddr[6]; base = platform_get_resource(pdev, IORESOURCE_MEM, 0); if (!base) { @@ -1079,24 +1070,13 @@ static int __devinit au1000_probe(struct platform_device *pdev) } aup->mac_id = pdev->id; - if (pdev->id == 0) { - if (prom_get_ethernet_addr(ethaddr) == 0) - memcpy(au1000_mac_addr, ethaddr, sizeof(au1000_mac_addr)); - else { - netdev_info(dev, "No MAC address found\n"); - /* Use the hard coded MAC addresses */ - } - + if (pdev->id == 0) au1000_setup_hw_rings(aup, MAC0_RX_DMA_ADDR, MAC0_TX_DMA_ADDR); - } else if (pdev->id == 1) + else if (pdev->id == 1) au1000_setup_hw_rings(aup, MAC1_RX_DMA_ADDR, MAC1_TX_DMA_ADDR); - /* - * Assign to the Ethernet ports two consecutive MAC addresses - * to match those that are printed on their stickers - */ - memcpy(dev->dev_addr, au1000_mac_addr, sizeof(au1000_mac_addr)); - dev->dev_addr[5] += pdev->id; + /* set a random MAC now in case platform_data doesn't provide one */ + random_ether_addr(dev->dev_addr); *aup->enable = 0; aup->mac_enabled = 0; @@ -1106,6 +1086,9 @@ static int __devinit au1000_probe(struct platform_device *pdev) dev_info(&pdev->dev, "no platform_data passed, PHY search on MAC0\n"); aup->phy1_search_mac0 = 1; } else { + if (is_valid_ether_addr(pd->mac)) + memcpy(dev->dev_addr, pd->mac, 6); + aup->phy_static_config = pd->phy_static_config; aup->phy_search_highest_addr = pd->phy_search_highest_addr; aup->phy1_search_mac0 = pd->phy1_search_mac0; diff --git a/drivers/net/smc91x.h b/drivers/net/smc91x.h index 8d2772cc42f..ee747919a76 100644 --- a/drivers/net/smc91x.h +++ b/drivers/net/smc91x.h @@ -83,43 +83,6 @@ static inline void SMC_outw(u16 val, void __iomem *ioaddr, int reg) } } -#elif defined(CONFIG_REDWOOD_5) || defined(CONFIG_REDWOOD_6) - -/* We can only do 16-bit reads and writes in the static memory space. */ -#define SMC_CAN_USE_8BIT 0 -#define SMC_CAN_USE_16BIT 1 -#define SMC_CAN_USE_32BIT 0 -#define SMC_NOWAIT 1 - -#define SMC_IO_SHIFT 0 - -#define SMC_inw(a, r) in_be16((volatile u16 *)((a) + (r))) -#define SMC_outw(v, a, r) out_be16((volatile u16 *)((a) + (r)), v) -#define SMC_insw(a, r, p, l) \ - do { \ - unsigned long __port = (a) + (r); \ - u16 *__p = (u16 *)(p); \ - int __l = (l); \ - insw(__port, __p, __l); \ - while (__l > 0) { \ - *__p = swab16(*__p); \ - __p++; \ - __l--; \ - } \ - } while (0) -#define SMC_outsw(a, r, p, l) \ - do { \ - unsigned long __port = (a) + (r); \ - u16 *__p = (u16 *)(p); \ - int __l = (l); \ - while (__l > 0) { \ - /* Believe it or not, the swab isn't needed. */ \ - outw( /* swab16 */ (*__p++), __port); \ - __l--; \ - } \ - } while (0) -#define SMC_IRQ_FLAGS (0) - #elif defined(CONFIG_SA1100_PLEB) /* We can only do 16-bit reads and writes in the static memory space. */ #define SMC_CAN_USE_8BIT 1 |