diff options
Diffstat (limited to 'drivers/pinctrl/pinctrl-coh901.c')
| -rw-r--r-- | drivers/pinctrl/pinctrl-coh901.c | 77 |
1 files changed, 69 insertions, 8 deletions
diff --git a/drivers/pinctrl/pinctrl-coh901.c b/drivers/pinctrl/pinctrl-coh901.c index 724234c9b01..0797eba3e33 100644 --- a/drivers/pinctrl/pinctrl-coh901.c +++ b/drivers/pinctrl/pinctrl-coh901.c @@ -23,7 +23,9 @@ #include <linux/list.h> #include <linux/slab.h> #include <linux/pinctrl/consumer.h> +#include <linux/pinctrl/pinconf-generic.h> #include <mach/gpio-u300.h> +#include "pinctrl-coh901.h" /* * Register definitions for COH 901 335 variant @@ -418,8 +420,68 @@ static int u300_gpio_to_irq(struct gpio_chip *chip, unsigned offset) return retirq; } -static int u300_gpio_config(struct gpio_chip *chip, unsigned offset, - enum pin_config_param param, unsigned long data) +/* Returning -EINVAL means "supported but not available" */ +int u300_gpio_config_get(struct gpio_chip *chip, + unsigned offset, + unsigned long *config) +{ + struct u300_gpio *gpio = to_u300_gpio(chip); + enum pin_config_param param = (enum pin_config_param) *config; + bool biasmode; + u32 drmode; + + /* One bit per pin, clamp to bool range */ + biasmode = !!(readl(U300_PIN_REG(offset, per)) & U300_PIN_BIT(offset)); + + /* Mask out the two bits for this pin and shift to bits 0,1 */ + drmode = readl(U300_PIN_REG(offset, pcr)); + drmode &= (U300_GPIO_PXPCR_PIN_MODE_MASK << ((offset & 0x07) << 1)); + drmode >>= ((offset & 0x07) << 1); + + switch(param) { + case PIN_CONFIG_BIAS_HIGH_IMPEDANCE: + *config = 0; + if (biasmode) + return 0; + else + return -EINVAL; + break; + case PIN_CONFIG_BIAS_PULL_UP: + *config = 0; + if (!biasmode) + return 0; + else + return -EINVAL; + break; + case PIN_CONFIG_DRIVE_PUSH_PULL: + *config = 0; + if (drmode == U300_GPIO_PXPCR_PIN_MODE_OUTPUT_PUSH_PULL) + return 0; + else + return -EINVAL; + break; + case PIN_CONFIG_DRIVE_OPEN_DRAIN: + *config = 0; + if (drmode == U300_GPIO_PXPCR_PIN_MODE_OUTPUT_OPEN_DRAIN) + return 0; + else + return -EINVAL; + break; + case PIN_CONFIG_DRIVE_OPEN_SOURCE: + *config = 0; + if (drmode == U300_GPIO_PXPCR_PIN_MODE_OUTPUT_OPEN_SOURCE) + return 0; + else + return -EINVAL; + break; + default: + break; + } + return -ENOTSUPP; +} + +int u300_gpio_config_set(struct gpio_chip *chip, unsigned offset, + enum pin_config_param param) { struct u300_gpio *gpio = to_u300_gpio(chip); unsigned long flags; @@ -620,13 +682,12 @@ static void __init u300_gpio_init_pin(struct u300_gpio *gpio, u300_gpio_direction_output(&gpio->chip, offset, conf->outval); /* Deactivate bias mode for output */ - u300_gpio_config(&gpio->chip, offset, - PIN_CONFIG_BIAS_HIGH_IMPEDANCE, - 0); + u300_gpio_config_set(&gpio->chip, offset, + PIN_CONFIG_BIAS_HIGH_IMPEDANCE); /* Set drive mode for output */ - u300_gpio_config(&gpio->chip, offset, - PIN_CONFIG_DRIVE_PUSH_PULL, 0); + u300_gpio_config_set(&gpio->chip, offset, + PIN_CONFIG_DRIVE_PUSH_PULL); dev_dbg(gpio->dev, "set up pin %d as output, value: %d\n", offset, conf->outval); @@ -637,7 +698,7 @@ static void __init u300_gpio_init_pin(struct u300_gpio *gpio, u300_gpio_set(&gpio->chip, offset, 0); /* Set bias mode for input */ - u300_gpio_config(&gpio->chip, offset, conf->bias_mode, 0); + u300_gpio_config_set(&gpio->chip, offset, conf->bias_mode); dev_dbg(gpio->dev, "set up pin %d as input, bias: %04x\n", offset, conf->bias_mode); |